Do I have to remove a piece of plywood before applying thinset?
You don't have to remove it. If it is in good condition and not fragmenting and adhering well, you can apply a layer of fresh thinset over it. However, this will increase the height of the finished floor an extra 1/8 or 1/4 inch (depending on whether you use a 1/4 inch or 1/2 inch, respectively, notched trowel).
Can you put thinset over wood flooring?
If it is in good condition and not fragmenting and adhering well, you can apply a layer of fresh thinset over it. However, this will increase the height of the finished floor an extra 1/8 or 1/4 inch (depending on whether you use a 1/4 inch or 1/2 inch, respectively, notched trowel).
Do I have to remove the thinset?
Yes, you should remove the thinset. You can usually chisel it up with a hammer and cold chisel. Show activity on this post. You don't have to remove it. If it is in good condition and not fragmenting and adhering well, you can apply a layer of fresh thinset over it.
Should I remove the thinset from my ceramic tiles?
Bookmark this question. Show activity on this post. Closed 5 years ago. I have just pulled up my old ceramic tiles from my bathroom an there is the thinset on the subfloor an some grout left on it. Do I need to clean that before putting new thinset on it? Show activity on this post. Yes, you should remove the thinset.
Can you install vinyl plank flooring over thinset?
While thinset mortar could hold vinyl tile in place, it is not necessary. The cementlike consistency of thinset is important with heavy tiles such as ceramic and stone, but with vinyl, which is light and resilient, you can use different adhesives.
Does all thinset need to be removed?
Yes, you should remove the thinset. You can usually chisel it up with a hammer and cold chisel.
Do you have to remove tile to install laminate?
Yes, you can lay engineered-wood or laminate flooring over tile if the tile is in decent shape. Loose, cracked tiles will cause your install to fail.
What should you not do when installing laminate flooring?
Laminate Flooring Installation Don'tsDon't install your laminate on any floor with a drain.Don't install laminate on any uneven subfloor or outdoors.Don't install your laminate over residential carpet.Don't install a second layer of laminate underlayment.More items...
Does vinegar remove thinset?
Vinegar acts as a simple acid solution when it comes in contact with certain elements, such as cement. While vinegar is a weak acid solvent and won't damage dried concrete, it wukk help to loosen up the bonding elements of thinset cement, allowing you to wipe up limited dried residue with your sponge.
What is the best way to remove thinset from concrete?
1:139:54How to Remove Thinset from Concrete - YouTubeYouTubeStart of suggested clipEnd of suggested clipOf is the amount of dust that is created when you are running these demolition hammers the scraperMoreOf is the amount of dust that is created when you are running these demolition hammers the scraper tool is doing exactly what it says it does it is scraping across the surface of the concrete.
How do you install laminate flooring over existing tile?
3:3522:43How to Install Vinyl Flooring Over Tiles (Over Linoleum Tiles) - Thrift DivingYouTubeStart of suggested clipEnd of suggested clipThe molding. Around your door so line a piece of the molding up to the door trim. And you want toMoreThe molding. Around your door so line a piece of the molding up to the door trim. And you want to trim it flush do a nice little flush cut or you can use a rotary tool I'm using a little handsaw.
Can you lay laminate on top of tiles?
But can you put laminate flooring over tile? The short answer is yes, you can put laminate flooring over tile.
Should I remove tile before installing vinyl plank flooring?
Any cracks or chips in your ceramic tile can also create problems with laying the new flooring on top. We recommend repairing any of these issues before installation. If your existing floor has any of these issues that cannot easily be fixed, removing the tile before installing the new vinyl plank is best.
Do you cut the tongue off the first row of laminate?
Place the first plank with the tongue side towards the wall, being sure to allow 1/8" for expansion. We recommend cutting off the tongue on this first row to avoid any problem with the expansion gap.
How long after laying laminate can you put furniture on it?
Any new laminate floor product, including Swiss Krono, needs to sit in your house for at least 48 hours in the room it will be installed in order to acclimate or to become accustomed to a new climate or conditions.
Why am I getting gaps in my laminate flooring?
What caused wood laminate flooring to develope space between boards that was glued down? One usual cause of gaping in laminate flooring is high moisture levels. As the weather becomes hot and humid, the laminate planks expand and contract, resulting in gaps.
Can you pour self leveling concrete over old thinset?
Yes you must remove all of the thinset - FOR SURE. Thinset is not meant to be exposed and a leveler on top of it will not protect it enough.
How do you remove old thinset?
Hammer your 1 in (2.5 cm) putty knife at a 45-degree angle to the thinset.You can also use a masonry chisel that is the same width.Continue removing the thinset in small chunks until you've removed enough to accommodate your new tiles.Always use a putty knife with a hammer-end handle and sharp blade.
What will dissolve thinset?
Pour hot water on the tiles. Start by mixing 1/2 of a cup of a citrus-based degreaser with a gallon of hot water. The hot water will help to soften the thinset just a bit, making it easier to remove. Pour the hot water on the thinset on the tiles, and be sure to use rubber gloves when doing so.
How do you remove thinset after removing tile?
0:055:053 easy ways to remove tile mortar thinset from cement floor ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipEnd use it as a ramming bar. And then you also have this scraper. That works really well you canMoreEnd use it as a ramming bar. And then you also have this scraper. That works really well you can change the blades to make it sharper.
How much is a thinset removal bit?
thinset removal bit $25 on amazon hooks up to an air compressor. .. gives you more control than a roto hammer. Been doing tile for 10 years and so far best bang for your buck
Can you go over old thin set?
You easily can go over old thin set with no problem,as long as it is down good....I have done whole house on top of strong bonded oldthinset....it is actually a benefit to the instsllation of the new tile....only a pro can understand what I mean....but trust me ,it is okay
Can angle grinders remove thinset?
Having done this exact thing recently, I found that using the hard metal brush attachment for the angle grinder worked very well to remove thinset without affecting the concrete beneath it. I'd lean towards the stiffer bristles.
Can you put tile over thinset?
You can put tile over old thinset. Make sure it not loose, vacuum to remove any debris, check for cracks, apply membrane if needed. I've done it hundreds of times for fifteen years including my own five houses. Remove the old thinset to get a flat surface for wood or laminate installation.
Can you wet thinset before starting?
Be sure to wet the thinset before starting, and as needed. The thinset comes off like mud, leaving clean concrete. Once finished, scoop up the mud and sweep.
Can you use thinset over old thinset?
The answer is, "if you want to do it properly, yes". You're going to find it near impossible to get a good base to lay tile on if you try to apply thinset overtop of old thinset.
How do you remove dried thinset?
Scrape away any dried thinset by using a chisel, chipping each mark from the tile without scratching the tile itself. Use a grout scraper to remove any remaining thinset from the grout lines. Get a 50-grit sanding disc and place it on a rotary sander at its lowest setting.
What is the best way to remove Thinset from concrete?
For tough jobs, a grinder is usually the way to go. Any size grinder will do, though larger ones will get the job done faster. A strong grinding surface, such as diamond, is necessary to break down the thinset mortar. With the right grinding surface material, the thinset can be ground away in no time.
How do you remove mortar from a slab?
Some Thinset mortar can be removed by using a chipping hammer with a scraper attachment. Use short jabbing motions to get under the mortar and pop it from the floor. But, if the mortar is stubborn, you may have to go directly to the big tools.
Do you have to remove old mortar before laying tile?
You can put new thinset on top of old, but only if the old thinset is perfectly smooth and level. This is rarely the case once the old tiles have been removed. The best option to smooth out the old thinset and prepare it for new tiles is to grind it down.
Does Thinset need to be removed?
The answer is, “if you want to do it properly, yes”. You’re going to find it near impossible to get a good base to lay tile on if you try to apply thinset overtop of old thinset.
How do you store Thinset overnight?
It does not dry by evaporation, so if you mix up a batch of thinset and pack it in an air-tight container , it will still harden in a few hours.
How do you remove dried Thinset from porcelain tile?
Wash Tiles Thoroughly Add a squirt of dish soap or a cup of granulated sugar to a bucket of warm water and then apply it to the areas where thinset is present. Use a sponge to gently scrub the thinset. You may start to notice the marks fading and the thinset coming away from the tiles already.
How to avoid making mistakes?
How to avoid making this mistake and other mistakes 1 It can be a long process to find the right answers 2 There is a lot out there to sift through 3 A lot of it is just plain junk 4 It can be hard to understand
Is it easy to install laminate flooring?
Installing Laminate Flooring can be easy if you have the resources to learn from. It still can be difficult, it really depends on how the layout of the room is. Sure a square room can be easy, but when a hallway gets added on to that it can be a lot more difficult unless you have the resources that can guide you through.
