How to Connect the Whirlpool Stackable Duet Washer and Dryer
- Level your front-load Duet washer by rotating the front washer feet clockwise or counterclockwise with an adjustable wrench to raise or lower the feet.
- Spray the top of the Duet washer with an all-surface cleaner. Wipe the washer dry with paper towels.
- Ask an assistant to help lower the back of the Duet dryer onto the floor to expose the feet. ...
Full Answer
Do you need plumbing for a steam dryer?
You shouldn’t need additional plumbing for a steam dryer. You can connect your steam dryer to a water source by using a “Y” hose connector. The “Y” connector lets both your washer and dryer connect to the same water source – no extra pipes are needed. Learn more by watching this video on how to install a Whirlpool ® Steam Dryer.
How to install the dryer on the wall?
Slide the dryer on the corner posts until it is close to its final location. Leave enough room to connect the exhaust vent. 1. Prepare dryer for leveling legs 2. Screw in leveling legs diamond marking ELECTRICAL INSTALLATION For power supply cord installations: 1. Choose electrical connection type
What is a whirlpool® steam dryer?
Like regular dryers, steam dryers use hot air to dry clothes. However, they also feature cycles and options that use steam for added benefits. Some inject steam directly into the dryer while others spray a fine mist of cold water that mixes with the heat in the dryer to create steam. What are the Benefits of a Whirlpool® Steam Dryer?
How do you ground a whirlpool dryer terminal?
Connect a separate copper ground wire (G) under the green external ground conductor screw (A) to an adequate ground. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw.
How long should a 3 wire cable be for a dryer?
Prepare your 3-wire cable for direct connection. It should be at least five feet in length so you can move your dryer with relative ease. Strip 3½" of outer covering from the end of the cable, leaving bare ground wire in its place. Cut 1" each from the remaining three wires.
How many times has wikihow been viewed?
To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 64,945 times.
What is wikihow wiki?
X. wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 63,696 times.
What is a dryer?
A dryer is a device that will add an enormous amount of convenience to your laundry day. This Whirlpool dryer might seem complicated to install, but follow the tutorial below and you'll be done in no time!
How to install a strain relief on a power cord?
1. Locate the terminal block (shown here ). Remove the hold-down screw and the terminal block cover. Now if you are installing the power supply cord strain relief, go on to steps 2 and 3. If you are installing the direct wire strain relief, go on to steps 4 and 5. ...
Where should the exhaust vent be located in a mobile home?
Exhaust vents in mobile homes must be securely fastened to a flame resistant portion of the home and the vent's ending should be outside the structure itself.
Can you change the location of a dryer?
Do not attempt to change the location of your dryer without at least one other person helping you, since its weight makes it an inherently dangerous object.
How long to dry wool sweaters?
Wool sweaters, along with stuffed toys and pillows that are filled with cotton or polyester, can be placed in a time dry cycle. Dry these items for 60 minutes at a low temperature. If not fully dried after one hour, add more time until your items are dry. For sweaters, lay your the garment flat on the rack and then shape, but do not overcrowd the rack. Before you place a stuffed toy in the dryer, squeeze out the excess water. With pillows, fluffing every 20 minutes during drying will increase fluffiness.
How to dry clothes in a dryer?
To dry your items, place them on the dryer rack and close the door. Select an air cycle or a time d drying cycle and temperature depending on what needs to be dried. When choosing the proper time, press either "More Time" or "Less Time," and reset the time as needed.
Why use a dryer rack?
Dryer racks can also speed up the drying process for items that you would normally dry on a clothesline. The rack keeps your items still, preventing damage that may occur during a regular tumble dry. Take care to follow installation and drying instructions so as not to warp or ruin your delicate items. Advertisement.
How long does it take for sneakers to dry?
Place them back inside your shoes once dry. If any items are not completely dry after an hour and 30 minutes, add additional time until they are dry fully. Advertisement. references.
Can you dry stuffed toys with heat?
Advertisement. For stuffed toys or pillows that are foam rubber-filled and sneakers or canvas shoes, these should not be dried with heat. Using heat to dry shoes can warp the soles, so take care when placing your shoes in the dryer. When drying these items, select air only and dry for 90 minutes.
Where did Gia Miller get her journalism degree?
Gia Miller received her journalism degree from The University of Georgia and began her career as an intern at O, The Oprah Magazine. She then spent several years at Elle DECOR magazine where she immersed herself in the world of interior design. Several apartments and homes later, she’s now mastered the art of DIY.
How to secure vent to exhaust hood?
Vent must fit over the exhaust hood. Secure vent to exhaust hood with 4" (102 mm) clamp. Run vent to dryer location using straightest path possible. Avoid 90° turns. Use clamps to seal all joints. Do not use duct tape, screws, or other fastening devices that extend into interior of vent to secure vent, because they can catch lint.
How to keep dryer from damaging floor?
To avoid damaging floor, place a large flat piece of cardboard from dryer carton under entire back edge of dryer. Firmly grasp dryer body (not console panel) and gently lay dryer down on cardboard.
What is vent chart?
The “Vent System Charts” provide venting requirements that will help achieve best drying performance.
How to reduce noise transfer in dryer?
Space must be large enough to allow door to fully open. Add spacing on all sides of dryer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
What vents must be securely fastened to a noncombustible portion of mobile home?
Exhaust vent must be securely fastened to a noncombustible portion of mobile home and must not terminate beneath the mobile home. Terminate exhaust vent outside.
When did the 4 wire power supply come out?
The National Electrical Code requires a 4-wire power supply connection for homes built after 1996, dryer circuits involved in remodeling after 1996, and all mobile home installations.
How to attach a 2 ft hose to a cold water faucet?
Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on coupling by hand until it is seated on faucet. Then attach “Y” connector to male end of the 2 ft (0.6 m) inlet hose. Screw on coupling by hand until it is seated on connector.
How does a steam dryer work?
Like regular dryers, steam dryers use hot air to dry clothes. However, they also feature cycles and options that use steam for added benefits. Some inject steam directly into the dryer while others spray a fine mist of cold water that mixes with the heat in the dryer to create steam.
What are some steam dryer benefits?
Look to steam cycles and options for benefits that help improve some well-known laundry problems.
When should you use the steam cycle on your dryer?
Dryers with steam capabilities can offer multiple ways to incorporate steam into your laundry routine:
Does a steam dryer need its own hookup?
You shouldn’t need additional plumbing for a steam dryer. You can connect your steam dryer to a water source by using a “Y” hose connector. The “Y” connector lets both your washer and dryer connect to the same water source – no extra pipes are needed. Learn more by watching this video on how to install a Whirlpool ® Steam Dryer.
How to use a steam dryer?
Dryers with steam capabilities can offer multiple ways to incorporate steam into your laundry routine: 1 When you’re drying wrinkle-prone fabrics: Add the steam option to a variety of cycles for extra wrinkle and static protection. 2 When you can’t unload laundry right away: Select a wrinkle prevention cycle that tumbles clothes with steam for sometimes hours after a cycle ends. 3 Use it to quickly freshen up clothing and help reduce odors and wrinkles without washing.
How to reduce static in dryer?
Reduce static. Steam added at the end of a cycle can help cut down on cling by adding humidity to the dryer. Odor neutralization. Particularly useful when refreshing lightly worn clothes, moisture combined with dryer heat can help absorb odor. Save time, water and energy.
What is the purpose of a sanitizer?
Use it to quickly freshen up clothing and help reduce odors and wrinkles without washing.
