How to Replace the Door Switch of Your Whirlpool Dryer
- 1. Unplug the Dryer Pull Dryer Plug from the Outlet
- 2. Detach the Lint Housing Remove the Lint Trap ...
- 3. Open the Dryer Top Loosen the Dryer Top ...
- 4. Remove the Old Door Switch Disconnect the Electrical Connector ...
- 5. Install the New Door Switch Set the Door Switch Into Place ...
- 6. Close Back Up ...
- 7. Test Your Dryer ...
- 8. Celebrate Your Victory ...
Full Answer
How to reverse the door on a whirlpool dryer?
How do you flip the door on a Whirlpool dryer?
- Remove the four Torx screws holding the door hinge to the dryer.
- Remove the two Trox screws holding the door strikeplate onto the dryer's door jamb.
- Remove the Phillips screws along the inside of the door.
- Rotate the outer window itself 180 degrees to rotate the handle to the other side.
How to reset Whirlpool dryer?
How to reset Whirlpool dryer?
- Turn the power off and wait at least 3 minutes before proceeding. First, turn the power off at the source.
- Remove the power cord from the electrical outlet (If applicable) and unplug the appliance.
- Wait 30 seconds. ...
- Try to start your dryer once again. ...
- Remove the load and unplug the dryer. ...
- Remove the electrical connections and check them for damage. ...
How to troubleshoot Whirlpool dryer problems and repairs?
Whirlpool Duet Dryer troubleshooting
- Dryer still Beep. This is a simple problem and easy to solve within a few minutes. ...
- Auto shut off. It is another troubleshooting problem when you start the dryer it makes a noise in a heavy voice and automatic shutoff after a few minutes.
- Dryer not spin but properly heated. ...
- Overheating Problem. ...
How to repair a whirlpool dryer with a bad timer?
Use the flathead screwdriver to pry open a tab that holds a power source harness to the rear of the timer. Remove the timer knob, the two screws that hold the timer in place, and pull the old timer out. Replace the old timer with the new timer. Replace all other connectors and wire harnesses. After installing the new timer, replace the rear panel.
How to loosen dryer lid?
What does a door switch do on a dryer?
Where is the switch on a door?
Why won't my dryer start?
How do I fix the door on my Whirlpool dryer?
0:000:54Dryer Repair- Replacing the Door Catch (Whirlpool Part # W10111905)YouTubeStart of suggested clipEnd of suggested clipThere is two locking tabs one on each side of that door catch that will engage the edge of the frontMoreThere is two locking tabs one on each side of that door catch that will engage the edge of the front panel to install the new one simply slide it into the hole.
Can you change the door on a front load dryer?
Most dryer doors are reversible, but front-loading washers typically have locking mechanisms with electrical parts that can't be changed to reorient the swing of the door.
How do you replace a dryer door?
0:404:09279570 - Replacing Your Dryer's Door Latch - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe do that by taking a pair of needle nose pliers or regular colors depending on how plain it isMoreWe do that by taking a pair of needle nose pliers or regular colors depending on how plain it is inside of the dryer.
How do you replace a door hinge on a Whirlpool dryer?
1:133:15Whirlpool/Kenmore Electric Dryer Left Door Hinge #8066057 - YouTubeYouTubeStart of suggested clipEnd of suggested clipRemove the hinge mounting screws from the front panel. And pull out the old door hinge install theMoreRemove the hinge mounting screws from the front panel. And pull out the old door hinge install the new door hinge by inserting it into the front panel. And securing it with the screws.
How do you fix a broken door hinge on a dryer?
0:352:30How To: Whirlpool/KitchenAid/Maytag Hinge WPW10362431 - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe're only gonna remove the upper one that's damaged. Tell them by four Phillips screws. So you gotMoreWe're only gonna remove the upper one that's damaged. Tell them by four Phillips screws. So you got to do is remove those. Screws.
Can washer and dryer doors be reversed?
If your washer's and dryer's doors bang into each other, you can just reverse the dryer's door. You can't change the direction of the washing machine door, but your dryer door has this capability.
How do you fix a bent dryer door?
Try loosening or removing the screws that hold the hinges tightly in place and test again. You may be able to repair the hinge by adjusting the screws for an evener balance. Or you may be able to bend the hinge back into place. But in most cases, a damaged hinge will need to be replaced.
Why is my dryer door not closing?
Door hinges that are bent out of shape will also prevent the door from closing securely. Besides that, buildups of lint and dirt at the door strike, catch, or hinge from preventing the dryer door from closing fully, leading to it popping open during the drying cycle.
How do you replace a dryer door seal?
0:060:40Whirlpool/Kenmore Electric Dryer Replace Door Gasket #3390731YouTubeStart of suggested clipEnd of suggested clipIf still intact detach the old gasket. And remove excess residue next apply high-temperatureMoreIf still intact detach the old gasket. And remove excess residue next apply high-temperature adhesive to the gasket slot install the new gasket by inserting it evenly along the slot.
Can you flip a door upside down?
Flip the hinges upside down and drill new holes for them so that the door flips the opposite way. Screw the hinges into their new position. Flip the door upside down to start tackling the hardware. The door handle and deadbolt should be easily removed by unscrewing them.
Can GE dryer doors be reversed?
GE and Hotpoint top load and front load matching dryers have a 180 degree right hand door swing (hinges on the right), though most models have reversible doors.
Can LG dryer door be reversed?
On the right side where your door is connected have someone support the door and remove the 4 screws located on the hinges. You will now be able to remove the door from the cabinet. Move the door to the left side and insert the hinge into the hinge hole.
How do you reverse a Samsung dryer door?
0:181:32How to reverse the door on your Samsung dryer - YouTubeYouTubeStart of suggested clipEnd of suggested clipHolder. Remove the final door hinge screw and place it into the other side screw hole reattach theMoreHolder. Remove the final door hinge screw and place it into the other side screw hole reattach the door on the other.
Reverse the Door Swing on Whirlpool Duet Dryer - YouTube
Model # WED71HEDW1
How to Change a Dryer Door From Left to Right | Hunker
You can change the way a dryer door swings open. Most dryers come pre-assembled so the door may either open and close on either the right or left side. Changing the direction in which it opens and closes is an easy process to complete.
Door Reversal Guide - Whirlpool
Door Reversal Guide - Whirlpool
Door Reversal Guide - Whirlpool
Door Reversal Guide - Whirlpool
VIDEO: How to Reverse the Door Swing (Door Reversal)
- Choose delivery frequency. You'll only be billed when your order ships. - Hassle-free, we'll send you a reminder before each delivery. Skip refills or cancel any time.
How to loosen dryer lid?
Slide a strong putty knife under the lip of the dryer lid. Pry upward to loosen.
What does a door switch do on a dryer?
The door switch provides important information to the dryer control panel, letting it know when it’s OK to tumble. By replacing this part, your dryer can once again accurately tell whether the door is open or closed.
Where is the switch on a door?
Identify the switch is in the upper right corner of the door pocket.
Why won't my dryer start?
When your dryer won’t start, the first place to check is the door. If there’s nothing blocking the latch, the problem might with your door switch. This is the switch that detects whether your dryer door is fully closed and if it doesn’t trigger, your dryer won’t consider it safe to start tumbling. Fortunately, the dryer switch is a very easy part to replace if you have the know-how.
What to do if Whirlpool dryer won't start?
Before you retire your Whirlpool dryer model WED49STBW that isn’t starting, you may want to take a look at the door switch. The door switch sends a signal to the control board that either tells the dryer to start or stop, depending on whether the door is open or closed. If the switch is faulty the dryer won’t work. Fortunately, replacing a malfunctioning door switch is not a complicated or expensive repair. Below we’ve provided you with a step-by-step guide that explains how to remove and replace your Whirlpool dryer’s door switch.
How to remove a door switch from a door?
Disconnect the wire harness from the door switch. Take your slot screwdriver and detach the locking tabs on the wire harness plug and then pull out the switch.
How to rotate a window handle?
Rotate the outer window itself 180 degrees to rotate the handle to the other side. Replace the outer window retainer and rotate it counter-clockwise to lock it into place. Replace the six Phillips screws.
Can you install a duet dryer door on the left side?
You can install the door so it opens to the right or the left.
What happens if your door doesn't latch?
If the door does not latch closed, you won’t be able to start a drying cycle. If this part is malfunctioning, you may not be able to open or close your door. In some instances, it may seem like your door is closing, but if it is not latching properly you won’t be able to start your drying cycle.
What is the strike on a dryer?
The strike is mounted on the body of the dryer, while the catch is mounted on the dryer door. These two parts work together to keep your dryer door closed. The catch holds the door strike to keep the door closed during the drying cycle. If the door does not latch closed, you won’t be able to start a drying cycle.
Can a dryer run if the door latch is malfunctioning?
You should replace this part as soon as it’s malfunctioning. Your dryer may run even though the latch is malfunctioning, but it is unsafe if the dryer continues to run while the door is open. This replacement part features 1 door latch kit which includes 2 strikes, 3 catches, and a set of instructions.
How to loosen dryer lid?
Slide a strong putty knife under the lip of the dryer lid. Pry upward to loosen.
What does a door switch do on a dryer?
The door switch provides important information to the dryer control panel, letting it know when it’s OK to tumble. By replacing this part, your dryer can once again accurately tell whether the door is open or closed.
Where is the switch on a door?
Identify the switch is in the upper right corner of the door pocket.
Why won't my dryer start?
When your dryer won’t start, the first place to check is the door. If there’s nothing blocking the latch, the problem might with your door switch. This is the switch that detects whether your dryer door is fully closed and if it doesn’t trigger, your dryer won’t consider it safe to start tumbling. Fortunately, the dryer switch is a very easy part to replace if you have the know-how.
