How to Shut Off Your Meter
- Locate your natural gas meter.
- Find the natural gas shut off valve.
- Using a 12-inch or larger adjustable wrench, turn the valve 1/4 turn in either direction.
How do you turn off the gas on a gas meter?
Steps for Shutting Off the Gas Meter Know beforehand where your gas meter is located. Have an 8″-12″ or larger adjustable wrench readily available. Find the gas shut-off valve. Turn the shut-off valve 1/4 turn to the left or the right so the valve is parallel with the ground.
Where is the shut off valve on a gas meter?
As you face the meter, you'll see a pipe running from the ground to the meter. There is a shut-off valve running parallel with the pipe, usually located about 6 to 8 inches above the ground. Take a 12-inch or larger adjustable wrench, and turn the valve 1/4 turn in either direction, until the valve is crosswise to the pipe. (See Diagram B)
How do you turn off natural gas in a house?
Natural Gas Shut-off Valves. For safety, a shut-off valve should be installed at every natural gas appliance. If a leak happens at a specific appliance, the valve allows you to turn off the natural gas at the appliance rather than shutting off all of your natural gas service. Some valves require a wrench to turn them.
What does it mean when your gas meter keeps moving?
If the gas meter dial continues to move after that time, it either means you forgot to turn off one of your gas appliances or you may have a natural gas leak.
Can I turn off my own natural gas?
Locate your main gas service shutoff valve. It's usually the first fitting on the natural gas supply pipe coming out of the ground next to the meter. With a wrench, turn the lever in either direction until it is crosswise to the pipe. Once the gas is turned off, leave it off.
How do I turn off natural gas to my house?
There is a shut-off valve running parallel with the pipe, usually located about 6 to 8 inches above the ground. Take a 12-inch or larger adjustable wrench, and turn the valve 1/4 turn in either direction, until the valve is crosswise to the pipe.
How do I turn my meter off?
0:031:08HOW TO TURN OFF THE SHOT METER IN 2K23 - YouTubeYouTubeStart of suggested clipEnd of suggested clipGo down controller. Settings you can see the shop meter is on you just go over to turn it off and i'MoreGo down controller. Settings you can see the shop meter is on you just go over to turn it off and i'll show you guys the different animations free throws only shot button only pro stick only.
How do you know if your gas meter is on or off?
A) located just before the gas meter. This valve, often called the street-side valve, is normally a rectangular nub (Photo 1). When the long side of the nub or handle is parallel to the incoming gas line, it's open and the gas is flowing. When it's turned a quarter turn, perpendicular to the incoming pipe, it's closed.
How do I know if my gas is turned off?
1:243:10How to turn off and on your Gas at the Meter - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's off it's rotated this way and so if you kind of follow your finger it kind of stops. When it'sMoreIt's off it's rotated this way and so if you kind of follow your finger it kind of stops. When it's shut off and. So that's how you know if it's on or off it's parallel.
How do I turn off the power to my house at the meter?
How to Switch Off the Electric MeterPut on rubber boots and gloves.Locate your circuit breaker and shut off the main power breaker.Lift your electric meter's front panel up.Place your gloved hand on the glass part of your meter and twist it counterclockwise to remove it.Flip the main switch to the off position.
How do I turn my gas meter back on?
0:100:48How to: Restore your Supply - YouTubeYouTubeStart of suggested clipEnd of suggested clipThere is a keypad press. The blue a button or the red B button the screen will light up and theMoreThere is a keypad press. The blue a button or the red B button the screen will light up and the meter will display press a to connect press the blue a button the meter will display press B to confirm.
How do I turn on my gas supply meter?
0:110:47How to re-enable supply on an EDMI gas smart Pay As You Go meterYouTubeStart of suggested clipEnd of suggested clipHold the ok button to turn the meter. On press the ok button until you get to a screen that saysMoreHold the ok button to turn the meter. On press the ok button until you get to a screen that says armed enable press and hold the ok button the screen should appear saying enabled.
How do I turn off my smart meter?
Press and hold the power button on the back of your smart meter display to turn it on. To turn it off, press and hold the same button for five seconds.
Where is the gas shut-off valve located?
The location of the valve can vary depending on the type of building and when it was installed: The gas meter and gas service shutoff valve is usually located on the side or in front of the building. If the building has a breezeway, it could be located there.
Should I be able to smell gas from my gas meter?
Answer: No, you should not smell gas at your gas meter. The only reason you are smelling gas by your gas meter is a leak at the regulator or at leak at one of the pipe connections, both of which are bad news. A gas leak smells like rotten eggs.
Should you turn off gas when on vacation?
Yes, turning off your gas will prevent issues if there is a gas leak. I never have but I do turn off my water in case of a leak and oil burner to prevent wasting fuel. Turning off gas will be a personal preference, just as turning off the water is.
Where is the gas valve in my house?
Your main shut off valve is located just before the gas meter. This is called your “street side valve”. On the inside of your house, where the pipe enters your house, you can find your “house side valve.” This ball valve is attached to a black iron pipe.
Can I turn my gas off at the meter?
There's usually one with a handle typically located between the main gas meter and the home (house-side gas valve). This is what you want to operate to shut off your home gas supply. The other valve will be somewhere between the gas meter and the street.
Which way is off for gas valve?
3:155:20How To Shut Off Natural Gas Valves - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut again the principle is the same you once the handle is in line with the pipe or parallel withMoreBut again the principle is the same you once the handle is in line with the pipe or parallel with the pipe. Then the gas is on if you turn it the other way the gas will be off. All right on this
How do you cap a gas line in your house?
How to Cap the Gas Line:Remove fittings and any additional piping. ... Clean the pipes with steel wool. ... Apply Teflon pipe dope or tape to the cap. ... Use the appropriate cap. ... Check for gas leaks. ... Relight pilot lights.
Step 1: Locate Your Natural Gas Meter
It's important to know exactly where your natural gas meter is so you can find it in case of an emergency. The following diagram shows four possibl...
Step 2: Find The Natural Gas Shut-Off Valve
As you face the meter, you'll see a pipe running from the ground to the meter. There is a shut-off valve running parallel with the pipe, usually lo...
Natural Gas Shut-Off Valves
For safety, a shut-off valve should be installed at every natural gas appliance. If a leak happens at a specific appliance, the valve allows you to...
Electric Bonding Or Grounding
Do not use SoCalGas'® natural gas meter, natural gas piping, natural gas risers or related equipment for electrical bonding or grounding because it...
What to do if gas meter is off?
If all your appliances are off and the dial is still moving, rotate the meter valve handle back into the horizontal ‘off’ position, then contact a licensed gas fitter to check for leaks in your gas pipes and appliances. If the dial isn’t moving, you can proceed with turning your gas appliances on. Depending on your appliances, you may also need ...
Why does my gas meter stop working after turning on?
After turning on the gas connection, you should see the gas meter dial move and then stop within fifteen seconds. This indicates gas is flowing from the network through your home’s connection. If the gas meter dial continues to move after that time, it either means you forgot to turn off one of your gas appliances or you may have a natural gas leak.
What to do if the gas dial isn't moving?
If the dial isn’t moving, you can proceed with turning your gas appliances on. Depending on your appliances, you may also need to restart pilot lights for them to work. Be sure to check the manufacturers’ instructions. After following these steps, gas supply should be restored to your house. If it hasn’t, that means the gas supply may have been ...
How often is a gas meter read in WA?
Your meter will be read approximately once every three (3) months by ATCO Gas, who maintains WA’s natural gas network.
Where is the gas meter located in an hour house?
For most properties, your gas meter will be located in a metal box at the front or side of the house. You may have a gas-only meter, or a combination gas and electrical meter box.
Do you need a gas meter box?
You may have a gas-only meter, or a combination gas and electrical meter box. There will be a valve located in the gas meter which controls the flow of gas to your house from the gas network. If you’ve recently moved into a new house connected to the natural gas network, it’s possible you may need to turn your gas connection back on at the meter.
Who maintains WA natural gas?
Once we receive your property’s actual quarterly gas meter readings from ATCO Gas – who maintains WA’s natural gas network – we use this information to balance your account across your next period of instalments, which is then shown on your invoice.
What about the gas pipes that connect to my property?
The Gas Network Operator (GNO) is responsible for the gas pipe that comes from the gas main into the property. Some time after your gas has been disconnected, they’ll likely visit your property to check things out, and might decide to disconnect the gas pipe that runs into the house from the gas main in the street.
What to do if you need an existing gas pipe removed?
If you ever needed an existing gas pipe in your property to be moved or removed (for example if building work is being carried out and the existing pipe is in the way), you need to contact your local GNO to do this work. Find out who your Gas Network Operator is here.
Why do people disconnect from gas?
As people move away from burning gas to heat their homes and their water - ‘electr ifying’ these process es instead - we expect (and encourage) more customers to start disconnecting their gas supplies.
Does your energy supplier have to remove your gas meter?
It’s your energy supplier’s job to remove your gas meter and make sure the incoming gas supply is capped. Right now, because we get so few requests, we offer this service for free.
Is gas capping a cost barrier?
At the same time, we’re working together with MAPs on a long-term solution, so that as gas capping becomes more common, there’s no cost barrier for someone looking to go green and get rid of their gas supply.
Who owns gas meters?
The electricity and gas meters in homes around the country aren’t owned by customers, or us – they’re actually owned by businesses called Meter Asset Providers (or MAPs).
What does it mean when you have to shut off a gas main?
When you have to ask how to shut off a gas main, it means you have no business touching it at all. Go to a trade school or serve an apprenticeship before touching something you have no knowledge of. You are facing danger to yourself and your neighbors by learning how to work with gas plumbing on the wing. R.
Is there a shut off on the main line?
Not in the real world, the only shut off is out on the meter set for the main line into the house and one for each individual appliance branch.
When to shut off gas meter?
Because an ENSTAR technician must turn the gas service back on after it has been turned off, you should only shut off the meter when you detect a gas smell or hear the hissing of a leak. This is especially important in the event of an earthquake as ENSTAR technicians may be busy reconnecting customers and unable to reach you immediately.
Where is the gas shut off valve?
Find the gas shut-off valve. This is the first fitting on the gas pipe coming up out of the ground near your meter. In the “on” position, the shut-off valve is perpendicular to the ground.
