How do I unlock my Kitchenaid gas cooktop? If Control Lock is activated when power to the cooktop is on, all keypads are locked out except for Power and Off. To Unlock Cooktop: Touch and hold LOCK for 3 seconds.
Full Answer
How do I use the cooktop lock on my Kenmore stove?
The indicator light will turn off, and one long tone will sound. To activate the Cooktop Lock: Turn off all burners and touch the lock key for 3 seconds. When the Cooktop Lock activates, the Cooktop Lock indicator light will turn on and one long tone will sound.
How do I Stop my Kenmore gas stove igniter from sparking?
To resolve the issue of the cooktop igniter continuously sparking, either decrease the downdraft vent blower speed or increase the cooktop flame setting for that burner. Refer to the Owner's Manual for specific information on setting the controls.
What do you do when your gas stove burner stops working?
If so, turn on any one of the surface burner knobs to release air from the gas lines. Do all burners fail to light? Check to see if the appliance is connected to the gas supply and the gas shutoff is turned on. If you are not connected to gas, have a qualified gas technician connect the appliance to gas.
How do I fix excessive heat around cookware on the cooktop?
Excessive heat around cookware on cooktop Cookware and flame are not matched -The cookware should be centered above the burner with the bottom sitting level on the grate. Th e flame should be adjusted so that it does not extend up the sides of the pan. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong.
How do I unlock my Kitchenaid stovetop?
To unlock the control panel, press and hold CONTROL LOCK for 3 seconds. The indicator light will turn off, and the appliance is ready for use.
How do you turn off the Control Lock on a Kitchenaid stove?
To turn off Control Lock, press and hold the Options key that says "Control Lock Hold 3 Sec" under it for 3 seconds.
How do you unlock a gas stove top?
Press and hold the Gas/Control Lockout button/pad for 3 seconds to lock or unlock the control. The Clear/Off pad is always active, even when the control is locked.
How do I unlock my Kitchenaid?
Press and hold TO LOCK for 3 seconds to lock the dispenser. Press and hold TO LOCK a second time to unlock the dispenser.
How do I reset my Kitchenaid cooktop?
Reset power to the product:Power unit down by turning off the circuit breaker(s) for one (1) minute.Power unit up by turning on the circuit breaker(s).Start a bake cycle.Monitor the oven for one (1) minute to ensure the error code does not display again.Verify oven operation.
How do I turn off Control Lock?
0:201:33Dishwasher Controls - Lock and Unlock - YouTubeYouTubeStart of suggested clipEnd of suggested clipFor the controls with a separate lock pad if any pad is pressed and the light above the lock padMoreFor the controls with a separate lock pad if any pad is pressed and the light above the lock pad flashes. The control panel is locked to unlock the control panel press the lock pad twice.
How do I unlock my Kitchenaid oven?
Door is locked when starting or using the oven Turn the power off at the circuit breaker or fuse box for one minute, then turn the power back on. Allow the oven to cool, approximately 30-90 minutes, move the latch arm to the left to unlock the door.
What does control lock mean on a stove?
The Control Lock avoids unintended use of the surface cooking areas. If Control Lock is activated when power to the cooktop is off, the cooktop is locked out, and the surface cooking areas cannot be turned on by the cooktop touch controls.
How do I lift the top of my stove?
How to Lift a StovetopGrab the front two corners and tuck your fingertips under the front edge.Lift firmly.Ensure the brackets pop into place to ensure the top stays up.
Why is my Kitchenaid locked?
Kitchenaid ovens have an oven door that locks. The lock on a Kitchenaid oven engages when it is operating in the self-clean cycle. This is a safety feature because of the high heat the oven produces when it is self-cleaning. Sometimes the door lock will not disengage, even when the self-clean cycle is finished.
How do I turn off the Control Lock on my Kitchenaid dishwasher?
To turn off Control Lock, press and hold the Options key that says "Control Lock Hold 3 Sec" under it for 3 seconds. If the dishwasher has a dedicated Control Lock button in the Options selections, press and hold CONTROL LOCK for 3 seconds (press the words "Control Lock).
How do you unlock the controls on a Kitchenaid microwave?
To Lock/Unlock Control:Touch and hold CANCEL for about 3 seconds, until the tone sounds and the control lock icon appears in the display. ... The control lock icon will remain lit in the display until the control is unlocked.More items...•
How do I unlock my Kitchenaid oven control?
Door is locked when starting or using the oven Turn the power off at the circuit breaker or fuse box for one minute, then turn the power back on. Allow the oven to cool, approximately 30-90 minutes, move the latch arm to the left to unlock the door.
How do I turn off my oven CONTROL LOCK?
To unlock an oven, hold down the Lock button on your control panel for 2 or 3 seconds and wait for the oven to beep to indicate it's unlocked. If this doesn't work, unplug it from the electrical outlet and wait a few minutes. Then, plug it back in again, which may reset the temperature gauge and cause it to unlock.
What is oven CONTROL LOCK?
Per page 9 of the Use and Care Guide: The control lock locks the control panel keypads to avoid unintended use of the oven(s). If set before the power failure occurs, the CONTROL LOCK keypad will remain set after a power failure. The control lock is preset unlocked, but can be locked.
How do I unlock my oven door?
0:203:27Oven Door Won't Open: Troubleshooting Door Lock ProblemsYouTubeStart of suggested clipEnd of suggested clipThe door latching rod by pulling the lock motor assembly down and tilt the front inwards. This willMoreThe door latching rod by pulling the lock motor assembly down and tilt the front inwards. This will allow you to unhook the locking rod from the Drive cam push. The rod forward and open the oven.
Where to find model number on Kitchenaid oven?
In Canada, register your new range at www.kitchenaid.ca. For future reference, please make a note of your product model and serial numbers. These can be located on the oven frame behin d the top right side of the oven door. Model Number__________________________________________ Serial Number ___________________________________________ Para una versión de estas instrucciones en español, visite www.kitchenaid.com. Deberá tener a mano el número de modelo y de serie, que están ubicados en el marco del horno, detrás del lado derecho superior de la puerta del horno.
How long does it take for an oven to shut off?
The oven control is set to automatically shut off the oven 12 hours after the oven initiates a cook or clean function. This will not interfere with any timed or delay cook functions.
How long does it take to preheat a convective oven?
When beginning a Bake, Convect Bake or Convect Roast cycle, the oven will begin preheating after Start is pressed. The oven will take approximately 12 to 15 minutes to reach 350°F (177°C) with all of the oven racks provided with your oven inside the oven cavity. Higher temperatures will take longer to preheat. The preheat cycle rapidly increases the oven temperature. The actual oven temperature will go above your set temperature to offset the heat lost when your oven door is opened to insert food. This ensures that when you place your food in the oven, the oven will begin at the proper temperature. Insert your food when the preheat tone sounds. Do not open the door during preheat before the tone sounds.
Do you line the bottom of an oven with foil?
IMPORTANT: To avoid permanent damage to the oven bottom finish, do not line the oven bottom with any type of foil or liner.For best cooking results, do not cover entire oven rack with foil because air must be able to move freely.
Do the grates on a gas range interlock?
The grates on this range cover the full width of the cooktop. The two grates may interlock (on some models ), using the hook formed into one end of both grates. The flat end of one grate drops onto the hook on the other grate as shown in the following illustration.
Can you use soap to clean stainless steel?
NOTE: To avoid damage to stainless steel surfaces, do not use soap-filled scouring pads, abrasive cleaners, Cooktop Cleaner, steel-wool pads, gritty washcloths or abrasive paper towels. Damage may occur to stainless steel surfaces, even with one-time or limited use.
What is an induction cooktop?
This induction cooktop generates and uses ISM frequency energy that heats cookware by using an electromagnetic field. It has been tested and complies with Part 18 of the FCC Rules for ISM equipment. This induction cooktop meets the FCC requirements to minimize interference with other devices in residential installation.
What happens if you remove a pan from the surface cooking area?
If a pan is removed from a surface cooking area when it is in use, the “no pan” indicator lights up. A flashing dash “-” will also appear in the display along with an “alert” tone for 1 minute. If the pan is not correctly replaced within 1 minute, the surface cooking area will switch Off.
What is a dual surface cooking area?
The dual size surface cooking area offers flexibility to cook using different sizes of cookware. Single size can be used in the same way as a regular surface cooking area. The dual size combines inner and outer surface cooking areas and is recommended for larger cookware, large quantities of food, and home canning.
How big should cookware be outside the cooking area?
Is the cookware the proper size? Use cookware about the same size as the surface cooking area. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.