Knowledge Builders

how do you adjust the pressure on a torpedo heater

by Dr. Jared Collier III Published 2 years ago Updated 2 years ago
image

First, open the body of the heater and use the burner knob to raise the burn chamber and wick. Light the wick with your match and adjust the size of the flame to the recommended settings for your unit. Even though it is easy, it can be annoying to do this every time you want to turn the heater on.

Part of a video titled Adjusting Pump Pressure on Your Forced Air Heater - YouTube
0:47
2:25
Using a flathead screwdriver adjust. The screw to the right to increase pump pressure to helpMoreUsing a flathead screwdriver adjust. The screw to the right to increase pump pressure to help ignition issues or to the left to decrease pump pressure to ease the flame back into the combustion.

Full Answer

What pressure should a torpedo heater run at?

Pump pressures range from 3 PSI to 6 PSI depending upon heater BTU size.

Why does my propane torpedo heater keep shutting off?

If the thermocouple is too far from the flame, this can cause the pilot to go out and shut down the propane heater; you can fix this easily by moving the thermocouple closer to the flame. The thermocouple could also be worn out, in which case it needs to be replaced.

How do I adjust my Mr heater?

0:489:05Mr. Heater Forced Air Kerosene Heater Cleaning and MaintenanceYouTubeStart of suggested clipEnd of suggested clipMake sure the heater is uncluttered. Make a general visual inspection of the heater for loose orMoreMake sure the heater is uncluttered. Make a general visual inspection of the heater for loose or damaged partners.

How long does a propane tank last on a torpedo heater?

How long will you need to run the heater? A propane model running off a 20-pound propane cylinder set at low will last for 65 hours and set at high will last for 24 hours.

How do I stop my heater from going short cycling?

3 Ways to Stop Your Furnace from Short-CyclingCheck (and Change) the Air Filter. We know it's annoying to hear so much about air filters and replacing them often. ... Check the Thermostat. There are a couple of different options for troubleshooting your thermostat. ... Call an HVAC Professional.

Why is my torpedo heater smoking?

Torpedo heaters are kerosene heaters and here is what I found regarding the smoke: If you are sure of your kerosene and your heater is giving off sooty black smoke it is a sign that the fuel/air mix is off. Make sure your heater is not in a draft. Too much air can create a very high flame condition.

How do you adjust the pressure on a kerosene heater?

0:472:25Adjusting Pump Pressure on Your Forced Air Heater - YouTubeYouTubeStart of suggested clipEnd of suggested clipUsing a flathead screwdriver adjust. The screw to the right to increase pump pressure to helpMoreUsing a flathead screwdriver adjust. The screw to the right to increase pump pressure to help ignition issues or to the left to decrease pump pressure to ease the flame back into the combustion.

Does Mr. Heater have a regulator?

The buddy system has the regulator located at the heater. In this setup you cannot have a regulator at the propane tank due to over-regulating the gas supply. This makes the gas that passes through the hose to get to the buddy system high pressure.

How long will a Mr. Heater run on a 20 lb tank?

220 hoursProvides 3-12 hours of heat from two 1lb. propane cylinders and up to 220 hours on two 20 lb.

How long will a 15000 BTU heater run on a 20 lb propane tank?

29 hourFeatures a soft nose P.O.L. and adjustable regulator with three heat settings - 10,000, 12,500 and 15,000 BTUs. Mounts directly to a 20 lb propane tank with up to a 29 hour run time on high.

How long will a 100lb propane tank last on a 30000 BTU heater?

10 daysThese 80 gallons of propane contain 7,320,000 BTU of heating energy....1st Calculation: How Long Will 100-Gallon Propane Tank Last (Based On Heating Need)Heating Need (BTU/h):100-Gallon Tank Lasts For:5,000 BTU/h61 days10,000 BTU/h31 days20,000 BTU/h15 days30,000 BTU/h10 days2 more rows

How long will a 20lb propane tank run a 10000 BTU heater?

About 24-36 hours. Depends on how much the heater runs.

Why does my gas heater keep turning itself off?

If your furnace shuts off too often, you could have a corroded or dirty flame sensor. A flame sensor lets your system know there's a flame when the gas valve is open. If there isn't a flame, the sensor will shut off the gas valve to keep the gas from getting into your house.

Why does my space heater keep turning off after a few seconds?

If your space heater keeps shutting off, chances are you have a damaged power cord or a dirty air filter. A faulty heating element or a fried circuit board could also explain the issue.

Why does my space heater keep turning off after a few minutes?

Solution. Your trusty space heater is turning off because it is getting overheated. The most common reason for overheating? You may have used it so much over the years that the filter might be clogged as it pulls in the cold air.

Why does my Big Buddy Heater keep shutting off?

Re: Big Buddy Heater keeps turning Off I break the q tip down a little because it's just a bit too much cotton and causes the q tip to get jammed. You are basically looking to clean it out. I usually spin the q tip as I push it thru and out again. This has always fixed the problem.

1.Videos of How Do You Adjust The pressure on a Torpedo Heater

Url:/videos/search?q=how+do+you+adjust+the+pressure+on+a+torpedo+heater&qpvt=how+do+you+adjust+the+pressure+on+a+torpedo+heater&FORM=VDRE

36 hours ago  · This will show you how to adjust the pump pressure on your kerosene forced air heater or as they are commonly called, a torpedo heater. The pump pressure det...

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9