Residential Rotors - I-20 Rotary Sprinkler Adjustment Instructions
- Arc Adjustments Adjustable heads are preset to approximately 180 degrees and can be adjusted with the water on or off. ...
- Increasing the Arc Insert the plastic end of the Hunter adjustment wrench into the arc adjustment socket. ...
- Decreasing the Arc To decrease the arc insert the plastic end of the adjustment wrench back into the arc adjustment socket. ...
- Radius Adjustment ...
How do you adjust a Hunter 1/20 sprinkler head?
Insert the plastic end of the Hunter adjustment wrench into the arc adjustment socket. While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360 degree rotation of the wrench will increase the arc 90 degrees. You can adjust the arc anywhere in between 50 degrees and 360 degrees.
How do you adjust the distance on a Hunter sprinkler head?
0:000:27How To Adjust Your Sprinkler Heads - Hunter PGP Radius - YouTubeYouTubeStart of suggested clipEnd of suggested clipTo change the distance of throw of a PGP insert the hex end of the adjustment tool into the rangeMoreTo change the distance of throw of a PGP insert the hex end of the adjustment tool into the range adjustment screw. You'll find this screw under the raised bump on the PGP s rubber. Cover turn the
How do you adjust Hunter PGP Ultra rotor sprinkler heads?
0:181:45How to adjust a Hunter PGP sprinkler head - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you turn it counterclockwise to make it. And that go as far that way and you turn it towards A+MoreAnd you turn it counterclockwise to make it. And that go as far that way and you turn it towards A+ to make it go further that way and a little bit of a turn will make quite a bit of difference.
How can I raise my sprinkler heads without digging?
0:214:15How To Easily Raise a Sprinkler Heads in 3 Minutes Without DiggingYouTubeStart of suggested clipEnd of suggested clipYou basically can raise two heads now if your heads are sunk in extra low you can join the two capsMoreYou basically can raise two heads now if your heads are sunk in extra low you can join the two caps together to raise your head approximately three inches.
What do the numbers mean on Hunter nozzles?
By referring to the Hunter PGP performance chart you will note the following: • As the nozzle size goes up the flow rate goes up. I.e. the flow rate on a Number 1 nozzle is. AT 206 KPA is 1.8 Litres per Minute (LPM), while a number 6 nozzle at the same pressure (206 KPA) has a flow rate of 7.4 LPM.
How do you calibrate sprinkler heads?
2:093:02How To Adjust A Hunter Rotary Sprinkler Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipDirection if you need to increase the arc turn the tool clockwise as indicated by the plus sign nextMoreDirection if you need to increase the arc turn the tool clockwise as indicated by the plus sign next to the hole. Turning. The tool counterclockwise. Towards the minus sign will decrease the arc.
How do I adjust my oscillating sprinkler?
0:041:38How to Use an Adjustable Length Rectangular Sprinkler - YouTubeYouTubeStart of suggested clipEnd of suggested clipRight center or left left. And right refer to the directions when you're facing the sprinkler fromMoreRight center or left left. And right refer to the directions when you're facing the sprinkler from the end where it connects to the hose.