How to Attach Round Rings on a Curtain
- 1. Mark the Top Edge Mark the top edge of the wrong side of the curtain panel with marks about 6 inches apart spaced equally across the top edge. ...
- 2. Purchase the Zip Ties ...
- 3. Insert the Pointed End ...
- 4. Lay the Curtain Flat ...
- 5. Thread the Needle ...
- 6. Sew On the Zip Ring ...
- 7. Attach the Curtain to the Rod ...
How to hang curtains with rings and hooks?
Part 2 Part 2 of 2: Hanging the Curtains Download Article
- Lift your curtains from the top. Lifting from the bottom or middle will cause the curtain to ruffle and hooks could fall out.
- Loop the hooks into the rod links. The links on the curtain rod should have holes or attachments for you to put the hooks through.
- Release the curtains slowly. ...
- Check to make sure every hook is fastened. ...
- Test your curtains. ...
How to install ring clips on curtains?
How to Install Curtains Using Rings & Rod
- Measure from the top of the inside of the ring to the bottom of the eye-screw or, if the ring has a clip rather than an eye-screw, to within ...
- Measure the length of the curtains from the top edge to the bottom edge. Add the ring add-on allowance.
- Mount the hardware on the wall according to the manufacturer’s instructions. ...
How many curtain rings do I Need?
With the return of the drapery secured to the wall, additional rings would not be necessary. But, if your drapery panels do not have a return, you will need to add a total of two rings, so you will need a total of nine rings. If you do not have access to your drapery panels, don’t fret. Industry standards are 3 to 4 rings per foot of the ...
How far apart should curtain clip rings be placed?
The heaver the curtains, the more pull, if your curtains are floor-length, lined & made from heavy material your rings should be closer together, if your fabric is light or transparent & short, rings could be further apart. I'd say ABOUT 4 to 6 apart inches would be my guess. But, it all depends on the look you're going for!
Can you attach curtain rings to curtains?
Unfold your curtain all the way and place a clip ring at either end, on the top edge of the panel. Fold your curtain in half so the two clip rings meet. Put a clip ring on the other end. Fold your curtain in half again, and place two clip rings on each fold at the other end.
How do you attach curtain rings to back tabs?
0:572:41Bali Blinds | How to Install Back Tab Draperies with Decorative RodYouTubeStart of suggested clipEnd of suggested clipWith the drapery still lying on a flat surface insert the end of the rod without the finial throughMoreWith the drapery still lying on a flat surface insert the end of the rod without the finial through the tabs. Once all the tabs have been inserted on the rod. Screw.
Where should curtain rings be placed?
Typically, these require a ring every 5-7 inches of panel width, or if they have Back Tabs, then a ring at each back tab and on either end. That is all. CWF PRO TIP: Figuring out the spacing of rings on flat panels is more art than science, and it is based on how full or how flat you want your panels to appear.
How do you put grommet rings on a curtain?
0:001:10How To Hang Grommet Curtains & Panels - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou'll need a metal rod that matches the grommets on your drape and the diameter. You want is a oneMoreYou'll need a metal rod that matches the grommets on your drape and the diameter. You want is a one in three eighths or a one and a half inch.
How do you attach curtain rings to fabric?
2:263:43How to Sew Easy Rod Pocket or Ring Clip Drapes - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen find the center of your panel. And clip that to the center ring and then measure where to clipMoreThen find the center of your panel. And clip that to the center ring and then measure where to clip your remaining rings to the panel to make those folds even.
How do you attach split rings to curtains?
Simply slide the ring into the desired pocket height on the back of the pencil pleat tape and hang on your rod. Space the rings out evenly on your curtains. These rings are made from high grade steel material that suit 16mm or 19mm curtain rods. TIP: The more rings you use the better your curtain will sit on the rod.
How much bigger should curtain rings be than Rod?
Choose a drapery ring with an inside diameter ½ inch larger than the diameter of the pole or rod. For example, if you have a 1-inch diameter rod, the appropriate ring will have an inside diameter of 1 ½ inches. A ring with a smaller inside diameter will make it difficult to move the drapery along the rod.
How far apart do you put clip rings on curtains?
I like to space ring clips approximately four inches apart so that there is a handsome fold between each clip in the drapery panel. Start by clipping each end of the panel. Next, clip the middle. Finally, space the clips evenly apart as close to 4 inches as possible.
Should the curtain rings match rod or curtain?
Wooden curtain rod rings are designed to be used with matching wood drapery hardware. That's because the ring size is made to fit the specific diameter of the rod you will be using.
What is the difference between a grommet and an eyelet?
Grommets are typically used for more heavy duty materials and usually are bigger in size. Eyelets are often used to finish off the opening for a drawstring casing. A buttonhole will serve the same purpose, but an eyelet can be a professional looking detail.
How do you attach metal rings to curtains?
0:562:37Types of Curtain Grommets & How to Install - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt is simply pressed over the top of the raised portion of the grommet on the underside. Until itMoreIt is simply pressed over the top of the raised portion of the grommet on the underside. Until it snaps in place the durable plastic curtain grommet is now installed.
Which side of a grommet goes down?
The grommet portion (the male piece) is inserted from the right side into the cut hole so it pushes through to the back. The washer portion (the female piece) is placed over the portion of the grommet sticking out through the hole, like a little hat.
Can you use rings on tab top curtains?
Like rod pocket curtains, you can add clips or rings over the tabs if you want to enhance the look. Rings also add length. If you need a few extra inches, attach rings to the top of the curtain to lower the panel to the length you want.
How do you attach curtain tieback hooks?
1:032:38How To Install Curtain Tie Back Hooks - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd a hammer drill. And you make a hole. Which is slightly bigger than the tie-back hook screwMoreAnd a hammer drill. And you make a hole. Which is slightly bigger than the tie-back hook screw itself so that you can then once you've made the hole you can fit a raw plug into that hole.
How do you attach curtains to the back?
How to Place a Hook in a Wall for Tying Back CurtainsMeasure for Horizontal Placement. ... Measure for Curtain Hooks Height. ... Mark Wall for Tieback Hook. ... Align Hook Screw Tip With Mark. ... Screw Hook Into the Wall. ... Secure the Hook. ... Securing a Hook in Drywall. ... Securing a Hook in Masonry.
How do you use curtain tie back loops?
Gather the curtain loosely and wrap the loop-end of the tieback around it one way and the tassel-end around it the other way. Slip the tieback loop over the tassel, arranging it to rest just at the top of the tassel. Adjust the curtain and the tassel and do the same for the other curtain.
How to hide zip ring on curtain?
Lay the curtain flat, the wrong side of the top edge away from you. Lay one ring on a ring location mark. Overlap the zip tie ring past the edge of the curtain. If the tie rings are 1/4 inch in diameter, overlap it by 1/4 inch. The top edge of the curtain will conceal the zip ring when the curtain is hung.
How to stitch a curtain back?
Pass the needle back to the right side of the curtain, immediately beside the previous stitch, and pass it back to the wrong side, snug up to the last stitch. Continue stitching until the bottom half of the zip ring is covered in stitches. Repeat with the remaining zip rings.
How to sew a curtain with a needle?
Insert the sewing needle from the wrong side of the curtain to the right, through the zip ring, and close to the inside edge of the ring. Work on the bottom half of the zip ring only. Pass the needle back to the wrong side exiting on the outside edge of the ring at the stitch origin point. Pass the needle back to the right side ...
How wide is a zip tie?
Buy the narrowest zip tie you can find. Big-box DIY stores carry ties 1/8 inch wide .
What side of the curtain hangs parallel to the rod?
If you want to attach a curtain to the ring, you must have some way of attaching the ring to the curtain so the right side of the curtain hangs parallel to the curtain rod.
How many inches to draw up a double thread?
Thread a needle with regular thread and draw up a double thread of 36 inches. Knot the ends.
Can you use a jump ring on a curtain?
Do not use open-ended metal rings such as jewelry jump rings; the weight of the curtain could pull the rings open, causing the curtains to fall.
What does "more curtain rings" mean?
More curtain rings = more pleats = panel will (generally) sit wider on the rod
How to hang curtains back on rod?
Your next step is to hang the curtain (s) back on the curtain rod. Start by placing the rings on the rod; then pull the fabric between each ring toward you. The curtain rings should sit toward the back/wall, and the (ring-free) pleated fabric should sit forward away from the wall.
How many pleats are there in a standard curtain panel?
I’ve gotten into the habit of doubling up my grommet-topped panels on each side of the window to give a fuller look (since a standard panel only produces four pleats). But with curtain hooks, you can determine how many pleats you want, which therefor dictates how wide your curtains sit! Below is a side-by-side of the exact same panels hung on grommets (left) and curtain rings (right).
How to keep pleats on curtains?
Once you have the pleats set at the top, use your hands to form those same pleats all the way down the length of the curtain. Once you have the pleats formed, use a string (or a hair clip, in my case) to hold the pleats together. This is called “training” your curtains, and works wonders for maintaining perfect pleats long after you’ve hung them.
What size curtain rings should I use for a rod?
Curtain rings – I like 1″ rings since they hold the panels closer up toward the rod. I bought this big bulk set.
Where do you put a hem line on a curtain?
This hem line that you just pinned should technically be at the top of your curtain panel (because we hung it upside-down, remember?).
Where to place clips on curtain panels?
You will always place a clip on either corner of the curtain panel and then evenly space the remaining clips in between those two. Before you move forward, it can be worth the time to experiment to see how many rings you prefer on your particular panel.
What clips can be used on rod pocket curtains?
Hooks or curtain ring clips can be used on rod-pocket curtains.
What are the different types of curtains?
There are two general types of curtains -- those that are hung with rings and those that have a pocket to slide a rod through. Each style has its own advantages and disadvantages. Specialty curtain rings with clips attached allow you to hang any type of lightweight or medium-weight curtains from a curtain rod. Advertisement.
How many rings are needed for a bathroom window?
The number of rings per package can vary, but is usually between 5 and 15. Plan accordingly.
Where to attach hooks to curtain?
Attach the hooks or clips to the curtain at the spots that were previously marked out.
Can you use hooks on curtains?
Hooks provide a more stable solution than clips, but may permanently alter or damage the fabric of the curtains. If the fabric of the curtains is woven loosely, such as a light brocade, you may be able to use hooks by sliding the tip between two threads in the fabric.
Can you pull curtains from a clip?
The weight of the window treatment may cause the fabric to pull free from the clips. Young children and pets can easily pull a curtain from a clipped curtain ring.
Who is Elizabeth Tumbarello?
Elizabeth Tumbarello has been writing since 2006, with her work appearing on various websites. She is an animal lover who volunteers with her local Humane Society. Tumbarello attended Hocking College and is pursuing her Associate of Applied Science in veterinary technology from San Juan College.
What are goblet pleats?
Goblet pleats feature a detailed heading style that looks identical to pinch pleated drapes. These pleats are tucked and folded, with an open design at the top of the curtain. The pleats have a cylindrical cuff that looks more like a wine glass. The main goblet pleat is shaped in interlining patterns and is mostly seen in grand homes with high ceilings.
What is hidden tab drapery?
Hidden tab panels are a simple way to hang your curtains as they provide a pleated look. Hidden tabs feature a series of flat loops or tabs that are sewn along the back of the curtain panel over the pole. These hidden tabs make the drapery look as though it is floating on the pole.
How to hang curtains with pencil pleats?
The neat and consistent folds resemble the size of a pencil, hence the name. You can hang your curtains using drapery pins attached to the back of the drape where the pins are out of sight. They can then be hooked onto a pole system.
What is the best way to hang drapes?
Curtain rings are another popular choice for hanging drapes. Using small hooks, you can attach your curtains to those rings before slipping them onto the rod. Curtain rings are a durable and practical solution as they allow the drapes to be easily removed and replaced.
Why are there hidden tabs on curtains?
This is because the curtain’s fabric touches the rod directly, thus making it more difficult to move. 2. Rod Pockets.
What is a rod pocket?
Rod pockets allow the curtain fabric to easily turn back on itself and create a pocket through which the rod can fit into. This allows the top of the curtain to gather slightly. With rod pockets, you’ll need to consider how often you want to open and close your curtains.
What is the best way to make a curtain panel look tailored?
4. Hanging Pins. Hanging pins are a super elegant way of creating a tailored look thanks to the plastic thread that creates loops on the curtain panel’s back. With a hanging pin , you can loop it through the plastic thread before attaching onto the ring.
