- Turn the pool filter system off.
- Attach your pool hose to the backwash port on your sand filter.
- Select the “Backwash” position on your multiport valve handle.
- Turn the pool filter system on and allow it to rush out of the backwash port and through the backwash hose for two minutes or so until the water ...
- Turn the filter off again and set your multiport filter valve to the “Rinse” position.
- Turn the pool filter system back on and allow it to run for a minute or so.
- Turn the pool pump off and switch the multiport valve to its original setting (usually the “Filter” position).
How do you backwash a sand filter on a pool pump?
With your backwash hose connected, turn off the pump, and move the valve to the “Backwash” position Turn on the pump and backwash the filter for 3-5 minutes Turn off the pump, and move the valve back to the “Filter” position Open the pump lid, and pour the sand filter cleaner into the pump’s strainer basket.
How do you backwash a pool with a multiport filter?
Select the “Backwash” position on your multiport valve handle. Turn the pool filter system on and allow it to rush out of the backwash port and through the backwash hose for two minutes or so until the water in the sight glass runs clear. Turn the filter off again and set your multiport filter valve to the “Rinse” position.
Why do I have to rinse my pool filter after backwash?
Rinsing the filter is needed because the sand gets moved around during backwashing and needs to be reset. Additionally, the filter tank still has backwash and sand sediment in it that needs to be removed so it’s not returned to the pool. Step 6.
What size backwash hose for Intex 2650 sand filter?
What does everyone use for a backwash hose on the Intex 2650 Sand Filter? I'm using a intex hose that is usually used to connect to the return and it's just not long enough. I need something closer to 15-20 feet long. Suggestions? You can buy backwash hose in 1 1/2 or 2" diameters in a roll of 25' or 50' long.
How to backwash a pool?
Backwashing is an easy process, but you do want to make sure you follow the steps correctly to get it as clean as possible. 1. Turn the pool filter system off. 2. Attach your pool hose to the backwash port on your sand filter. 3. Select the “Backwash” position on your multiport valve handle. 4.
How long does it take for a pool filter to clear?
Turn the pool filter system on and allow it to rush out of the backwash port and through the backwash hose for two minutes or so until the water in the sight glass runs clear.
What is the PSI of a filter?
PSI (pounds per square inch) is the measure of pressure your filter is operating on.
Why is my pool water cloudy?
If you notice your pool water getting a little cloudy or see debris floating in it that the filter doesn’t seem to be removing, it could mean the filter isn't working as well as it should. You'll also notice high TDS (total dissolved solids) levels when you test your chemistry levels if this is the case.
How to know when to backwash?
However, if the flow rate is dropping, you'll likely experience an increase in PSI and cloudy water as well, so you can usually just go by those two indicators to know when it’s time to backwash.
What should my pool water be?
Your pool water should be crystal clear and ready to swim in again!
How often should I clean my pool?
I personally don’t think it hurts to take care of it once a week when you are checking your pool chemicals, but there are certainly instances when you should clean it more often like when you're battling algae, after a storm and when you see obvious signs that it’s dirty.
