step 1 :Removing the Blower Motor 0:20 Remove the four clips from the panel below the glove box Pull down the panel under the glove box Disconnect the blower motor electrical connector Remove the three 8mm bolts from the blower motor Remove the blower motor from the HVAC box step 2 :Installing the Blower Motor
How do I replace the blower motor on my Toyota Corolla?
The blower motor is covered by a black plastic cover, located below and behind the glove box. Pull down on this cover to remove it. Then set it aside.
How do you remove the a/C blower on a Toyota Camry?
Removing the A/C blower is only a matter of removing three screws and a plug. Getting to the blower, however, is a different story. This article applies to the Toyota Camry (2007-2011). The Camry’s A/C blower is a hard-working component of cabin comfort. It has to both maintain interior temperature, plus run at different speeds to accomplish this.
Why is my AC blower motor not working on my Camry?
The most common causes for AC fan blower motor not working in Toyota Camry are blown fuse, bad relay, resistor or control module malfunction and faulty blower motor. However, a bad electrical connector or broken wire, or a defect in the climate control unit can also cause the blower motor to stop working. 1. Blown fuse
How to fix a blower motor that won’t turn on?
Twist the blower motor so you can access its electrical connection. Unplug this connection by pushing in the tab in the center of the plug. Now remove the blower motor from its housing, and set it aside.
Can I replace my blower motor myself?
You can replace a blower motor yourself without much risk of hurting the system, but you're likely to hit a snag in the process.
How do I know if my motor blower is bad?
What Are Signs Your Blower Motor Needs to Be Replaced?Poor or Airflow from Air Vents. This will be the first and most obvious sign your blower motor has a problem. ... No Airflow At All From Vents. ... Skyrocketing Energy Bills. ... Strange Noises When You Turn on the Heat. ... Overheating Blower / Weird Smells.
How much is the labor to replace a blower motor?
Blower motor replacement typically takes two to three hours to complete, at a charge of $75 to $150 per hour. That brings the cost of labor to $150 to $450, depending on the difficulty of the repair and the cost of labor in your area.
How do you remove the blower motor on a 2007 Toyota Camry?
1:344:56How to Replace Blower Motor 06-11 Toyota Camry - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd push it on the lock. That down that aside you can use a large Phillips head screwdriver toMoreAnd push it on the lock. That down that aside you can use a large Phillips head screwdriver to remove the three bolts that have Philips head screws in there pull in the blower motor.
How long does it take to change a blower motor?
How long does it take to replace a blower motor? Replacing a blower motor takes 2 to 3 hours on average. The blower motor is typically located behind a control board and other furnace parts.
How often do blower motors go out?
10 to 20 yearsBlower motors are designed to last just as long as your furnace itself, anywhere from 10 to 20 years.
Is it hard to replace a blower motor?
The replacement of the blower motor is common and straightforward, so most shops will perform the repair — many on the same day.
Where is a blower motor located?
The blower motor is usually under the dashboard on the passenger side. Blower motors that make loud squeaks or rattling noises may be worn out and on the verge of packing it in, but sometimes those noises are caused by leaves or other debris that can be cleaned out after the motor is removed from the vehicle.
Why do blower motors fail?
Blower motor breakdown can be the result of anything from old age to failed bearings, high amp draw, electrical failure in the windings, dirt accumulation, and more. “The most common cause is dirt accumulation due to lack of maintenance,” said Tom Beaulieu, president of Bay Area Services Inc.
How do you change the blower motor on a 2005 Toyota Camry?
0:103:30How to Replace Heater Blower Motor 2002-06 Toyota Camry - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd pull down on the connector that's going to disconnect the wiring for you with an eightMoreAnd pull down on the connector that's going to disconnect the wiring for you with an eight millimeter socket go ahead and remove your three bolts there's one here one up front and one back.
How do you clean a car blower motor?
Here's what to do:Disconnect car battery.Detach the blower motor from its connector.Unscrew all the screws on the blower motor. ... Locate the retainer clip in the center of the blower wheel. ... Clean out any debris from the motor.Clean the blower motor with an electrical-parts cleaner.Oil the bearings.More items...
How do you change a blower motor on a 2010 Toyota Corolla?
0:552:57How To: Replace the Blower Motor in a 2010 to 2017 Toyota CorollaYouTubeStart of suggested clipEnd of suggested clipUse a ratchet and an eight millimeter socket with an extension to remove the three bolts securingMoreUse a ratchet and an eight millimeter socket with an extension to remove the three bolts securing the blower motor. And lower it from the housing. Lift your new blower motor. Into place.
How do you test a blower motor on a car?
Turn off your vehicle, set your multimeter to Ohms, and check for resistance between the blower's positive and negative terminals. You may also turn the car key to run without starting the engine, put the cooling system at full blast, and check for DC voltage. If none of these produces a reading, the blower is bad.
What happens when a blower motor fails?
Power to the blower motor is fed through the blower motor resistor, so if it fails or has any issues power can be cut off to the motor. A blower motor without power will not be able to produce any air pressure, and as a result the heating and air conditioning system will be left with no air coming from the vents.
What does a bad blower motor sound like in a car?
A defective blower motor will make a continuous sound noticeable by the passengers in the vehicle. It can manifest as a knocking, whirring, clunking, vibrating, squealing, or whining noise that persists until the blower motor is replaced.
How do you test a HVAC blower motor?
0:185:18Step by Step Procedure for Troubleshooting a Blower Motor ...YouTubeStart of suggested clipEnd of suggested clipAnd then you put one probe on there and one to the l2. Common neutral bar right here and you shouldMoreAnd then you put one probe on there and one to the l2. Common neutral bar right here and you should read 120 volts. If you read 120 volts. And your blower motor is not turning on then.
1. Blown fuse
The AC blower motor in Toyota Camry needs electricity to work. In case of a faulty fuse, the circuit is interrupted and the motor can not work.
2. Bad relay
Relays are electromagnetic switches that are used to switch electrical loads on and off. A bad relay can also be the cause of AC blower motor failure in your Toyota Camry.
3. Bad resistor or control module
The function of the blower motor resistor is to control the speed of the blower motor. When you increase or decrease the AC fan speed in your Camry, the climate control unit signals the resistor module to increase or decrease the flow of electric current to the blower motor.
4. Faulty blower motor
When you turn on the AC fan in your Camry, and the air does not flow out of the vents, or the airflow is poor or inconsistent, it could be due to a broken blower motor.
5. Bad connector or broken wire
A bad connector on the blower motor or the resistor module, or on the climate control unit can interrupt power supply to the blower motor in Camry. Additionally, a damaged wire in the circuit, including the wire from the fuse box, can also cause the blower motor to stop working.
6. Defective climate control unit
Climate control module is the brain of the air-conditioning system in your Toyota Camry, also responsible for turning on and controlling the speed of the blower motor. In rare cases, a fault in the climate control unit can cause the blower motor to stop functioning properly.
Conclusion
There are many reasons why the AC blower motor may not be working in your Toyota Camry. When looking for the reason, you should always start with the most obvious cause, blown fuse or faulty relay.
How to install a blower motor resistor?
Insert your replacement resistor into the compartment and return the two screws and tighten it down into the compartment. Reconnect the cable harness. Take a moment to turn on the blower in your car and switch between the HVAC settings to make sure the new resistor is doing its job. If all is well, then you can clip back the panel for the passenger footwell. Then, you're all done.
What is the part responsible for controlling the blower motor?
The blower motor resistor is the part responsible for controlling the blower. When it stops working, the HVAC controls also stop working. This article will show you how to fix it.
Where is the resistor on a blower motor?
Figure 1. Blower motor resistor is to the left of the motor.
What year was the Toyota Camry?
This article applies to the Toyota Camry (1997-2001).
