How do you change a starter on a Chevy Silverado? Take off the connections for the starter and the wiring harness. Replace the heat shield on the new starting with the one that was on the old starter. To restart the engine, reattach the power line and the solenoid cable to the starter.
Full Answer
How do you remove the starter from a Chevy Silverado?
Disconnect the battery connections leading to the starter. Pull down on the starter, and push it toward the front of the truck to dislodge as well as remove it. Figure 2. Remove the two 13mm starter mounting bolts.
Does the Chevy Silverado have a bad starter?
One of the most common problems that can occur in the life of a vehicle is a bad starter, that includes the Chevy Silverado. It is important to determine whether or not it’s a bad starter that is keeping the vehicle from turning over. If your Silverado is not starting, don’t assume right away that the starter is bad immediately.
How does an electric starter work in a truck?
Each time you switch on the ignition in your truck, the battery supplies power to the electric starter, so it can turn the engine over and allow air as well as fuel to be sucked into the cylinders for combustion.
Why won't my Silverado start?
Why is my starter not turning over?
What does it mean when a Silverado battery is bad?
Why does my Silverado make a grinding sound?
How to tell if a starter is bad?
What is a bad starter?
What does it mean when a Silverado starts with smoke?
See 4 more
About this website
How long does it take to replace a starter?
between 2 and 4 hoursHow long does it take to replace a starter motor? You can expect its replacement to take between 2 and 4 hours. Not all starter motors are easy to get to, which can add time to the process and further cost to your final bill.
How much is a starter for 2007 Chevy Silverado?
2007 Chevrolet Silverado 1500 Starter - from $154.99+ | AutoZone.com.
What can cause a 2007 Chevy Silverado not to start?
5 Reasons Your Chevy Won't StartDead Battery. The most common reason a Chevy car (or any car) won't start is a dead battery. ... Battery Corrosion. Another reason your Chevy car won't start is also battery-related. ... Bad Timing Belt. ... Failed Ignition Coil. ... Bad Starter Motor.
How do you remove a Chevy starter?
0:000:37“removing” STARTER chevy 350, 327, 305 - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe ground wire comes off with an 11 32nd. Wrench if you can get a socket in there it's a lot easierMoreThe ground wire comes off with an 11 32nd. Wrench if you can get a socket in there it's a lot easier to take off the positive wire it's a 9 16.. With these wires off the starter.
How long do Silverado starters last?
between 100,000 and 150,000 milesOn average, your car starter motor should last between 100,000 and 150,000 miles. In many instances, the car starter will last the vehicle's life.
How much does it cost to replace a starter on a Chevy Silverado?
Chevrolet Silverado 1500 Starter Replacement Cost Estimate. The average cost for a Chevrolet Silverado 1500 starter replacement is between $441 and $574. Labor costs are estimated between $134 and $169 while parts are priced between $306 and $405.
Why won't my truck start but has power?
The cause of this problem is usually one of 3 things - a failed starter motor, a bad connection between the battery and starter motor, or a blown fuse (if present) in line between the starter and the battery.
Why does my Chevy Silverado hesitate to start?
When your engine is hesitating, it is usually a symptom of a problem with the air-to-fuel ratio mixture. It can be because the mixture is too lean or there is a problem with the ignition system that is creating the misfire when the engine comes under load.
Why is my car not turning over?
If your vehicle won't start, it's usually caused by a dying or dead battery, loose or corroded connection cables, a bad alternator or an issue with the starter. It can be hard to determine if you're dealing with a battery or an alternator problem.
Can I replace the starter myself?
You can buy a new starter, which is rather expensive, or you can buy a rebuilt starter, which is just as good as a new one [source: Allen]. If the problem is really your starter, save yourself a trip to the mechanic and replace it yourself.
What tools do you need to take off a starter?
Tools needed to replace a starter:Sockets and wrenches.Screwdriver.Pliers.Battery terminal puller.Drive-on ramps, jack or jackstands.
What is the first step for removing a starter?
How to Replace a StarterSafety First. Disconnect the battery. ... Remove the Wiring. Remove the wiring and positive battery cable from the starter solenoid.Remove the Starter and Bolts. Remove the starter retaining bolts. ... Compare to Verify. ... Transfer Heat Shield. ... Replace with New Starter. ... Secure and Tighten. ... Connect the Wiring.More items...
Are all small block Chevy starters the same?
Not exactly. While most starters will look the same, there are slight differences that require noticing.
How do you remove a starter motor?
10 Steps To Replace A Starter MotorStep 1: Safety First. ... Step 2: Jack Up The Vehicle If Needed. ... Step 3: Locate The Starter. ... Step 4: Remove The Starter Motor And Bolts. ... Step 5: Compare The Replacement Starter To The Old One. ... Step 6: Transfer Heat Shield. ... Step 7: Place The New Starter. ... Step 8: Insert The Starter Mounting Bolts.More items...
How do you change a car starter?
1:374:33AutoZone Car Care: How to Replace Your Starter - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow locate the starter under the engine loosen or remove any parts that might interfere withMoreNow locate the starter under the engine loosen or remove any parts that might interfere with removing it then disconnect the electrical cables attached to the starter. Mark them accordingly.
How do you test a truck starter?
The easiest way to check the starter on the vehicle is to use jumper cables to bypass the vehicle's electrical system. With the ignition turned off and the transmission in "park" -- and with all due care -- connect one end of the red/positive jumper cable to the positive terminal of the battery.
Signs of a Bad Starter Relay or Struggling Solenoid
Climb into your car. Buckle up for safety. Turn the key in the ignition and… nothing. Nothing but a click. The engine won’t turn over and your car won’t start.Could be a dead battery.But since the dash lights and the radio and the headlamps seem to be working, maybe something else is the culprit. This could be a sign that your car’s starter relay – or starter solenoid – has gone bad.
Why won't my Silverado start?
Common other reasons your Silverado won’t start include: Bad Battery Cables or Terminals – Throughout your Silverado’s life, the battery cables and terminals can become corroded. This corrosion keeps the proper voltage from getting to the starter. If the dash lights dim or turn off entirely when trying to start your Silverado, ...
Why is my starter not turning over?
There are other issues that can keep it from turning over. These include a bad battery, battery cables, or a neutral safety switch issue. Starters are not expensive, but replacing them can be tricky.
What does it mean when a Silverado battery is bad?
Bad Battery – A battery that is too depleted won’t start your engine. If the starter is turning slowly, but not fast enough for your Silverado to start, it could very likely be a bad battery that is at fault (as opposed to a bad starter).
Why does my Silverado make a grinding sound?
It can also make a grinding sound. If you hear a high pitched whirring sound, it may indicate that your Silverado’s starter is bad, or it could mean that the starter is turning, but not making contact with the flywheel. This is often caused by starter bolts that were not torqued tightly enough, or a broken flex plate/flywheel tooth.
How to tell if a starter is bad?
1. Noises. Your ears are the best diagnostic tool that you have. You can tell a lot about what’s going on with a vehicle by carefully listening for changes. A bad starter will often click, but not engage the flywheel/flexplate. It can also make a grinding sound. If you hear a high pitched whirring sound, it may indicate ...
What is a bad starter?
One of the most common problems that can occur in the life of a vehicle is a bad starter, that includes the Chevy Silverado. It is important to determine whether or not it’s a bad starter that is keeping the vehicle from turning over.
What does it mean when a Silverado starts with smoke?
Smoke coming from under the hood is a good indication that the starter has given up the ghost. It can burn up, or the wiring associated with it can burn up. If you see smoke, stop cranking! Make sure your Silverado isn’t on fire and have a mechanic take a look.
How does a starter work on a Silverado?
Each time you switch on the ignition in your truck, the battery supplies power to the electric starter, so it can turn the engine over and allow air as well as fuel to be sucked into the cylinders for combustion. The starter generally lasts longer than the battery, but when it does eventually fail, you'll be stuck wishing it had enough juice to bring your truck back to life one more time. Replacing the starter in your Silverado isn't a difficult job, and can be completed with just a few basic tools as well as a bit of your time. Take a look at the steps below to learn how it is done.
How to attach a starter to a new starter?
Remove the protective shroud from the old starter solenoid to attach it to the new starter. Slide in the new starter in the correct position underneath the engine, and fasten the 10mm solenoid bolt. Reconnect the starter's battery cables and secure it with the two 13mm mounting bolts. If you removed the bell housing, re-install it as well. Lastly, reconnect the negative battery terminal and switch on the ignition to ensure the engine starts.
How to disconnect battery from hood?
Pop the hood, and disconnect the negative battery cable (black). The starter and battery are directly linked, so the power supply must be cut off.
How to jack up a truck starter?
For this DIY job, jacking up your truck is optional because the starter can still be accessed without raising the vehicle. Place a floor jack under the center of the front crossmember. Lift the truck and place jack stands underneath the side rails to support it.
Why won't my truck start?
Always test the battery and clean the connections before assuming a starter is bad. Oftentimes, the battery or corroded connections can be the actual problem as to why your truck won't start.
What to do if your Silverado won't start?
Starting your Silverado's engine requires the use of two parts: the battery and the starter. So if your battery is fully charged and properly connected but your truck still won't start, it might be time to replace the starter.
Where is the starter located on a V8?
The starter is located underneath the engine on the front passenger's side. On V8 engines, there is a bell cover housing that must first be removed to access the starter. Once this housing is removed, use a 13mm socket with ratchet and extension to remove the two bolts holding the starter in place.
Why won't my Silverado start?
Common other reasons your Silverado won’t start include: Bad Battery Cables or Terminals – Throughout your Silverado’s life, the battery cables and terminals can become corroded. This corrosion keeps the proper voltage from getting to the starter. If the dash lights dim or turn off entirely when trying to start your Silverado, ...
Why is my starter not turning over?
There are other issues that can keep it from turning over. These include a bad battery, battery cables, or a neutral safety switch issue. Starters are not expensive, but replacing them can be tricky.
What does it mean when a Silverado battery is bad?
Bad Battery – A battery that is too depleted won’t start your engine. If the starter is turning slowly, but not fast enough for your Silverado to start, it could very likely be a bad battery that is at fault (as opposed to a bad starter).
Why does my Silverado make a grinding sound?
It can also make a grinding sound. If you hear a high pitched whirring sound, it may indicate that your Silverado’s starter is bad, or it could mean that the starter is turning, but not making contact with the flywheel. This is often caused by starter bolts that were not torqued tightly enough, or a broken flex plate/flywheel tooth.
How to tell if a starter is bad?
1. Noises. Your ears are the best diagnostic tool that you have. You can tell a lot about what’s going on with a vehicle by carefully listening for changes. A bad starter will often click, but not engage the flywheel/flexplate. It can also make a grinding sound. If you hear a high pitched whirring sound, it may indicate ...
What is a bad starter?
One of the most common problems that can occur in the life of a vehicle is a bad starter, that includes the Chevy Silverado. It is important to determine whether or not it’s a bad starter that is keeping the vehicle from turning over.
What does it mean when a Silverado starts with smoke?
Smoke coming from under the hood is a good indication that the starter has given up the ghost. It can burn up, or the wiring associated with it can burn up. If you see smoke, stop cranking! Make sure your Silverado isn’t on fire and have a mechanic take a look.
