how do you change a thermostat in a freezer

1. Disconnect the electrical power. Unplug the freezer or shut off the circuit breaker for the freezer.
2. Remove the control knob. …
3. Remove the grille cover. …
4. Remove the cold control thermostat. …
5. Install the new cold control thermostat. …
6. Reinstall the grille cover. …
7. Reinstall the control knob. …
8. Restore electrical power.

Full Answer

How do you replace a thermostat on a freezer?

How to Replace a Chest Freezer Thermostat

1. Replace the Thermostat. If your chest freezer is not cooling down to the right temperature, the thermostat needs to be replaced.
2. Remove the Panels. To replace a chest freezer thermostat, the panels must be removed. ...
3. Remove the Screws or Retaining Clips. ...
4. Locate the Two Wires and Remove the Thermostat. ...
5. Install the New Thermostat. ...
6. Reassemble the Freezer. ...

How much does a refrigerator thermostat cost to replace?

The cost to Replace a Thermostat starts at $195 - $231 per thermostat, but can vary significantly with site conditions and options. Get fair costs for your SPECIFIC project requirements. See typical tasks and time to replace a thermostat, along with per unit costs and material requirements.

How to install a replacement thermostat?

How to install a thermostat

• Use the safe isolation procedures listed above. ...
• Remove the thermostat frontplate and the dial.
• Open the transparent cover and expose the wires and connections.
• Before you touch anything, use your voltage tester to double-check that all the connections are dead.

More items...

How to replace the thermostat in a whirlpool freezer?

Chest Freezer

1. Unplug the Whirlpool chest freezer from the wall outlet. Do not lift the freezer lid during the repairs.
2. Look on the side of the freezer cabinet for the thermostat control. Pull the knob from the thermostat control.
3. Remove the screw from the top of the thermostat control cover. ...
4. Slide the wire connectors off the thermostat. ...

More items...

Where is the freezer thermostat located?

In freezer-on-top models, it may be located under the floor of the unit, or it could be found at the back of the freezer. If you have a side-by-side refrigerator, the defrost thermostat is found at the back of the freezer side.

How do I change the thermostat in my upright freezer?

0:081:08How to Replace a Frigidaire Upright Freezer Defrost Bi-metal ThermostatYouTubeStart of suggested clipEnd of suggested clipThe shelves from the freezer remove the screws from the evaporator cover pull the evaporator coverMoreThe shelves from the freezer remove the screws from the evaporator cover pull the evaporator cover out of the freezer unplug the wires to the thermostat unclip. The old thermostat.

How do I know if my freezer thermostat is broken?

If food freezes inside the fridge or its compartments, the cause may be a faulty thermostat. You can use an appliance thermometer to check the thermostat, or try increasing the temperature a couple of degrees. Then wait a day to check whether the food has become unfrozen.

Is it easy to replace a thermostat in a fridge freezer?

You can replace a fridge thermostat in a few minutes with some basic hand tools, and the cost is minimal when compared to a service call to a technician or a new refrigerator.

Is it cheaper to repair or replace a freezer?

Typically, most refrigerator repairs will cost less than buying a new one. The rule of thumb is that if the cost of repairs is more than half the cost of purchasing a new refrigerator, you may be better off replacing it.

Why isn't my freezer cold enough?

If your freezer is not cold, the problem may be caused by a broken condenser fan motor. The condenser fan draws cool air through the condenser and over your freezer's coils. If this fan is broken, your freezer's inner temperature will rise, and the compressor will overheat.

Does the fridge thermostat control the freezer?

This control does not actually control the cold—it controls the air that circulates between the freezer and the refrigerator. Fortunately, most manufacturers label the two controls with a suggested normal setting. With a new refrigerator, the recommended settings are the place to start.

How do I reset my freezer compressor?

Here's how to do it:Unplug your refrigerator. Disconnect your fridge from its power source by removing the power cord from the wall outlet. ... Turn off the refrigerator and freezer from the control panel. ... Reset your freezer and fridge temperature settings. ... Wait for the refrigerator temperature to stabilize.

How much does it cost to replace a refrigerator thermostat?

What Are Common Refrigerator Repair Costs?RepairAverage CostThermostat replacement$100 - $440Coils replacement$100 - $440Door seal replacement$50 - $440Drip pan replacement$50 - $2003 more rows•Apr 27, 2022

How do you fit a fridge freezer thermostat?

3:014:47How to Replace a Fridge Thermostat - Zanussi - YouTubeYouTubeStart of suggested clipEnd of suggested clipBefore taking my new thermostat. And unwinding it. And then placing the sleeve. Over the top. AndMoreBefore taking my new thermostat. And unwinding it. And then placing the sleeve. Over the top. And once I've done that this can just be gently fed back into the fridge.

Can a fridge work without a thermostat?

You can run a fridge without a thermostat. A thermostat is just an on/off switch for the compressor. When the temp reaches the point that you set it at, it goes one. Generally, it goes off 2 to 3 degrees below that point.

How do I reset my fridge thermostat?

1:132:36Refrigerator Troubleshooting, Hard Reset, and Liquid Temperature ...YouTubeStart of suggested clipEnd of suggested clipIf the cause of your issue is still a mystery you'll want to try what is called a hard reset unplugMoreIf the cause of your issue is still a mystery you'll want to try what is called a hard reset unplug your unit from the wall for 30 to 45. Minutes then plug the unit back in this will reset the unit.

How do you change a thermostat on a whirlpool upright freezer?

0:562:34Whirlpool Upright Freezer Thermostat - YouTubeYouTubeStart of suggested clipEnd of suggested clipI just strained it out folded it over and then just lit it out i pulled it out the top carefully.MoreI just strained it out folded it over and then just lit it out i pulled it out the top carefully.

How do you change a thermostat on a Kenmore upright freezer?

0:191:08How to Replace a Kenmore Upright Freezer Defrost Bi-metal ThermostatYouTubeStart of suggested clipEnd of suggested clipThe shelves from the freezer remove the screws from the evaporator cover pull the evaporator coverMoreThe shelves from the freezer remove the screws from the evaporator cover pull the evaporator cover out of the freezer unplug the wires to the thermostat unclip.

How do you change the temperature on a Frigidaire freezer thermostat?

0:483:37Temperature Control Thermostat (part 241537103) - Frigidaire ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipUse a flathead screwdriver to help pry off the thermostat control knob disconnect the thermostatMoreUse a flathead screwdriver to help pry off the thermostat control knob disconnect the thermostat power wires along with the grounding wire lift out the thermostat then removed the diffuser block.

What should your freezer temp be?

0° FKeep your appliances at the proper temperatures. The freezer temperature should be 0° F (-18° C). Check temperatures periodically. Appliance thermometers are the best way of knowing these temperatures and are generally inexpensive.

What to do if your thermostat stops working?

If the temperature control thermostat stops working, the freezer can be too cold or not cold enough. Replace the chest freezer thermostat with the manufacturer-approved freestanding freezer part. Use this procedure to replace the temperature control thermostat on common Kenmore, Frigidaire, Gibson, Crosley, Kelvinator and White-Westinghouse chest ...

How to secure cold control thermostat to compressor grille?

Squeeze together the 2 locking tabs that secure the cold control thermostat to the compressor grille cover and release the cold control thermostat from the grille.

Where is the thermostat located on a chest freezer?

After that, locate the thermostat. For most models, the thermostat is located on top of the chest freezer. If not, the thermostat is located in the rear compartment or underneath the floor panel.

How to tell if a chest freezer thermostat is broken?

One way to test the thermostat is to set it to a colder temperature. If the freezer cools down to your new setting, the thermostat is not broken. If there is no change in the temperature, it must be replaced.

Can you turn off the power on a freezer?

You should not turn off the power until you have prepared all the working tools, especially if there is food inside the freezer. Prior to replacing the thermostat, perform a thorough inspection of your freezer to check for other problems that are causing the problem. The condenser coil on the fridge must be clean with plenty of room for ventilation. Use a vacuum cleaner to clean away the dust that has accumulated behind the freezer.

How to locate the thermostat in your fridge/ freezer?

The thermostat is usually found inside the fridge where it is fixed. You can clearly spot it behind the dimmer used to regulate the fridge temperature.

How to remove thermostat panel?

Remove the panel by unscrewing the screws holding the thermostat in place.

What is a thermostat?

A thermostat regulates the overall temperature of the fridge and freezer. It is found behind the control panel.

What does it mean when your fridge starts up?

Plugin the appliance and check if the fridge starts up normally. This usually means a faulty thermostat is in place.

How to replace thermostat capillary?

Slide the thermostat out of the capillary with soft hands and replace it with your new thermostat capillary. Slide the new thermostats capillary back inside and reconnect all the wiring using the picture you took on your phone as a reference.

What to do if your fridge doesn't cool?

If your fridge or freezer is connected to an outlet but the fridge cavity does not cool. Try unplugging the unit and removing the thermostat using a screwdriver.

What to check before working on a fridge?

Before you begin working on your fridge make sure to check if the motor or compressor is still running. Inside the motor is a capacitor. The current is kept inside the capacitor even though it is not receiving any power. Therefore, make sure to discharge the capacitor when working on any capacitor-type fridge or freezer. This is extremely important, or you may receive a severe electric shock.

How to change thermostat sensor?

Grab the new control thermostat and straighten out the sensor bulb. Then, thread the bulb through the plastic installation tube that’s attached to the side of the damper control. Stop sliding the sensor bulb forward once the tip of the bulb reaches the end of the tube.

Where is the temperature control thermostat on a Frigidaire refrigerator?

The control thermostat is found in the control housing inside the fresh food compartment of your Frigidaire refrigerator model FRS26R4CW.

What does a sensor bulb do in a freezer?

The sensor bulb, which monitors the temperature, stretches from the control thermostat to the freezer interior. If you notice your freezer is too cold or too hot, there’s a good chance the temperature control thermostat has failed and is no longer switching the compressor on and off at the appropriate time.

How to pull back thermostat bracket?

Before you push the control thermostat into its bracket, reconnect the wires to its terminals. Then, use your Flathead screwdriver to pull back the bracket locking tab while pushing down on the control thermostat until the component locks in place.

How to remove thermostat from mounting bracket?

Next, remove the control thermostat from its mounting bracket by using your Flathead screwdriver to depress the locking tab holding the component in place.

How to install a control housing on a refrigerator?

Begin installing the control housing assembly by threading the sensor bulb through the opening near the back of the fresh food compartment. Then, insert the control housing plug into the refrigerator ceiling. Next, push the water lines into the back of the control housing assembly.

Where to insert sensor bulb?

Insert the rest of the sensor bulb into the clips running along the inside of the control housing. Then, near the temperature control, bend the sensor bulb so you can fit the component back into the mounting bracket.

Where is the thermostat located on a refrigerator?

If you have a refrigerator that is next to the freezer then the thermostat should be found at the back of the freezer.

How long does it take for a refrigerator thermostat to work?

If the thermostat is working okay then it will take a few hours to maintain a steady temperature. However, if it doesn’t then it will need replacing.

How to pull wires out of thermostat?

There will be some wires that are attached to the thermostat and these need to be pulled away gently using the pliers. You should make sure that you are extremely careful doing this as if you pull too hard or grip the wires in the middle then they could break under the pressure.

Can you take a thermostat out of a refrigerator?

Once you’ve removed any remaining screws or clips holding it in place, you are now in a position to take the old faulty thermostat out of the refrigerator. If the thermostat is around an evaporator tube then you should take care when removing as this may cause damage.