Replacing the oil in your Briggs and Stratton Lawnmower:
- ● Step 1: Prepare your Lawn Mower for the Oil Change ...
- ● Step 2: Disconnect the spark plug cable ...
- ● Step 3: Tilt the mower and set it up ...
- ● Step 4: Drain the oil ...
- ● Step 5: Replace the oil filter ...
- ● Step 6: Check all the connections ...
- ● Step 7: Add in new oil and start the engine ...
How often should I change the oil in my Briggs & Stratton?
This article will discuss how you can check and change the oil on your Briggs & Stratton engine lawnmower! You will need to change the oil in your lawn mower engine every 25-30 hours of use. This is much more often than other engines, and it needs to be done because this type of engine uses a lot less oil than others.
How do you take care of a Briggs and Stratton engine?
Steps to Better Engine Maintenance. For optimum performance, you should change the oil in your small engine after the first five hours of use and then annually, or every 50 hours of use (whichever comes first). Use Briggs & Stratton SAE 30W Oil above 40°F (4°C) for all of our engines. Check oil level regularly.
What kind of oil do you put in a Briggs and Stratton?
Use Briggs & Stratton SAE 30W Oil above 40°F (4°C) for all of our engines. Check oil level regularly. Air-cooled engines burn about an ounce of oil per cylinder, per hour. Fill to mark on dipstick. DO NOT OVERFILL. Start the engine and run it until it is warm.
Does a Briggs and Stratton EXI need an oil change?
While regular scheduled maintenance of your EXI engine will eliminate the need for an oil change, Briggs says it won't hurt if you do it anyway. ReadyStart® Engine Starting System: No prime, no choke - just pull for power.
See more
What to do if your muffler is smoking?
If while tipping, some oil drains from the muffler, wipe the access oil with a rag, when restarting the engine, allow the oil to burn off as smoke. If the engine smokes excessively, see your local Briggs & Stratton Dealer.
How long does it take to change the oil on a lawn mower?
Heavy usage requires changing the oil after 25 hours of use, follow the directions in your owner’s operators manual to provide your lawn mower with the attention it requires or view the video for directions. The following are acceptable oil drain methods: Through the dipstick tube. Through the drain plug. By using an oil extractor tool.
Where is the drain plug on a lawn mower?
If your engine is equipped with a drain plug, it would be located under the lawn mower deck. Look carefully as the drain plug may be obstructed by clumps of turf or debris, the belt guard or the mower blade (use caution when moving the blade).
Where to find oil recommendations for Briggs and Stratton?
Oil recommendations are located in your engines operator’s manual. You should see your local Briggs & Stratton Dealer if your oil level is too high and you did not overfill the engine with oil, your oil level is consistently too low and there are leaks on the engine or stains underneath, your engine smokes excessively.
Does moving the blade on a muffler cause oil to smoke?
Note: if you must move the blade to get at the drain plug, do so slowly and with the spark plug removed. Moving the blade may cause excess oil to appear in the muffler, if this occurs, the oil will smoke in the muffler the next time the engine is started. This is only temporary, the smoking will subside and soon stop.
Can you recycle used engine oil?
Briggs & Stratton has made recycling used engine oil even easier. You can recycle your used oil free of charge at any participating local Briggs & Stratton Dealer.
When to drain engine oil?
Drain the engine oil when the engine is warm, this allows the oil to suspend any internal debris in the oil and doing so will allow for impurities to drain, along with the oil.
What causes oil to wear?
Dirt and debris get into the oil and cause wear.
Who designed the EXI lawn mower?
So when they set out to imagine the next evolution of lawn mower engines, Briggs & Stratton designed the EXi from the ground up with easy maintenance in mind.
Does cooler oil last longer?
The oil that's in there will last longer. Cooler oil will take longer to break down. To keep the oil clean, Briggs turned to an automotive-style paper air filter in a tight, press-fit element to keep dirt out.
Do lawn mowers need oil changes?
A lawn mower that never needs an oil change. For the life of the engine, all you need to do check the oil level...and add as needed. No messy draining process, no oil disposal. Just...Check and add.
Can you change the oil on a lawn mower?
Since most engines don't have a drain plug anymore, changing your oil can be frustrating and messy: Tip the lawn mower over...oil misses the pan. Sometimes an oil change can do more bad than good, as well, when care is not taken to ensure dirt and other debris does not enter the engine.
Can you change the oil in a car?
Yes, you can still change the oil if you want to.
When To Change The Oil In on a Briggs & Stratton engine lawn mower
You will need to change the oil in your lawn mower engine every 25-30 hours of use. This is much more often than other engines, and it needs to be done because this type of engine uses a lot less oil than others.
How To Change The Oil In a Briggs & Stratton Engine Lawn Mower
Step one – Park or turn off your mower and allow it to cool down for at least an hour before beginning work on it. You don’t want to start messing with the engine while it’s still hot, because you could end up hurting yourself.
