Begin at one end of the panel, an inch down from the top of the rod pocket, and attach a clip to the back of the pocket at a chalk mark. The goal is for the clip not to be exposed when you turn the curtain over and hang it. Once all the ring clips are attached, slip the rings through the curtain rod and hang the curtains.
What is the best way to hang a curtain rod?
Ring Clips. One of the most popular methods for hanging drapery is ring clips which are clipped to the top edge of the drapery panel with rings sliding over the rod. You can use this method to hang any type of drapery panel, since you simply clip the ring to the panel.
How far apart do you put curtain clip rings?
The general guideline is to attach clips every 2 to 4 inches. The heavier the curtains, the closer you should attach the curtain clip rings. To attach curtain clip rings to rod pocket curtains: Remove the curtains from the curtain rod. Determine the number of clip rings per panel required by measuring the width of each panel.
What are curtain rings with clips attached?
Specialty curtain rings with clips attached allow you to hang any type of lightweight or medium-weight curtains from a curtain rod. Determine the number of curtain rings you have or want. A wider, heavier drapery style curtain requires more rings than a lightweight sheer curtain does.
Can curtain rods be used with pocket curtains?
Curtain rods can pose a problem if you plan to open the curtains on a regular basis. A solution to this problem is using curtain hooks ( drapery pins) or curtain clips with attached rings when hanging rod pocket curtains.
Can you use clips on rod pocket curtains?
Using curtain clip rings on rod pocket curtains allows for easy opening and closing. You can attach the clips in a manner that enhances how the curtain falls and looks. Keep in mind that attaching curtain rings using clips (or hooks) adds to the length of the curtains. Remove the curtains from the curtain rod.
How do you keep rod pocket curtains in place?
Purchase a new rod that extends approximately three-inches outside of both brackets. Hang your final curtain ring or tab outside of each bracket on the additional portion of the rod. When you pull your curtains, they will “catch” on the bracket to prevent the rod from sliding. Use a center bracket.
How do you attach curtain rings and hooks?
2:012:46Curtain Hooks and Rings - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis ring is for use with a round curtain rod to use them you simply clip the clasp to the top ofMoreThis ring is for use with a round curtain rod to use them you simply clip the clasp to the top of the curtain. Then slide the curtain rod through the ring.
How do you attach drapery hooks to rod pocket curtains?
If you don't want to use header tape, or don't have access to a sewing machine, simply slide your pinhooks up into the rod pocket. Space your pinhooks 4 inches to 6 inches apart for curtains that lie flat between the hooks and 7 inches to 12 inches apart for a swoop between pinhooks.
How do I keep my curtain rings from sliding?
Here are some of the best practices to keep your curtain rods from sliding.Extend the Curtain Rod. ... Strengthen the Rod. ... Hang Your Brackets Wide. ... Make Sure the Curtain Rod is the Right Size. ... Tighten the Screws. ... Use Rubber Bands. ... Duct Tape. ... Command Strips.
How do you keep pocket curtains from sliding on a rod?
Stick one side of a self-adhesive hook and loop tape dot on the back of a metal rod at the position of each inside edge when in the desired gathered position on stationary panels. Stick the other side of the dot to the inside of the rod pocket of the back side of the drape or the inside of the curtain ring.
How do you use drapery clips?
Start with a total of 9 rings. Unfold your curtain all the way and place a clip ring at either end, on the top edge of the panel. Fold your curtain in half so the two clip rings meet. Put a clip ring on the other end. Fold your curtain in half again, and place two clip rings on each fold at the other end.
How do you hang curtains with ring holes?
0:211:25How to hang an Eyelet curtain by Appletree Living - YouTubeYouTubeStart of suggested clipEnd of suggested clipIn first take the finial. Off next simply place the curtains onto the pole. The last eyelet on theMoreIn first take the finial. Off next simply place the curtains onto the pole. The last eyelet on the back edge must go over the bracket that then becomes the backstop. Once you've hung on the curtains.
What kind of curtains use clip rings?
You can use curtain clips to hang any type of drapery panel, since you simply clip the ring to the panel. If you want a little bit more length out of your panel, curtain clips are a great way to add 1-2 inches, since the clips means the fabric hangs just below the drapery rod.
How do you install drapery pins?
Drapery pins (figure A) are inserted into the back (lining side) of the panels. The sharp, pointed end goes into the fabric. Insert the straight end of the pin all the way until it looks like figure B. The curved end of the pin will go through the eyelet of your drapery ring or rod carrier.
How do curtain rings work?
But you may be wondering how exactly drapery rings work. It's actually quite simple. You just hang them from a metal pin that's in the back of the drapery. Some drapery rings also have built-in clips, allowing you to hang the drapes without needing to insert pins into the fabric.