Below are how-to instructions for Wet & Forget Outdoor Concentrate:
- First, clear the affected surface (s) of leaves and garden debris
- Mix Wet & Forget Outdoor Concentrate and water in a pump garden sprayer, in a 1 to 5 ratio. (1 part product to 5 parts water).
- Spray down your exterior surface with Wet & Forget. ...
- Walk away, and you’re done! ...
Do you have to dilute Wet and Forget?
Yes, Wet & Forget Ready-To-Use is pre-mixed so no water is needed and there's no rinsing after application.
How do you mix Wet and Forget it?
Wet & Forget's mixing ratio is 1 part Wet & Forget to 5 parts water. For a 1-Gallon sized garden pump sprayer, pour 20 oz (2.5 cups) of Wet & Forget into your sprayer. Next, fill the sprayer with water to the 1-Gallon marker and you're ready to go.
How long should Wet and Forget be applied before rain?
Wet & Forget takes 4 to 5 hours to dry, so check the weather forecast before you spray to ensure there's no rain, snow, or sleet heading your way. After Wet & Forget Outdoor dries, it teams up with the weather (rain, wind, sleet, snow) to eliminate nasty growths – no scrubbing required!
Is Wet and Forget just bleach?
Wet & Forget is non-acidic and contains no bleach; therefore it can be used on ANY outdoor surface material. Some of the more popular surfaces include: Roofs, Siding, Decks, Walkways, Driveways, Brick, RVs, and Boats.
How long do you leave Wet and Forget?
Spray your shower down with Wet & Forget Shower after you use the shower. The next day, simply rinse the surfaces clean with water before showering. Do this once each week to keep your shower spotless. For best results leave on surface 8-12 hours (but no more than 24 hours).
How long does Wet and Forget take?
approximately 2-3 monthsHow long Wet & Forget takes to work is totally dependent on the intensity of the contamination of mould, algae or lichen. For mild contaminations, results can be seen in days. For more stubborn infestations Wet & Forget can take approximately 2-3 months to see improvements.
Can you pressure wash after using Wet and Forget?
A: Yes, you can paint/stain surfaces after applying Spray & Forget on them. If you are in a hurry, simply pressure wash the surface after applying Spray & Forget to clean it.
Does Wet and Forget get rid of weeds?
Does Wet and Forget Kill Grass and Weeds? Wet and Forget is not a true herbicide. Though it does kill algae, moss, mold, and mildew, it does so in such a “light” way that most plants would be able to shrug off the damage.
What surfaces can you use Wet and Forget on?
Wet & Forget is non-acidic and contains no bleach; therefore it can be used on ANY outdoor surface material. Some of the more popular surfaces include: Roofs, Siding, Decks, Walkways, Driveways, Brick, RVs, and Boats.
What is the same as Wet and Forget?
Bio-Shield was tested and certified by two independent laboratories to have the same active ingredient as Wet and Forget.
What is the main ingredient in Wet and Forget?
Outdooris alkyl dimethyl benzyl ammonium chlorideThe active ingredient in Wet & Forget Outdooris alkyl dimethyl benzyl ammonium chloride. This ingredient is present in many common household sprays and in anti-bacterial wipes. Wet & Forget Outdoor doesn't contain harsh chemicals such as bleach, ammonia, sodium hydroxide, lye, or trisodium phosphate.
Does Wet and Forget clean mold?
Wet & Forget Outdoor removes moss, mold, mildew, and algae on exterior surfaces. It's a gentle cleaner that doesn't require any scrubbing, and its bleach-free formula is safe to use on all types of headstones.
Can Wet and Forget be used with a watering can?
Applying with a watering can? We do not recommend applying Wet & Forget with a watering can, it is a very wasteful and costly way of applying the product. It is far more effective to apply with a basic pump action garden sprayer, the product will go much further and a more even coverage achieved.
What surfaces can you use Wet and Forget on?
Wet & Forget is non-acidic and contains no bleach; therefore it can be used on ANY outdoor surface material. Some of the more popular surfaces include: Roofs, Siding, Decks, Walkways, Driveways, Brick, RVs, and Boats.
Is Wet and Forget better than bleach?
Bleach is a real hassle to use, encourages moss, algae, lichen or mold and mildew to grow right back, and can even harm the surface you're trying to clean. Wet & Forget Outdoor beats bleach and eliminates even the toughest growths with no scrubbing, and keeps them clean for a year or more in most cases.
Does Wet and Forget get rid of weeds?
Does Wet and Forget Kill Grass and Weeds? Wet and Forget is not a true herbicide. Though it does kill algae, moss, mold, and mildew, it does so in such a “light” way that most plants would be able to shrug off the damage.
How to apply wet and forget?
Applying Wet & Forget is quick and easy. Just mix with water and apply with a tank sprayer. That's it! Wet & Forget goes to work on contact cleaning the surface. Check out our video on how to mix Wet & Forget along with a few applications to different surfaces. Wet & Forget has an unlimited shelf life, and it can be safely stored pre-mixed in the sprayer until your next application!
Where Can I Use Wet & Forget Outdoor?
Bleach and many other outdoor cleaners are highly caustic and can potentially corrode and discolor outdoor surfaces. Wet & Forget's gentle, nearly pH-neutral formula is bleach-free and safe to use on virtually any outdoor surface.
How long does it take for algae to clean?
Reaction Time: Once treated with Wet & Forget, green growths such as algae will clean up within a few days or weeks in most cases. Black stains caused by mold and mildew can take a month, sometimes several months. Worse-case scenario, heavy black stains that have built-up for many years can take six months - 1 year to come clean. Be Patient. Good Things Take Time.
What is the pH of wet and forget?
Wet & Forget Outdoor has a pH level of 8, while pure water has a pH of 7. Most products on the market have a pH level of 10-13, which is 100 – 10,000 times more alkyl than Wet & Forget Outdoor. Application: Apply Wet & Forget Outdoor to a DRY outdoor surface until thoroughly saturated.
How long does wet and forget last?
Wet & Forget's gentle cleaning action uses the wind and rain to continue working overtime; it keeps ugly stains at bay for a year or more on most surfaces.
How to get rid of black and green stains?
Are you tired of the never-ending cycle of cleaning black and green stains from your home? Introducing the easiest solution for eliminating these issues without using elbow grease or harsh chemicals —Wet & Forget Outdoor Cleaner! Simply spray and walk away! That's it. Wet & Forget goes to work with the wind and rain to gently clean the surface over time.
Can wet forget concentrate be used as a refill?
Wet & Forget Concentrate is a different dilution rate than Wet & Forget Xtreme Reach™ Hose End, it cannot be used as a refill for the hose end.
How much water does wet and forget save?
The Verdict: Using Wet & Forget to clean our surface instead of power washing will save well over 100 gallons of water.
Is wet and forget corrosive?
Something you may not know about Wet & Forget, the ultimate outdoor moss, mold, mildew and algae cleaner, is that it’s non-caustic and non-corrosive due to its neutral pH of 8. In this way, Wet & Forget does its job while being gentle on the surrounding environment.
When to apply wet and forget?
Apply Wet and Forget on a cool and dry day with minimal wind. Make sure there is no rain in the forecast for 4-5 hours. Typically, the evening or early morning is the best time to apply because evaporation is minimal. This way, the treated surface stays wet with Wet & Forget for a longer period. Apply Wet & Forget Outdoor Concentrate and Wet & Forget Ready-To-Use when temperatures are above 32 degrees. Apply Wet & Forget Extreme Reach™ Hose End when temperatures are above 55 degrees.
How long does it take for wet and forget to dry?
Keep pets off the surface applied to until it is dry to ensure they don’t ingest any of the Wet & Forget. Wet & Forget will take 4-5 hours to dry completely. If they accidentally walk in the treated area while wet, rinse your pet’s paws with fresh water as a precaution. Wet & Forget is safe for pets if it rains after the dry time.
Can wet and forget indoors be used indoors?
For indoor use, we recommend using Wet & Forget Indoor Mold+Mildew Disinfectant Cleaner.
Does wet and forget etch glass?
No, Wet & Forget will not etch the glass in windows. However, Wet & Forget may leave a residue on the glass. After the Wet & Forget has dried, you can wash the glass portion of the window with glass cleaner to remove any residue.
Can you use Wet and Forget Outdoor?
You can use Wet & Forget Outdoor on any outside surface, including: Driveways and Walkways, Patios, Pool Surrounds, Fiberglass, Bricks, Painted or Textured Surfaces, Tombstones and Grave Markers, Natural Stone, Ceramic Pots, Decks, AstroTurf, Tennis Courts, Canvas Awnings, Greenhouses, Boats, RV’s, Gutters, Siding (Vinyl, Aluminum and Wood and Stucco) and Roofs (Asphalt and Fiberglass, Steel, Clay, Shake and Tile).
Is wet and forget bleach free?
Wet & Forget has an unlimited shelf life. It is bleach-free and non-acidic. Wet & Forget can be stored in the original bottle as a concentrate or as a dilution in your garden sprayer. The product will not deteriorate after being diluted nor damage your garden sprayer. Always keep the cap tightly fastened and the product out of the reach of children.
Can you use Wet and Forget Outdoor Concentrate with a pressure washer?
We recommend applying Wet & Forget Outdoor Concentrate with a pump-up garden sprayer for best results. For large surfaces and high elevations, we recommend using Wet & Forget Xtreme Reach™ Hose End. NOTE: Most standard hose end sprayers do not have the correct dilution rate for Wet & Forget. If you use a pressure washer with Wet & Forget Outdoor Concentrate, only use pressure washers that can pull from a separate container with the pre-mixed solution of 5:1 otherwise, we do not recommend pressure washers as you will not get the proper dilution or results.
What is the pH of moss removal?
Most moss, mold and mildew removal products are either highly acidic (with a pH of roughly 1) or highly caustic (pH of around 12). Also, these products may be able to remove as much as you’d like them to remove, but they can easily damage the surface you’re trying to clean in the first place.
Is wet and forget good for moss?
It’s pretty well known that Wet & Forget is an amazingly effective moss, mold and mildew stain remover that requires very little work on your part. But what you may not know is just how gentle Wet & Forget is on the surfaces you apply it on.
Is wet and forget safe?
With a pH of 8, Wet & Forget is close to neutral. This means Wet & Forget is very gentle and safe to apply to any surface. It will remove moss, mold and mildew stains and leave your surfaces untouched.
When to apply Wet and Forget?
Apply Wet & Forget on a cool, windless day, with no rain in the forecast for 4-5 hours after application. Usually, the evening or early morning is the best time to apply; when evaporation is minimal. You want the treated surface to stay wet long enough for the product to properly treat the surface. Apply Wet & Forget Xtreme Reach™ Hose End at any temperature above 55 degrees.
What is a wet and forget hose end?
Wet & Forget Xtreme Reach™ Hose End should be used to treat large surfaces and high elevations. Wet & Forget Ready-to-Use should be used on small surfaces such as a planter, steps, or patio umbrellas. Wet & Forget Ready-to-Use is premixed with water and comes with a hand sprayer to apply to small surfaces.
How much coverage does wet and forget have?
For example, porous surfaces will readily absorb the product, and painted surfaces will use less product. On average you can expect 2,000 sq. ft. coverage from a 48oz. Xtreme Reach™ Hose End container.
How long does it take for a tree to decompose?
Thoroughly saturate the surface with Wet & Forget on a cool, dry day. Late in the day is best. Leave the growth to start decomposing for 2-3 weeks (the longer, the better). Once the surface has fully cleaned up, you can paint or stain the surface. If you would like to speed up the cleaning process, feel free to gently pressure wash the dead growth and left-over stains that the rain hasn't cleaned yet.
Does wet and forget etch glass?
No, Wet & Forget is a gentle product and will not etch the glass in windows. However, Wet & Forget may leave a residue on the glass. After application, turn the Xtreme Reach™ Hose End to the water setting and rinse off any windows that have overspray. You can also wash the windows with glass cleaner to remove any residue.
Can you use Wet and Forget on pets?
If they accidentally walk in the treated area while wet, rinse your pet's paws with fresh water as a precaution. Wet & Forget does not reactivate with rain therefore the surface is safe for pets after the first initial dry time.
Can you use Wet and Forget hose end on asphalt?
Yes, you can use Wet & Forget Xtreme Reach™ Hose End on any outdoor material. Clean brick, vinyl, asphalt, rubber or any other surface. The hose end product is best suited for large surfaces and high elevations. The hose end is ideal for quickly cleaning roofs, siding or large patios.
