Place the end of the lower radiator hose into an approved catch can container. Clamp the heater hose between the flushing T and the heater core. This allows you to back flush through the engine block. Turn on the water supply and start flushing the fluid until it runs clear.
Full Answer
How to drain the radiator on a Dodge Ram?
Locate the radiator's drain valve on the bottom of the radiator. You don't need to raise the Dodge Ram since it's a high truck with enough room for this job. Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it's empty.
How do you empty the coolant from the radiator?
Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it's empty. Figure 2. Loosen the radiator drain valve and drain the coolant. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water.
What does a radiator flush do on a Dodge Ram?
The radiator is designed to keep the Dodge Ram's monstrous engine cool. It circulates coolant through the engine to ensure it stays cool under any driving condition. After a while, rust and deposits start building up inside the radiator. Flushing the system ensures it stays lubricated, rust free,...
How to clean the radiator on a Toyota Corolla?
After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator.
How do you drain the radiator on a Dodge Ram 1500?
2:3010:28How To Drain & Fill Coolant + Thermostat - Chrysler 4.7L (Dakota ...YouTubeStart of suggested clipEnd of suggested clipAnd turn it counterclockwise. It's hard to do with just one hand. So you turn it counterclockwise itMoreAnd turn it counterclockwise. It's hard to do with just one hand. So you turn it counterclockwise it'll get you right there it won't turn any further than that at which point you need to pull.
How do you change the antifreeze in a Dodge Ram 1500?
0:494:54RAM 1500 Coolant Flush Replacement - 2009 to 2018YouTubeStart of suggested clipEnd of suggested clipSo I'm gonna go ahead and show you just how easy it is to replace the coolant on these trucks. RightMoreSo I'm gonna go ahead and show you just how easy it is to replace the coolant on these trucks. Right now but on the bottom of the thermistor. Radiator here you'll see this drain plug.
How do you flush a radiator step by step?
How to Perform a Radiator FlushStep 1: Let engine cool completely. ... Step 2: Find and remove your fill cap. ... Step 3: Locate the petcock. ... Step 4: Let the old fluid drain. ... Step 5: Recycle old antifreeze. ... Step 6: Add radiator cleaner and water. ... Step 7: Start your vehicle. ... Step 8: Drain the system.More items...
How do you bleed the cooling system on a Dodge Ram 1500?
1:109:53More than one way to bleed a Hemi coolant system - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow in that first video we talked about having to use an Allen wrench to actually get into the portMoreNow in that first video we talked about having to use an Allen wrench to actually get into the port or that bleeder and back it off to get the air out.
What color antifreeze does Dodge Ram use?
What color coolant does 2017 Ram 1500 use? It's giant to understand that color doesn't matter. While most Organic Acid Technology (OAT) coolants are generally orange, yellow, red or purple, Hybrid Organic Acid Technology (HOAT) coolants are orange and yellow.
What coolant should I use in Ram 1500?
2013 - 2021 Ram 1500 Classic 5.7L V8 uses MS. 90032 OAT coolant antifreeze. 2019 - 2022 Ram 1500 5.7L V8 uses MS. 90032 OAT coolant antifreeze.
What is the best thing to use to flush a radiator?
Mix baking soda with water. You'll want approximately 5 teaspoons of baking soda per 1 litre of water. Add the solution to your cooling system and run the engine until it's hot. Drain the system before flushing it again with distilled water.
Can a radiator flush cause problems?
Can a radiator flush cause problems? Yes and no. Yes, because a radiator flush is going to flush out any corrosion, debris, rust, and other contaminants. If the flush isn't thoroughly to clear all of that out, it can loosen up those things which could clog up the cooling system, including the radiator.
What is best radiator flush?
Editor's Pick: Prestone Radiator Flush and Cleaner. ... Best Radiator Coolant Additive: Royal Purple Purple Ice Super Coolant. ... Best Flush for Diesel Engines: Liqui Moly Radiator Cleaner. ... Best for Oil-Based Cooling System: Irontite Thoroflush Radiator Flush. ... Best to Stop Leaks: Bar's Leaks 10-Minute Radiator Flush.
How do you burp a Dodge Ram 1500?
0:232:48Clearing the Cooling System of Air. 'Burping' the Radiator. Jeep.YouTubeStart of suggested clipEnd of suggested clipBasically how you do it is take off the radiator cap. And then tilt the vehicle. So it's up on up onMoreBasically how you do it is take off the radiator cap. And then tilt the vehicle. So it's up on up on jack stands.
How do you bleed the radiator on a Dodge Ram?
12:1826:58Dodge Ram Hemi 5.7 Thermostat Mod | Coolant Flush Bleed & TrickYouTubeStart of suggested clipEnd of suggested clipInto this upper radiator hose into the radiator. And also remember that radiator upper radiator hoseMoreInto this upper radiator hose into the radiator. And also remember that radiator upper radiator hose end is lower than this neck and i've got the funnel with the additional water in the funnel.
Will cooling system bleed itself?
Will a cooling system bleed itself? Your coolant system can bleed some between the overflow tank and thermostat. However, to properly bleed, you need to fill the coolant and run the car with the radiator cap off.
How do you burp the cooling system on a Dodge Ram?
0:132:31How to Properly Bleed Engine Cooling System by yourselfYouTubeStart of suggested clipEnd of suggested clipIf your systems been drained you've already got your radiator cap off.MoreIf your systems been drained you've already got your radiator cap off.
How do you drain the coolant reservoir on a Dodge Ram?
0:1114:39How to Replace Coolant Reservoir 2013-2018 Dodge Ram 1500YouTubeStart of suggested clipEnd of suggested clipAnd you're going to find the overflow hose for that you can either use a socket or a flatheadMoreAnd you're going to find the overflow hose for that you can either use a socket or a flathead screwdriver.
How do you burp a Dodge Ram 1500?
0:232:48Clearing the Cooling System of Air. 'Burping' the Radiator. Jeep.YouTubeStart of suggested clipEnd of suggested clipBasically how you do it is take off the radiator cap. And then tilt the vehicle. So it's up on up onMoreBasically how you do it is take off the radiator cap. And then tilt the vehicle. So it's up on up on jack stands.
How do you bleed the radiator on a Dodge Ram?
12:1826:58Dodge Ram Hemi 5.7 Thermostat Mod | Coolant Flush Bleed & TrickYouTubeStart of suggested clipEnd of suggested clipInto this upper radiator hose into the radiator. And also remember that radiator upper radiator hoseMoreInto this upper radiator hose into the radiator. And also remember that radiator upper radiator hose end is lower than this neck and i've got the funnel with the additional water in the funnel.