how do you install a floor plug

• If you have carpeting, cut an opening in the carpeting and padding to access the wood subfloor. ...
• Use a power drill to drill a hole in the flooring and subfloor. Use a hole saw sized according to the instructions that come with the kit. ...
• Run wiring for a new circuit or circuit extension from the source (circuit breaker panel or an existing outlet on the circuit) to the floor box location. ...
• Pull the two-wire (plus ground) NM cable up through the floor opening.
• Feed the end of the cable into the bottom of the floor box or tube. ...
• Connect the NM cable conductors to the receptacle—white wire to neutral (silver-colored screw terminal), black wire to hot (brass- or copper-colored) screw terminal), and the bare copper ground wire to ...
Tighten the wire clamp holding the cable in the box. (With the Thomas & Betts model, this involves simply closing the bottom of the tube.) Insert box down through the ...
Fasten the cover plate to the floor, using the provided mounting screws.
Connect the new NM cable to the circuit breaker panel or to the source outlet being used to feed the new extension. ...
Turn the power to the circuit back on and test the new floor outlet for proper operation.

Full Answer

How do you install electrical outlets on a carpeted floor?

For outlet installations on carpeted floors, the top edge of the outlet box must be flush with the carpet. Flipping the outlet ears over before mounting the box is one easy way to accomplish this.

How do you drill a hole in the floor to install outlets?

Use heat vents, cable or plumbing pipes that penetrate the floor and are visible from below as reference points. Drill a small hole through the floor (Photo 1) where you intend to place the outlet and locate the bit from the open ceiling below. If you drilled directly over a joist, you won’t be able to see the bit.

Can you plug a lamp into a floor outlet?

Sometimes electricity is just not where you need it, especially in big rooms and in older houses. A floor outlet may be the perfect way to solve the problem. Until someone comes up with a better idea, we’re stuck with plugging lamps into outlets to get light. But what if you want a lamp in the middle of the room where there’s no outlet?

Where does the plug go on a rug?

With each of these scenarios, the plug sits in the outlet underneath the rug and only a very small section of the cord is slightly visible. Most floor outlets have deep recessed sockets, so the plug itself doesn't sit above the finished floor level and therefore doesn't interfere with the rug's placement.

How do you wire a floor plug?

Connect the bare ground wire to the metal box by looping it once in a clockwise direction around the green grounding screw and tightening the screw. Loop the end of the same bare grounding wire clockwise around the grounding screw on the receptacle and tighten the screw.

Are floor outlets a good idea?

It is a good idea to use floor outlets to meet all electrical needs in open spaces since they can power several devices – TV sets, sound systems, and lighting fixtures. If you consider the holidays, having an extra outlet will be very helpful when it comes to lighting up Christmas lights, etc.

How do you install concrete floor plugs?

1:025:08Concrete Floor Box Installation | Leviton - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd power conduit to the power conduit entry. If you need to split power conduit. Use the Y adapterMoreAnd power conduit to the power conduit entry. If you need to split power conduit. Use the Y adapter by connecting it directly to the reducer. Next place your low voltage divider.

How do floor outlets work?

Floor outlets are electrical outlets that are installed into a floor area rather than into a wall. Often, a floor outlet will be equipped with a metal plate to protect the outlet and wiring, along with a cover that prevents dust and other material from collecting in the outlet when the device is not in use.

Are floor outlets legal?

The NEC now requires floor receptacle outlets, based on open floor space, for meeting rooms that are at least 12 feet wide and have a floor area of at least 215 square feet. Additionally, the code requires at least one receptacle for each 215 square feet of floor space or major portion thereof.

Can I put furniture over a floor outlet?

This is so that you can call attention to the area and help people to avoid tripping over the mat or the raised portion of the outlet. Leave Some Space - If you plan to cover your floor outlets with furniture when the outlets aren't in use, always leave at least three inches of space above the outlet's opening.

Where should I put my floor outlet?

somewhere along the line of the edge of the rug, between the end table and sofa end of your furniture layout makes sense if you only get one floor plug.

What is a poke through floor box?

Leviton's poke-through floor box system accommodates standard or Decora™ single or duplex receptacles, as well as Lev-Lok and QuickPort® inserts. Unlevel Floors Are No Problem. A two-piece construction allows for self-leveling up to four degrees, eliminating tripping hazards and unpleasant appearences.

How do you install a floor box kit?

3:205:37Floor Box Assembly for residential wood floor construction - YouTubeYouTubeStart of suggested clipEnd of suggested clipBring the electrical cable through the preferred box clamp and place the Box down in the hole. AndMoreBring the electrical cable through the preferred box clamp and place the Box down in the hole. And secure with the preferred mounting method. Once the device has been wired.

What is a floor plug?

Definition of floor plug : an electrical receptacle with its face flush with or recessed in a floor.

How do you put a floor plug under a rug?

The proper way to use a floor outlet is to have a cutout in the carpet around the outlet, and ideally a cover on the outlet when it is not in use to avoid dirt (or even worse, spilled drinks) getting into the outlet.

How much does it cost to put an outlet in the floor?

Expect to pay around $125 to $175 to replace or install a standard outlet. The national average can run anywhere from $100 to $500 per outlet depending on the complexity of the job.

Why are floor outlets expensive?

Many people think that floor boxes are more expensive to install. Strictly speaking, this is not true; the cost of putting in one fixture or the other is generally the same. However, it is true that floor boxes will sometimes require more wiring and thus drive up costs a little.

Where should I put my floor outlet?

somewhere along the line of the edge of the rug, between the end table and sofa end of your furniture layout makes sense if you only get one floor plug.

How much does it cost to put an outlet in the floor?

Expect to pay around $125 to $175 to replace or install a standard outlet. The national average can run anywhere from $100 to $500 per outlet depending on the complexity of the job.

What are floor plugs?

Definition of floor plug : an electrical receptacle with its face flush with or recessed in a floor.

How to test a receptacle?

Put the receptacle's faceplate on and tighten the screws. Turn on the circuit breaker. Plug an appliance or an electrical device into the receptacle to test your installation.

What type of outlet do I need for a floor outlet?

Determine which type of electrical outlet you need for your floor outlet. Electrical code requires that your floor outlet be a ground-fault circuit interrupter (GFCI) receptacle if it will be installed in a garage, bathroom, or outside. They are also recommended for damp locations.

How to strip plastic insulation?

Use a wire stripper to strip a short length of plastic insulation from each end of the three wires at the end of the 14/2 cable. There should be enough bare metal wire protruding to wrap around the terminal screws.

Can you put an electrical outlet in the wall?

Sometimes an electrical outlet in the wall isn't quite right for your electrical needs, and you need an electrical appliance or device plugged in to a floor outlet. This can occur more often in older homes, which were built in an era when there weren't so many electrical appliances and devices available. Although you could reach for that power extension cable, you can remedy the situation by installing an floor electrical outlet yourself.

Is AC voltage dangerous?

Make sure there is no voltage present when you're doing your installation. AC voltage is very dangerous.

Who is Doug Hewitt?

Doug Hewitt has been writing for over 20 years and has a Master of Arts from University of North Carolina-Greensboro. He authored the book "The Practical Guide to Weekend Parenting," which includes health and fitness hints for parents. He and his wife, Robin, are coauthors of the "Free College Resource Book."

How to remove a junction box?

Turn off the electricity at the main circuit breaker for the circuit that controls the junction box. Loosen the screws holding the cover of the junction box in place with a screwdriver and remove.

How to cut off conduit?

Measure out the distance between the junction box and the outlet. Use a pair of snips to cut off the same amount of conduit.

Where is the junction box for an electric outlet?

Locate the nearest junction box where you will be connecting the new electric outlet. Junction boxes are about 4 inches square and usually mounted on the outside of the wall in concrete areas, such as basements.

Where did Nathan McGinty get his degree?

Nathan McGinty started writing in 1995. He has a Bachelor of Science in communications from the University of Texas at Austin and a Master of Arts in international journalism from City University, London. He has worked in the technology industry for more than 20 years, in positions ranging from tech support to marketing.

Can you put an outlet in concrete?

A nice thing about being a homeowner is the ability to add improvements where you see fit. This can include just about anything, including installing an electrical outlet in a concrete floor. The challenging part of this project isn't the wiring, but having to cut through the concrete. But, with the right tools and safety precautions, the job can be completed by the determined DIYer.

Where do I put electric floor plugs in living room?

We have a big open floor plan in main living space that will contain the kitchen, living and dining area. See attached picture

How many blocks are there in a 3x3 recliner?

We have two 3x3' recliners with 2x2' table between and one 6'x3' love seat. So our furniture basically makes two blocks --- a block of 8'x3' (recliners and table) and a block of 6'x3' (loveseat)

When do floor plugs have to be set?

The floor plugs have to be set when the foundation for house is poured, so our decision must be made soon.

Can you put a cover over a recliner?

Then I would play around with it some more and consider putting more in for future furniture arrangements. If you are going to have wood flooring you could put a cover over the ones not in use. Also, keep in mind that the plug will stick upwards so you want to make sure that if a plug ends up under the recliner that its movement won't interfere with the plug.

Can you put outlets in the floor?

Of course you may put outlets in the floor and place an area rug on top.