To install a tetherball pole in the ground:
- You will need to dig a 2 foot deep hole in the ground about a foot wide in diameter.
- Set the tetherball pole in the ground, and mix up a bag of concrete.
- Pour in the concrete and hold the pole level until the concrete sets enough to keep the pole upright.
- Let the concrete set overnight
How to install a tetherball pole in concrete?
Set the Tetherball Pole in the Concrete 1 Mix your concrete according to the directions on the bag, using your bucket or another suitable container. 2 It’s not necessary to mix it all at the same time. 3 When it’s ready, place your pole centered in the tire or hole and start to fill around it with concrete.
How do you set up a tetherball set?
Most tetherball sets come with a pole and rope of lengths that work together. If you’re piecing a set together yourself, you’ll want to set the pole up first. Then, let the ball hang on its own and make adjustments to the rope length from there.
How do you make a tetherball out of a tire?
If using the tire to create a movable tetherball, lay the tire flat on the ground. Mix the cement according to the directions on the package, using the bucket and water. You will need a few helpers to hold the pole in place while you pour the cement either into the hole or the tire, but over the rebar.
How high should a tetherball ball be off the ground?
In either case, the rope is usually cut so the ball will hang 2 feet above the ground on any pole. A typical permanent tetherball pole will be 2 and 3/8 inches in diameter. A heavy duty permanent set may even be up to 3 inches in diameter, mostly used in parks or playgrounds.
How do you attach a tetherball pole to ground sleeve?
0:212:20EastPoint® Sports Platinum Tetherball Set - Assembly Video - YouTubeYouTubeStart of suggested clipEnd of suggested clipInto the top of the pole. Going all the way through the two holes. Then secure your eye bolt. WithMoreInto the top of the pole. Going all the way through the two holes. Then secure your eye bolt. With the wing nut. You're just going to twist that on you're gonna hand tighten it.
How much concrete do I need for a tether pole?
Materials Required:1-½-inch galvanized steel pipe of desired height plus 2 feet.Rebar – 2 pieces, 12 inches long.Concrete – 180 lbs.Eyebolt with washer and hex nut.Safety wire.Tetherball with rope (link to Amazon)Connecting hook for rope.
How high should a tetherball pole be?
The pole is often 10 feet (3.0 m) high, and can be as low as 7 feet (2.1 m) high depending upon the height of the players.
How do you set up a tetherball set?
Step 1: Paint Tire. Make sure that your tire is clean and dry. ... Step 2: Drill Pipe for Rebar. ... Step 3: Prep for Concrete. ... Step 4: Add Concrete and Level Pole. ... Step 5: Add Decorative Stones. ... Step 6: Install Eye Bolt Into Cap Piece. ... Step 7: Hang the Ball. ... Step 8: Play.
How do you attach a tetherball pole to concrete?
You will need to dig a 2 foot deep hole in the ground about a foot wide in diameter. Set the tetherball pole in the ground, and mix up a bag of concrete. Pour in the concrete and hold the pole level until the concrete sets enough to keep the pole upright. Let the concrete set overnight.
What kind of rope is used for tetherball?
nylonTachikara T-Rope is a tetherball attachment rope made of nylon and measures 9.84 feet. Clip attaches to all standard tetherballs and poles.
How long should a tetherball pole be?
A tetherball pole can be as small as 7 feet, depending on the size of the players. Typically adults will play on a 10 foot pole, and you'd see the 7 or 8 foot poles on school playgrounds.
What can I use for a tetherball pole?
0:152:56Tether Ball Pole and Stand - DIY with a spare tire - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the basically takes a eight foot chain like fence post and i actually have one of the line capsMoreSo the basically takes a eight foot chain like fence post and i actually have one of the line caps and i use a line pole there so you can actually see the line cap right here. And you need a
How long should the tether ball rope be?
The length of the tetherball rope must sit 2-feet above the ground. The standard pole length for tetherball should be 10-feet above the ground. This means that the average tetherball rope should be around 8-feet in length.
How much space do you need for a tether ball?
Find a flat open playing area at least 20ft (6.1m) square. For best results many people prefer to anchor the tetherball pole and sleeve to the ground with cement.
Tetherball Pole Regulations | SportsRec
What Is the Height of a Tetherball Pole? - Reference.com
Where should a tetherball pole be located?
The pole for the game should be located several feet away from any other obstacle, wall or building. This will ensure that there's plenty of room for the ball to swing, regardless of how long the rope is, and that the ball won't hit any objects if it does swing too high.
How to play tetherball on a pole?
Once the cement dries, attach the tetherball and rope to the top of the pole using the mounting clip. Make sure that the rope is as long or as short as you'd like so that it doesn't drag the ball on the ground or hit any other items in the area. Figure out how far away you'll stand to play the game, then use the shovel to completely level out the area around the pole to that distance.
Can you use a shovel to level a tetherball?
Use the shovel to approximate a level area in which to play. It doesn' t have to be entirely level yet , as you'll return to this project after the pole is mounted . However, having a level base for the tetherball area makes it easier to install the pole.
Is a tetherball pole a good thing?
A tetherball pole is a great item to install in your yard or elsewhere on your property if you have children. Tetherball is an easy game and a fun activity for children to enjoy when the weather is nice outside. A tetherball pole is also easy to install and takes up very little space. It requires very little maintenance and is inexpensive to build. Read on for a brief guide on how to install a tetherball pole properly.
How to play tetherball?
Tetherball is a game for two players that is played with a ball attached to a string that is attached to the top of a pole. Players stand on opposite sides of the pole and hit the ball back and forth. The goal is to get the other player to miss the ball and have the string wrap around the pole in the direction you are hitting. The game ends when the string has wrapped around the pole so many times that the ball is snug to the pole. Since the pole must be sturdy and anchored strongly enough into the ground to withstand the swinging of the ball, you must know how to install a tetherball pole.
How far off the ground should a tetherball be?
Attach the tetherball to the top of the pole with the clip. The ball must hang three to four inches off the ground.
How deep should a post hole be?
Use the post hole digger to dig a hole about two feet deep.
How to fill a hole in a cement bag?
Mix the cement with water (follow instructions on the bag) and pour in the hole until about half of it is filled.
What is the official height of a tetherball pole?
Tetherballs usually have a bar recessed in the top that the rope is tied to. Some simply have loops that protrude out, but this is less common as striking the loop with the hand can be painful. The pole is often 10 feet (3.0 m) high, and can be as low as 7 feet (2.1 m) high depending upon the height of the players.
How much space do you need for tetherball?
You ‘ll need a clear space of about 100 square feet to play tetherball. It doesn’t matter if it’s paved or grass, as long as it’s level. Once you ‘ve chosen your space, you ‘ll need to draw a circle on the ground of approximately 10 feet in diameter.
Who invented tetherball?
Tetherball was invented in Britain by at least as early as 1875. It may have been invented in Ireland, where some lucky, young Dubliner could have received a set for Christmas in 1875. Freeman’s Journal, ( Dublin, Ireland ), December 7, 1875, page 5.
How do you win tetherball?
To win a game of tetherball, you’ll need to wrap the ball around the pole until you run out of rope. Your opponent will be trying to wrap the ball around in the opposite direction as you. So you’ll need to undo their wrappings, or not allow your opponent to wrap the ball in their direction.
Can you catch the ball in tetherball?
Players are not allowed to touch the pole or the rope at any point during a tetherball game. Crossing over the line that defines a player’s territory is considered offsides. Throwing the ball is not allowed, and all strikes must bounce off the hands or forearms.
How do you cement a tetherball pole in a tire?
Drill holes into one of the ends of your line pole, in a cross pattern.
What is the official height of a tetherball pole?
Tetherballs usually have a bar recessed in the top that the rope is tied to. Some simply have loops that protrude out, but this is less common as striking the loop with the hand can be painful. The pole is often 10 feet (3.0 m) high, and can be as low as 7 feet (2.1 m) high depending upon the height of the players.
How much space do you need for tetherball?
You ‘ll need a clear space of about 100 square feet to play tetherball. It doesn’t matter if it’s paved or grass, as long as it’s level. Once you ‘ve chosen your space, you ‘ll need to draw a circle on the ground of approximately 10 feet in diameter.
Can you catch the ball in tetherball?
Players are not allowed to touch the pole or the rope at any point during a tetherball game. Crossing over the line that defines a player’s territory is considered offsides. Throwing the ball is not allowed, and all strikes must bounce off the hands or forearms.
Who invented tetherball?
Tetherball was invented in Britain by at least as early as 1875. It may have been invented in Ireland, where some lucky, young Dubliner could have received a set for Christmas in 1875. Freeman’s Journal, ( Dublin, Ireland ), December 7, 1875, page 5.
Is tetherball dangerous?
The issues that come with these tetherball poles is that children can be hit at high speeds by the ball or the rope, causing a variety of injuries and even knocking players onto the ground.
How to mount a tetherball to a pole?
To mount the tetherball to the top of the pole, it is necessary to drill a hole in your galvanized steel pipe to hold an eyebolt. The loop of the eye bolt will be where the tetherball rope attaches to the pole.
How to make a tetherball set?
1. Plan the Pole’s Location, Height & Mounting Type. Before you purchase any materials to make your tetherball set, think about the location you’ll use for playing. Make sure there is enough room for the ball to swing around freely, plus plenty of space for players on both sides to move around.
What are the concerns with tetherball sets?
Stability and strength are also concerns with tetherball sets you can purchase.
How much space do you need to play tetherball?
We recommend at least 100 square feet of open space to play tetherball, on level ground with no tripping hazards. An official tetherball court is a 20 foot diameter circle. When deciding on the height of your tetherball pole, it will depend mainly on who will be playing most often.
What is a tetherball?
You can think of a tetherball as being quite similar to a volleyball, except it’s attached to a rope. Both types of ball are meant to be hit with any part of the hand, although a tetherball tends to be a bit harder; they are made of soft rubber material and feel similar to a soccer ball.
How high should a baseball pole be?
Regardless of how high the pole is, the ball should be hung so that it is 2 feet above the ground. The pole will need to be mounted into something sturdy to keep it from moving around, even if players put a lot of strength into hitting the ball.
Why do players use internal attachments?
The internal type of attachment is generally preferable for most players since they prevent accidental injury that might result from the player hitting the loop on their hands or arm. Also, they’re less likely to break at the attachment point since the ball surface protects it.
How to attach a tetherball to a pole?
Push the eye bolt through the steel pole at the first end you drilled to make sure it fits. Use a washer and nut on each side to ensure the eye bolt stays in place . This is where you will attach your tetherball at the very end of this process.
How long should a galvanized pole be?
Your galvanized steel pole should be 8 feet long. Drill holes into both ends before even thinking about putting it in cement. Drill a hole about an inch and a half from one end, straight through the pole where the eye bolt will go. This requires two holes in a straight line, so make sure to just keep drilling straight through to the second side.
Can you set up a tetherball pole in your backyard?
There are a couple different ways to create a tetherball pole, depending on whether you want one that’s permanent or one that can be moved around the yard. You only need a few items to get started, and the next thing you’ll know, you have your own tetherball set that doesn’t take a big chunk out of your wallet.
