How to Install Beadboard Ceiling over Popcorn
- Prime both sides of each piece of beadboard paneling you will install.
- Run a stud finder across the ceiling to locate the joists.
- Place the first board in place on the ceiling, up against a wall.
- Nail the beadboard to the joists by driving the nails at an angle through the tongue portion of the boards; the tongue should be facing away from the wall.
How do you cover a popcorn ceiling with beadboard?
Covering a popcorn ceiling with classic beadboard paneling can instantly transform the look of the entire room from dated to timeless. Prime both sides of each piece of beadboard paneling you will install. Priming both sides helps prevent moisture from seeping through the boards in the event of a leak.
How do you install beadboard ceiling boards?
Place the first board in place on the ceiling, up against a wall. Use a laser level to check that the board is parallel to the wall across the room. If it isn't, adjust the board slightly until it is - any gap will be hidden on the where the beadboard meets the wall with molding. 4. Nail the Board to the Joists
How do you attach beadboard to joists?
Nail the beadboard to the joists by driving the nails at an angle through the tongue portion of the boards; the tongue should be facing away from the wall, reveals Kelly Concepts. The joists typically are located every 16 inches (some are spaced 24 inches apart), so the nails must be 16 inches apart.
How to add trim to ceiling joists?
If you can identify the ceiling joists (by knocking) be sure to pop some nails in there, too. Repeat until all the ceiling is covered. Add trim.
What is the best way to cover popcorn ceilings?
Why do you have to leave popcorn ceilings?
Can you paint beadboard before installation?
About this website
Can I put paneling over popcorn ceiling?
Since you have textured popcorn ceilings, the surface would be too uneven to just put paneling on top of it. You could go to the trouble of removing all the texture first, but a simpler method would be to put furring strips (made from 1×3 or 1×4 boards) on the ceiling, then attach the paneling to them.
What is the best way to cover popcorn ceilings?
There are three popular options for covering over the ceiling: covering them with ordinary drywall; using a prefinished grid-plank system such as Armstrong's Easy-Up grid system, or attaching furring strips then installing traditional tongue-and-groove planks or beadboard paneling on the ceiling.
What is the cheapest way to cover a popcorn ceiling?
The process of smoothing out popcorn ceiling using more plaster/drywall is the cheapest option when it comes to covering your popcorn ceiling since all you need is joint compound and application products.
How do you put beadboard on a ceiling?
6:5210:19DIY Beadboard - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd the ceiling. As well as the molding. And the wall. Now as i'm going around the room i also likeMoreAnd the ceiling. As well as the molding. And the wall. Now as i'm going around the room i also like to fill in any nail holes that are on the moldings. This will make it look really nice once you
How do you make a popcorn ceiling look modern?
When looking for a way to dress up a ceiling with texture while also hiding that popcorn texture, consider adding wood or wood paneling. Covering the ceiling with tongue and groove wood planks, bead board, or another rustic wood plank or panel is a creative way to add interest to the ceiling and update the space.
Is it worth it to remove popcorn ceiling?
In short, removing a popcorn ceiling can increase your home value. However, particular circumstances can affect its impact. Removing popcorn ceilings from a smaller home may not be a good use of renovation money. As long as it's in good condition, a fresh coat of paint may be the better option due to cost.
Can I put shiplap over popcorn ceiling?
You can install shiplap over a popcorn ceiling to cover it up. Shiplap planks come in a variety of sizes and can be attached to the ceiling with nails. Simply measure the popcorn ceiling and locate the joists above it, then cut the shiplap boards to size and attach them to the joists with 2-inch finish nails.
Can you use beadboard on ceilings?
Not only can beadboard be used for ceilings, but it's actually a really popular and beautiful use of this material. Taking up most of the surface area of any room, your ceilings should never be overlooked and fortunately, due to beadboard being lightweight, it's not a challenge to install it overhead.
How much does it cost to remove popcorn from the ceiling?
Popcorn ceiling removal cost ranges from around $898 to $2,847, with the average homeowner paying $1,853 for professional removal. Popcorn ceilings were all the rage in the 1970s and 1980s—everyone wanted them.
How do you install a 4x8 sheet of beadboard on a ceiling?
Measure the ceiling and locate the ceiling joists. You can use a stud finder or just drill holes in the drywall until you hit resistance.Cut down the beadboard (including cut outs for lights and vents). ... Install beadboard. ... Measure, cut, paint and install border boards. ... Add trim boards. ... Caulk, fill nail holes and paint:
Can you put beadboard over textured ceiling?
Installing beadboard paneling over popcorn ceilings is a quick way to cover the popcorn. This is important because many homes have popcorn ceilings that contain asbestos. In many cases, it is best to leave the popcorn to avoid asbestos problems. Fortunately, covering it with beadboard allows you to do just that.
How do you cover a popcorn ceiling with planks?
3:314:44How To Wood Plank A Ceiling | Easy Way To Cover Textured or Popcorn ...YouTubeStart of suggested clipEnd of suggested clipFor all of our ceilings we always use bears ceiling flat white paint. So we just rolled that on iMoreFor all of our ceilings we always use bears ceiling flat white paint. So we just rolled that on i think we did about two coats. And it turned out. Great.
What is the cheapest way to cover a ceiling?
Cheapest: Install an array of 1-by-2-inch furring strips on the existing ceiling and nail tiles or planks to the strips. Furring strips cost about $1 per strip.
How much does it cost to cover a popcorn ceiling?
The average rate ranges from $898 to $2,847, with most homeowners ending up paying about $1,853 for professional removal and finish.
Is it safe to skim coat over popcorn ceiling?
5:5511:26When To Skim Coat Over A Popcorn Ceiling? - YouTubeYouTubeStart of suggested clipEnd of suggested clipLike a bump you can just scrape that down and then you can do your second skim coat after that soMoreLike a bump you can just scrape that down and then you can do your second skim coat after that so unless you like to sand it is not necessary to sand in between coats.
Can you put new drywall over popcorn ceiling?
Yes. You can install drywall over the popcorn ceiling to cover it. Feather-light drywall panels can be installed with adhesive and then attach the panels to the ceiling joists using screws and nails. If your popcorn ceiling is 8 feet or higher, you might consider installing a drop ceiling.
Beadboard Planks Over Popcorn Ceiling DIY - Designing Vibes
After witnessing what a mess it was to scrape off the popcorn in our living room (you can read my tutorial for removing popcorn ceilings here), I decided to try something different.I wanted to brighten the space and add some nice up-scale detailing to the space….beadboard ceiling seemed the best route to go.
How far apart should beadboard be?
Nail the beadboard to the joists by driving the nails at an angle through the tongue portion of the boards; the tongue should be facing away from the wall. The joists typically are located every 16 inches (some are spaced 24 inches apart), so the nails must be 16 inches apart. Nail the wall-side edge of the board to the ceiling by driving additional nails up through the face of the board. Only the boards installed at the beginning and end of each row need to be nailed this way; the other boards are nailed through the tongues.
What is a popcorn ceiling?
This textured ceiling is often one of the most visible, unbroken surfaces in a room, which makes them even more noticeable than other areas of the same room. Covering a popcorn ceiling with classic beadboard paneling can instantly transform the look of the entire room from dated to timeless.
How to set a board in place?
Set the next board in place by overlapping its grooved edge onto the tongue of the installed panel. Nail the board into place.
Is popcorn ceiling asbestos?
Popcorn ceiling materials may contain asbestos. Confirm that your ceiling is safe to work on by having the texture material inspected and tested by an asbestos testing or abatement professional.
Is it easier to beadboard popcorn ceilings?
Our analysis of trying to cover popcorn ceilings with beadboard is that it is more difficult than scraping, but easier. That sounds dumb, but what I mean is that it is a little more difficult to work with big materials and we had to prep the cuts ahead of time, but it was much easier and neater than dealing with scraping, sanding, mudding and painting.
Can you scrape popcorn ceilings?
Hate your popcorn ceiling? You can scrape it (we have a tutorial for that!) or, you can cover it. Beadboard is an easy way to DIY cover popcorn ceilings. Here's how we did it.
Is beadboard painted white?
Even though the beadboard was primed white, we wanted to give it a coat of the same color ceiling paint as the boards would get. Not all ceiling paint is created equal…
Can you pay someone to drywall over it?
Of course, nothing is as easy as paying someone to drywall over it for you. That’s my favorite method, but my wallet prefers the beadboard. Speaking of, here’s what it cost us.
What is the best way to cover popcorn ceilings?
Paneling adhesive. Nail gun. Drywall compound. Popcorn ceilings can date a house faster than almost anything else. Installing beadboard paneling over popcorn ceilings is a quick way to cover the popcorn. This is important because many homes have popcorn ceilings that contain asbestos.
Why do you have to leave popcorn ceilings?
This is important because many homes have popcorn ceilings that contain asbestos. In many cases, it is best to leave the popcorn to avoid asbestos problems. Fortunately, covering it with beadboard allows you to do just that. Advertisement.
Can you paint beadboard before installation?
Painting the beadboard before installation will save you a lot of time. Painting the beadboard after installation can be time-consuming, messy and tiring. Let the paint dry completely. Roll on a second coat of latex paint once the first has dried. Allow the paint to dry entirely before installation.
