How to Light a Rheem Water-Heater Pilot
- Rotate the gas knob on your Rheem water-heater clockwise until it is in the "Off" position.
- Rotate the water-heater temperature dial counterclockwise until it is set to the lowest temperature setting.
- Lift the outer door off of your Rheem water-heater. Rotate the gas knob counterclockwise until it is in the "Pilot" position.
- Push down the red button to the left of the gas knob. ...
- Replace your water-heater's outer door. Rotate the gas knob counterclockwise until it reads "On." Set the hot-water temperature dial to your preferred water temperature.
What are some common problems with a Rheem water heater?
- System Overload – You could be using too much hot water and overloading your hot water heater. ...
- Exhaust Blockage – Your hot water heater needs to vent pressure and air from the combustion chamber. ...
- Check the Error Code Guideline – Rheem water heaters can display a variety of error codes. ...
How to light pilot light water heater?
Steps to Lighting Water Heater Pilot
- Find the access panel. The first step in lighting water heater pilot is finding your access panel; this is usually located under the gas valve.
- Locate the gas burner. To light a gas water heater pilot light, you have to first search for the gas burner. ...
- Twist the gas knob. ...
- Light it up! ...
- Turn the gas knob to “On”. ...
- Close the access panel. ...
Why is my new water heater not heating?
- A water heater is held in place by a metal bracket at the bottom.
- Start by making sure that all the wires are disconnected from all the screws.
- Pull the bracket out gently and lift off the old thermostat.
- While still pulling the bracket out, insert the new thermostat.
- Connect the wires on the screws and tighten them together.
How to reignite a hot water heater?
Steps for Relighting the Pilot Light On A Water Hater
- Push down and turn the gas valve to the “PILOT” setting—this starts the flow of gas into the tube that supplies the pilot light. ...
- While holding down the pilot gas valve, or the red button, with one hand, you’ll use your other hand to light the pilot light. ...
- Continue holding down the gas valve for one minute after the pilot light has been lit.
How do you ignite a pilot light on a Rheem?
5:256:36How to relight Rheem Stellar Gas Hot Water - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn the control knob to pilot. Press the control knob down for thirty seconds. Keep holding theMoreTurn the control knob to pilot. Press the control knob down for thirty seconds. Keep holding the control knob down press the igniter repeatedly for forty seconds.
Where is the pilot light on a Rheem water heater?
You can see the pilot light through the viewing window on the Rheem water heater's inner door. Continue to hold down the red button for one minute after the pilot light is lit and then release it. The pilot light will remain lit.
Why is my Rheem water heater not lighting?
A faulty thermocouple or malfunction of the gas valve could be the culprit, but the problem may be as simple as a draft coming from a crack in the wall or under the door. Although Rheem recommends that you call a professional for any water heater repair, you can sometimes diagnose and correct the problem yourself.
How do you light a gas water heater with electronic pilot?
0:283:35How to Light a Water heater pilot (new style) - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd on with a little white indicating arrow right there we'll turn that to the pilot mode and whatMoreAnd on with a little white indicating arrow right there we'll turn that to the pilot mode and what we'll do is we'll press down right here this is allowing the gas to flow through the valve.
Why did my Rheem water heater pilot light go out?
If it senses that your water heater pilot light keeps going out, the thermocouple will shift off the gas supply to the heater. Over time, thermocouples can malfunction, accumulate dust buildup, or the device can get bent away from the pilot light's flame.
How do you light a water heater manually?
0:593:14How to Relight a Gas Water Heater Pilot Light | Roto-Rooter - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn the dial to the pilot setting. Once it's in the correct position press. And hold the red buttonMoreTurn the dial to the pilot setting. Once it's in the correct position press. And hold the red button all the way down start the flow of gas to the pilot assembly.
Can you manually light a Rheem water heater?
0:001:07How to light the pilot on a Rheem gas water heater - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd push in towards the water heater push the button down. And then push. The igniter button this isMoreAnd push in towards the water heater push the button down. And then push. The igniter button this is going to make a little spark.
How do I know if my Rheem water heater is working?
2:564:54How to Troubleshoot an Electric Water Heater - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf the meter is registering resistance then the element is good once you have completed your test ofMoreIf the meter is registering resistance then the element is good once you have completed your test of the upper element. Move down to the lower element. And repeat the process.
How do you reset the pilot light on a water heater?
1:444:16How To Relight A Water Heater Pilot Light - YouTubeYouTubeStart of suggested clipEnd of suggested clipPosition press the knob on the front in and hold. It next you're going to press the igniter. ThereMorePosition press the knob on the front in and hold. It next you're going to press the igniter. There should be a black square button below the knob that you're pressing.
Can you manually light a gas water heater with electronic ignition?
They use electronic ignition to ignite the gas. Do not attempt to manually light an electronic ignition system. If the pilot light is not lit: Attempt to re-light the pilot light, following the instructions posted on your water heater.
How do you relight an automatic pilot light?
1:074:41Relight a Natural Gas Furnace - YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure your thermostat is turned up to trigger the furnace to kick in the furnace should relightMoreMake sure your thermostat is turned up to trigger the furnace to kick in the furnace should relight within 2 to 3 minutes it. May not rely immediately.
How do I know if my pilot light is out on my water heater?
No flame where there should be a flame? These are signs the pilot light on your water heater is out. Fortunately, it's a really easy fix....Signs your pilot light is outYour Water is Cold.Blinking Light or Error Message.You Can't See the Flame.
How do you check the pilot light on a water heater?
The pilot light on most water heaters is located at the base of the unit, below the gas control valve. Open the access panel or door to the burner chamber and look inside. There, you'll find the pilot light tube, which should have a steady blue flame. If you don't see the flame, the pilot light is out.
Can I relight my hot water heater?
Most homeowners can relight a pilot light themselves without any issue, but it's important to be safe when dealing with a gas-powered hot water heater. You should always proceed with care when relighting a pilot light, since the gas used to power your hot water heater is flammable and potentially dangerous.
How do you light a hot water heater without an igniter?
Lighting with No IgniterTake a long lighter to reach the pilot. ... Remove the plate attached below the dial box. ... Switch Pilot to OFF.Wait for a while, – 5-10 minutes until there won't be any gas.Change the temperature to LOW, and switch to Pilot.Push ON/OFF dial down, and simultaneously use the lighter.More items...•
How do I turn up my Rheem hot water heater?
0:561:45How to Adjust Water Heater Temperature - YouTubeYouTubeStart of suggested clipEnd of suggested clipThere are two thermostats on electric water heater upper. And lower so I'm going to show you how toMoreThere are two thermostats on electric water heater upper. And lower so I'm going to show you how to adjust both after removing the covers take a flathead screwdriver.
Why can't I light the pilot light on my water heater?
You can’t light the pilot light on your water heater if the thermocouple is bad. You can easily verify whether it’s malfunctioning or not. Just use...
How much does it cost to replace a water heater thermocouple?
It will cost you around $15o to replace the thermocouple of your water heater professionally. However, the price of this part is only $20. I recomm...
What would cause a pilot light to keep going out?
A dirty or damaged thermocouple, bad igniter or dirty gas chamber will cause a pilot light to keep going out.
What to do if your Rheem water heater pilot light goes out?
If you smell gas at any time while you are lighting your Rheem water-heater pilot light, leave your home immediately and call your gas provider's emergency phone number from another location .
How to light a gas water heater pilot light?
Push down the red button to the left of the gas knob. Hold the red button down while pressing the piezo i gnitor striker, found to the immediate right of the gas knob, repeatedly until the pilot is lit. You can see the pilot light through the viewing window on the water-heater's inner door. Continue to hold down the red button for one minute ...
How long to wait to set water heater to lowest temperature?
Rotate the water-heater temperature dial counterclockwise until it is set to the lowest temperature setting. Wait five minutes to allow any gas in the water-heater to pass through.
How to see pilot light on water heater?
You can see the pilot light through the viewing window on the water-heater's inner door. Continue to hold down the red button for one minute after the pilot is lit, and then release it. The pilot will remain lit. Advertisement.
Why is it important to know how to light the pilot on a water heater?
It's important to know how to light the pilot on your water-heater, because you should always turn the pilot light off if you are leaving your home for an extended vacation. Advertisement.
What to do if you run out of hot water?
If you run out of hot water, check the pilot light. If you don't have any hot water, the first thing you should do is check to see if the pilot light on your Rheem water-heater has gone out. Rheem water-heater pilots need to be manually lit using the piezo ignitor striker built into the water-heater. It's important to know how to light the pilot on ...
How to heat water in a gas tank?
Reignite the main burner. Turn the main gas valve back “On” and adjust the temperature control to your desired setting. The main burner under the tank should light and begin heating the water in the tank .
Where to check for water heater pilot?
Check inside the door panel of your water heater for instructions. Specific instruction of details for your individual model may be listed here, and they may help guide you in the process of relighting the pilot for your specific water heater.
What is the difference between a new and old gas water heater?
There are two basic styles of gas hot water heaters, “new” and “old.”. Old style heaters will require you to use your own flame to relight the pilot, while new style tanks come equipped with a pilot light igniter.
How to turn on pilot light on gas valve?
Turn the gas valve to the "Pilot" setting and push down on it. Doing this starts the flow of gas into the tube that supplies the pilot light.
Why won't my water heater light?
Low gas pressure or a malfunctioning gas valve may also be to blame if this process doesn’t work. Contact an appliance repair person, a plumber, or your gas company if you are unable to light the water heater after several attempts.
How long to hold down gas valve?
Continue holding down the gas valve or control button for 1 minute after the pilot light has been lit. This will heat the thermocouple, which is a sensor that shuts the gas off when the pilot is out.
What happens if a pilot light doesn't relight?
If the pilot light doesn’t relight or goes out immediately after relighting, you may have a bad thermocouple. The thermocouple extends from the temperature control into the flame area of the pilot light. They are relatively cheap, and you can install one yourself.
Where is the rating plate on a Rheem water heater?
However, the best part is that you won't have to spend hours on end trying to locate the rating plate on your Rheem Water Heater – because the sticker is located on the water heater's exterior. Tankless water heaters generally have the stickers placed on the right-side of the surface.
What is Rheem heating?
Rheem manufactures and sells a diverse line of cooling and heating products for both commercial and residential use. This line-up includes oil furnaces, 98.7% fuel-efficient (annual) gas furnaces, heat pumps, 20 SEER (Seasonal Energy Efficiency Ratio) air conditioners, and package units. The company also creates indoor air quality (IAQ) products such as UV lamps, humidifiers, and media filters.
What year did Rheem win the most popular water heater title?
In 2008, the US Department of Energy ranked the company at fifth place in the central AC and heat pump market, and in 2015 Rheem won the most popular water heater title by Builder magazine.
What is hybrid water heater?
Hybrid Water Heaters – pull in hot air into the appliance's evaporator coil to heat water. Also referred to as a heat pump water heater, this device needs a moderate or a warm climate to work efficiently.
What type of water heater is the most common?
Tank-type Gas Water Heaters – are the most prevalent water heaters because of their low installation and operating cost. These water heaters run on gas and require ample space for setup.
Is Rheem copyrighted?
All imagery and manuals are copyright © Rheem. Please visit https://www.rheem.com/ for the most up to date manuals and product information. You can read our DMCA policy here .
Can a warranty on a water heater be voided?
Additionally, you should also note that some manufacturer warranties for water heaters can be voided if the product is not installed by a licensed professional.