Full Answer
What is braai in cooking?
What is a braai?
What is the most important factor in braai?
What is the best mesh for braai?
How to make a fire with a stick?
Where to put fire lighter in braai?
Is it fun to make a braai?
See 2 more
How do you fit a braai built in?
Installation procedures - Built in braais Construct brick support walls (1) for the unit. Choose personal desired height 7 –9 bricks high). Position the unit , cover sides back and the top with fiberglass insulation (2) and brick in the unit. A lintel or slab underneath the unit is not required.
How do you build a braai?
2:427:01How to Build a Braai Tutorial - YouTubeYouTubeStart of suggested clipEnd of suggested clipSure build cement with eight parts building sand in a wheelbarrow. Make a hole in the center slowlyMoreSure build cement with eight parts building sand in a wheelbarrow. Make a hole in the center slowly pour in small amounts of water and mix well the mixture should be of a mud-like consistency.
Can you build a braai with cement blocks?
Cement foundations will require a base layer of clay bricks or rocks to protect it from cracking. Never use a concrete brick in a braai, fireplace or firepit.
Can you build a braai with paving bricks?
You can use a 1 x 0,6m paving slab, or a 0,6 x 0,6m slab like this one. To get the brickwork bond correct, it is necessary to cut half bricks. Cut these on a soft surface with a bolster chisel and club hammer. Wear protective clothing for this operation.
How deep should a foundation for a braai be?
Lay the foundation Mark off and excavate the area to a depth of about 20 cm, and compact the ground.
Do you need plans to build a braai?
So long as you make an application to get the proper approval from the local authority, you DO NOT NEED PLANS . But the law is also very clear in terms of compliance with the regulations; minor building work must adhere to the regulations.
Are red clay bricks fireproof?
Red bricks can also be used in a brick oven. In ovens, red bricks will heat up, retain heat, cook, bake, roast, re-fire, absorb conduct store and hold the heat from wood fire and perform the same way as fire bricks do. But it is not as hard and durable as fire bricks. It may flake or crack.
Are normal bricks fireproof?
Most bricks are fireproof because their method of construction and properties allow them to withstand heat and flames. However, it is important to remember that brick-built homes have more than just bricks in the walls.
How hot does a built in braai get?
In a domestic fireplace or braai they are really a total "over specification". Refractory Bricks are normally rated from around 1600'C upwards. They are expensive and not easily available. A braai will never reach this kind of heat and all facebricks are fired to around 1000 – 1250'C.
Can any brick be a fire brick?
Substitute for firebricks can be old red clay solid bricks. In ovens these alternative red clay bricks will heat up, retain heat, cook, bake, roast, re-fire, absorb conduct store and hold the heat from wood fire and perform the same way as proper refractory firebricks do.
What temperature can fire brick withstand?
2460° F.Fire Brick is a high heat tolerant dry-pressed clay brick. The most common use of this product is for fireplace installations, indoor/outdoor brick ovens and outdoor kitchens. Fire Brick can be used during residential or commercial installations and are capable of withstanding temperatures up to 2460° F.
Can you build a brick BBQ without cement?
Make a simple barbecue pit with just fireproof bricks or cinder blocks that stack and fit together neatly with no need for mortar. Simply slot in a grill and you'll be ready to go whole hog.
How do you make a braai out of wood?
Building your firePack 2 pieces of wood parallel to each other.Place fire lighters in the gap between the 2 pieces of wood. ... Next, pack another 2 pieces of wood on top of the bottom 2 at a 90 degree angle.Continue with this packing pattern until you have used at least 12 pieces of wood.More items...
How high must a braai chimney be?
2 metres highA pro-installer will already know your chimney needs to be 2 metres high at the very minimum to correctly draw smoke away. A pro will also remember to use a flue pipe. We have these available in 1-metres lengths. The smooth surface allows for a better smoke draw and will protect your brick or stonework.
Can you build a brick BBQ without cement?
Make a simple barbecue pit with just fireproof bricks or cinder blocks that stack and fit together neatly with no need for mortar. Simply slot in a grill and you'll be ready to go whole hog.
How do you start a braai fire without wood?
Break a few firelighters into small pieces and place them inside the braai. Using briquettes, build a pyramid on top of the firelighters. Just make sure that you can still access the firelighters.
What is braai in cooking?
Firstly what is a BRAAI. A Braai is roasting any type of meat on a Fire , this tradition of Braaing meat out in the open resonates from days gone by when no stoves where available and today this form of cooking out in the open still flourishes in South Africa.
What is a braai?
The actual BRAAI. This is the actual area and Braai that will be used to make the fire in and later roast the meat. As one can imagine almost anything will do, from a wheel barrow to a fire brick outdoor braai. What matters most is the heat that the coals will produce and will the braai area be able to cope with it.
What is the most important factor in braai?
The most important factor of all are the COALS, when making a Braai. Knowing just how much heat is needed for the type of meat that one is to braai is imperative. Wood Fired Braai's are by far the best, this is due to the amount of coals the wood produces. Charcoal fired braai's create large amount of coals, how ever charcoal does not offer one ...
What is the best mesh for braai?
Next is a suitable grid on which the meat will be placed and cooked. Expanded mesh ( stainless steel) is the most suited.
How to make a fire with a stick?
Step 3. Gradually add larger pieces of wood to the fire. Step 4. Add the grid to the fire and burn the grid clean, then use steel brush and clean completely. Step 5. Using a stick spread the coals under the grid. Make sure that you have no open flames prior to adding your meat. Step 6.
Where to put fire lighter in braai?
Neatly arrange the fire lighter in the center of the braai area
Is it fun to make a braai?
Note that making a braai should be fun, don't give up should your first time be a bit disappointing.
How to build a braai?
To build in a braai, preferably use baked bricks (clay bricks) around the body of the unit, as it is more resistant to heat.(Insulation material is also recommend to protect the cement between the bricks) Before you begin, keep in mind that your grid (at the lowest) is 200 mm higher than the lintels on which the braai will rest.
How to draw level with a braai?
Take the total height from the highest point of you roof to the floor, there where your braai will stand, now subtract the height of the first lintel (A) & the total height of the braai (F) from the total height of your roof. Now you will be left with the length of flue needed to draw level with the highest point of your roof. now add 750mm to extend past your roof, in most cases this would be sufficient for your cowl to work properly.
How to make a brick stand?
Start with a double row of bricks, go up as high as you want your stand to be, minus 100 mm. Place lintels (2 or 3 will be enough), across the inner row of bricks, or lay a slab. Carry on up with the outer row. The width between the inner row of brick (B) should be approx. 50 mm wider than your braai. The depth (C) should be about 25 mm deeper than your braai.
Is a braai a guideline?
The instructions for a braai installation is intended only as a guideline, We strongly recommended that the advice of a professional builder/installer be consulted.
CHOOSE THE RIGHT TIME TO INSTALL
Ready to upgrade your braai area? In South Africa, where summer heat can soar, it helps to pay attention to the temperature ranges indicated on materials for handling. Noted on product labels, you’ll find that certain materials can’t be applied in excessive heat. If possible, try and opt for a milder time of year to install your built-in braai.
CONSIDER YOUR BUILT-IN BRAAI LOCATION
Is your braai area sheltered from harsh winds, rain, and direct sun? Where your built-in braai is situated will determine the particulars and long-term success of your project. Also ensure you allow enough room for cooking and easily moving around the braai.
SELECT THE RIGHT BUILT-IN BRAAI FOR YOU
Built-in braais are a great choice because they provide versatile cooking means – from potjies and steaks to bread and pizza. But selecting the perfect built-in braai for your needs can be difficult. Fortunately, Megamaster stocks everything you need (and need to know) to become the ultimate braai legend.
FIND A RELIABLE INSTALLER
Understandably, most people want to try and avoid mounting costs. However, paying a professional to install your built-in braai is well worth the investment. A well-built braai area will add value to both your experience and property value. An amateur effort could very well achieve the opposite.
SPECIFY THE CORRECT COMPONENTS
A well-constructed built-in braai can be seen as the cornerstone of any good South African home. With that in mind, it pays to stress the details – right up till the end of the project.
THINGS TO REMEMBER WHEN INSTALLING A BUILT-IN BRAAI
Although we highly recommend hiring an installation expert, if you do plan to install it yourself, here are some practical tips to consider:
BEFORE PRIME STEAK, PRIME YOUR BRAAI
Before you start using your newly installed built-in braai, remember to prime it first. This process entails initiating your braai with a small, slow-burning fire. In doing so, you will burn away any resin and debris from the building materials used.
800 Standard Braai
The Standard built in Braai offers all the standard features of an built-in braai. This unit is ideal for town houses or where space is limited. Whether it be a family gathering or simply unwinding with friends.
800mm Deluxe Built in Braai
Constructed from quality 3mm steel, this durable unit enables mouth watering dishes straight from the fire! Our Deluxe range truly offers the ultimate in barbecuing & comes in a variant of sizes to suit your requirements.
800mm Double Sided
Our Double Sided Built-in Braais offers the best of all seasons. This unit allows you to enjoy your braai experience not only from inside your entertainment area but also outdoors on a beautiful summers day. Installing this unit is like having two braais installed in the space of one!
1.2m Spit Braai
This unit is ideal for large gatherings and will suit the connoisseur braai enthusiast that likes to prepare a whole lamb or hog. This unit sports a duel speed heavy duty spit motor enabling you to Roast it to perfection- succulent & tasty – just the way you like.
1.2m Combination Braai
Crafted from only the best A grade materials, the Combination Deluxe Braai truly embodies the best of Both worlds! Neatly housed as one unit, this Braai not only enables you to enjoy a traditional charcoal braai experience, but also offers the classic steakhouse flavors of a gas BBQ. Whatever your preference, this braai aims to please!
What is braai in cooking?
Firstly what is a BRAAI. A Braai is roasting any type of meat on a Fire , this tradition of Braaing meat out in the open resonates from days gone by when no stoves where available and today this form of cooking out in the open still flourishes in South Africa.
What is a braai?
The actual BRAAI. This is the actual area and Braai that will be used to make the fire in and later roast the meat. As one can imagine almost anything will do, from a wheel barrow to a fire brick outdoor braai. What matters most is the heat that the coals will produce and will the braai area be able to cope with it.
What is the most important factor in braai?
The most important factor of all are the COALS, when making a Braai. Knowing just how much heat is needed for the type of meat that one is to braai is imperative. Wood Fired Braai's are by far the best, this is due to the amount of coals the wood produces. Charcoal fired braai's create large amount of coals, how ever charcoal does not offer one ...
What is the best mesh for braai?
Next is a suitable grid on which the meat will be placed and cooked. Expanded mesh ( stainless steel) is the most suited.
How to make a fire with a stick?
Step 3. Gradually add larger pieces of wood to the fire. Step 4. Add the grid to the fire and burn the grid clean, then use steel brush and clean completely. Step 5. Using a stick spread the coals under the grid. Make sure that you have no open flames prior to adding your meat. Step 6.
Where to put fire lighter in braai?
Neatly arrange the fire lighter in the center of the braai area
Is it fun to make a braai?
Note that making a braai should be fun, don't give up should your first time be a bit disappointing.
