Knowledge Builders

how do you put a tie on a cushion

by Prof. Jeremy Wisoky Published 3 years ago Updated 2 years ago
image

Use the seam ripper and carefully open the seam near one corner of your cushion, where you want the tie. Open the seam enough to insert the end of the ties. Insert the raw ends of both tie strips into the opening in the cushion and sew it back shut.

Full Answer

How to tie a cushion with ties?

What do you need to make a cushion tie?

How long does it take to undo ties on pillows?

How to make a hole in a pillow?

How long to let fabric dry before putting on ties?

How to tie a pillow back?

How to prevent pillows from going airborne?

See 4 more

About this website

image

How to Make Ties for Chair Cushions | eHow

Chair cushions can slip, especially on lawn furniture. Ties are not only decorative, but also keep a cushion from blowing into the yard on windy days, or simply keep it beneath someone using the chair. Of course, the chair must have openings for the ties to go through and around as most lawn chairs do.

How to Keep Outdoor Cushions From Sliding (Genius Hacks)

HOW TO KEEP OUTDOOR CUSHIONS FROM SLIDING. It’s nice that you have outdoor furniture that looks great and is comfortable. But if your cushions keep sliding off and you’re tired of chasing them down, there are steps you can take.

How to tie a cushion with ties?

Pull the ties through the holes until the two ends are even and then tie a knot to hold the ties in place. Repeat the process until all of your cushions have ties.

What do you need to make a cushion tie?

Cushion ties: Tools and materials. The only tools you need are something to mark the hole locations on the fabric (a pencil works fine), a needle with a large eye and something with which to punch holes (a paper punch or leather punch, depending on the thickness of the fabric).

How long does it take to undo ties on pillows?

When you need or want to bring the cushions and pillows indoors, it just takes a couple minutes to undo the ties and haul them inside. Originally Published: January 17, 2019.

How to make a hole in a pillow?

If you don't want to or can't poke through the pillow cover and the pillow insides, remove the cover and make a hole in the center of the front and back. Then poke a hole through the middle of the pillow itself. The goal is to make a hole in the middle that you can pull the tie through and then thread on the button.

How long to let fabric dry before putting on ties?

To make sure the fabric around the holes doesn't fray, apply Fray Check to the edges. Let it dry for around 20 minutes before you insert the ties.

How to tie a pillow back?

Using the needle, pull the end of the tie back through the hole to the back side of the pillow and tie the ends in a knot.

How to prevent pillows from going airborne?

Prevent outdoor furniture cushions and pillows from going airborne on a windy day or ending up as part of a muddy pillow fort by adding ties. Making the ties is simple and inexpensive and using the ties saves you from dirty or lost cushions.

How to tie a cushion with a ripper?

Use the seam ripper and carefully open the seam near one corner of your cushion, where you want the tie. Open the seam enough to insert the end of the ties.

How to make a tie with fabric?

Cut the fabric into strips. Each tie will be in two pieces. Each piece will require two strips of cloth for the front and the back. So to make one tie, cut four strips of cloth. The actual dimensions are based purely on your preference for long verses short ties and for thick verses thin. For something semi-standard, cut the strips approximately 12 inches long and 3 inches thick.

Can a chair slip on a lawn chair?

Things You'll Need. Chair cushions can slip, especially on lawn furniture. Ties are not only decorative, but also keep a cushion from blowing into the yard on windy days, or simply keep it beneath someone using the chair. Of course, the chair must have openings for the ties to go through and around as most lawn chairs do.

How far apart should buttons be on a cushion?

Place the buttons an equal distance from each other and from the edges of the cushion. For example, if you are adding four buttons to the cushion, then you might want to place each of the buttons so that they are 4” (10 cm) from each other and 6” (15 cm) from the edges of the cushion. Measure to find these areas. ...

How to get a needle out of a cushion?

Then, bring the needle back up and out of the fabric. Pull until the thread is taut. Make sure to pull the thread taut after every time you bring it up and out of the fabric.

How to attach twine to a button?

1. Thread the twine through one of the buttons and the needle. Insert the twine through one of the buttons and then center the button in the middle of the twine strand. Tie a knot to secure the button in place. Then, thread the twine through your upholstery needle.

How many buttons can you put on a cushion?

You can add as many buttons to each cushion as you like. If you want to ensure that your buttons will match the fabric of your cushion, then you can always cover them in fabric. Cut the twine into 24” (61 cm) strands. You will need a strand of twine for each button you plan to add to the cushion.

How to make a cushion look polished?

Buttoning a cushion is an easy way to make it look more polished. To add buttons to a cushion, all you need to do is sew them into the cushion with a bit of twine. Try adding buttons to one or more of your cushions to improve the look. Steps.

How to secure a knot in twine?

Add a dab of fabric glue to secure the knot. To ensure that the knot does not come undone, add a dab of fabric glue to the knot in the twine. Allow the glue to dry completely before touching it.

How to make a button secure?

To ensure that the button is secure, stitch in and out of fabric a few times. Make sure to make one pass through each hole in the button. If your button has multiple holes in it, then you will need to thread the needle through all of the button holes.

What to use for cushioning?

For cushioning, you can choose foam or any other stuffing you desire. Some people use feathers, plastic bags, and cotton, so you have a wealth of options to choose from.

How to make a bar stool with a back?

If your bar stool has a back, cut four cords that are long enough to be tied to the back attachments. If you have a backless bar stool, take your fabric and hem the edges, allowing two free inches at the edge. This is where your elastic cord will be placed.

Can you make a bar stool with cushions?

Although you can have your cushions custom made, making them yourself is a nice and easy DIY project. Creating a bar stool that slips on and off easily allows you to throw them in the wash and replace the stuffing easily.

Where to attach ties to a cushion cover?

Attach two ties, one on top of the other, at one side of cushion cover, along the back edge.

How to sew a cushion?

You have two options for stitching the cushion closed: 1 Since the cushions are thin, you can do like I did and sew it up on the machine. This method can get a little fussy since you have to keep shoving the cushion under the presser foot, but I like how the finished edge comes out. 2 You can sew the opening closed by hand using a slip stitch. Make sure you make small stitches and double the thread so it won't pop open once people start sitting on it.

How to sew a t-shirt with a t-shirt?

Begin at one side of where the opening will be, begin stitching, going over first set of ties. When you get to the corner, lower needle down into fabric, pivot, and turn to sew the next side. Continue in this fashion until you have sewn over the other set of ties and stop leaving an opening in the back edge.

How to turn a cushion cover right side out?

Before you turn the cover to the right side, trim across the corners at a 45 degree angle to remove excess fabric that can cause bulk once turned. Now turn cover right-side out, make sure the seams are flat, and give it a good ironing. Next, insert the cushion inside the cover.

How long are ties for a chair?

Most ties are around 8" long--you just have to make sure you have enough to secure the cushion to your own style of chair. You may need to cut a couple of strips to have enough for all of your ties. Just be sure to leave enough width (or length) in the remaining fabric to be able to cover the cushions!

How to make a finished edge on a tie?

To do this, slightly open the tie, fold under one of the short ends about 1/4-1/2", then close tie back together. You can hold this end secure with a pin.

What size fabric should I use for a dressmaker?

Dressmaker or fashion fabrics are usually 44-45" wide. I decided to go with a stripe fabric, but you can choose any pattern you like that coordinates with your decor.

How to remove a cushion cover?

Remove the covers from the cushions. If your cushion covers are not designed to be removed, carefully unpick one of the side seams with embroidery scissors or a seam ripper, just enough to remove the cushion form or stuffing from the inside. Be prepared to sew this seam back together by hand after you’ve dyed the covers – if you don’t have basic sewing skills, recruit a crafty friend or family member to help. Do not dye cushions without removing the cover first, as Cushion Factory notes, because you will risk the cushions becoming misshapen or moldy.

How to get wool cushion covers to shrink?

After rinsing wool cushion covers, pull them back into shape by hand and lay them flat on a towel to dry.

Can you dye a polyester cushion?

Cushion covers that are 100 percent polyester will also not accept dye. For a deeper color, add more dye and let the cushion covers soak in the dye solution for a longer amount of time than is recommended by the dye manufacturer. Remove the covers from the cushions.

Can you dye outdoor cushions?

Do not attempt to dye cushion covers that are labeled “dry clean only”; not only will the dye not take, but you might ruin the fabric and make the covers useless. Cushion covers that are 100 percent polyester will also not accept dye. For a deeper color, add more dye and let the cushion covers soak in the dye solution for a longer amount of time than is recommended by the dye manufacturer.

Can you dye a patio cushion after it's been removed?

Don’t discard the dye bath after you remove the cushion covers. After the covers are rinsed and dried, examine the color. If you want the color to be darker or more intense, you can simply place them back into the same dye bath and repeat the process until the final color is to your satisfaction. Fresh colors from dying outdoor cushion covers will help restore faded patio cushions and revive the look and feel of your outdoor space.

How to tie a cushion with ties?

Pull the ties through the holes until the two ends are even and then tie a knot to hold the ties in place. Repeat the process until all of your cushions have ties.

What do you need to make a cushion tie?

Cushion ties: Tools and materials. The only tools you need are something to mark the hole locations on the fabric (a pencil works fine), a needle with a large eye and something with which to punch holes (a paper punch or leather punch, depending on the thickness of the fabric).

How long does it take to undo ties on pillows?

When you need or want to bring the cushions and pillows indoors, it just takes a couple minutes to undo the ties and haul them inside. Originally Published: January 17, 2019.

How to make a hole in a pillow?

If you don't want to or can't poke through the pillow cover and the pillow insides, remove the cover and make a hole in the center of the front and back. Then poke a hole through the middle of the pillow itself. The goal is to make a hole in the middle that you can pull the tie through and then thread on the button.

How long to let fabric dry before putting on ties?

To make sure the fabric around the holes doesn't fray, apply Fray Check to the edges. Let it dry for around 20 minutes before you insert the ties.

How to tie a pillow back?

Using the needle, pull the end of the tie back through the hole to the back side of the pillow and tie the ends in a knot.

How to prevent pillows from going airborne?

Prevent outdoor furniture cushions and pillows from going airborne on a windy day or ending up as part of a muddy pillow fort by adding ties. Making the ties is simple and inexpensive and using the ties saves you from dirty or lost cushions.

image

1.Videos of How Do You Put a Tie On a Cushion

Url:/videos/search?q=how+do+you+put+a+tie+on+a+cushion&qpvt=how+do+you+put+a+tie+on+a+cushion&FORM=VDRE

36 hours ago  · In this video (How to Make a Cushion 1 - Ribbon Tie Closure), Margo Price shows you how to make a cushion with a ribbon ties closure. In this series of six v...

2.How to Make a Cushion 1 - Ribbon Tie Closure - YouTube

Url:https://www.youtube.com/watch?v=0QOgPsfZ4O4

4 hours ago  · Using a needle and twine to button a cushion, and showing the correct slip knot so that all the buttons can be set to the same depth before finally tying off.

3.How to button a cushion - YouTube

Url:https://www.youtube.com/watch?v=9a-9rQMfgMA

31 hours ago How to Make Ties for Chair Cushions Step 1. Cut the fabric into strips. Each tie will be in two pieces. Each piece will require two strips of cloth for the... Step 2. Sew a pair of strips right side …

4.How to Make Ties for Chair Cushions | eHow

Url:https://www.ehow.com/how_5542436_make-ties-chair-cushions.html

16 hours ago A chair cushion tie can be made by following these steps: 1. Cut a strip of fabric that is twice the width of the cushion and long enough to wrap around the entire cushion. 2. Fold the fabric in …

5.How to Button a Cushion: 10 Steps (with Pictures)

Url:https://www.wikihow.com/Button-a-Cushion

29 hours ago  · How do I attach my cushions to my furniture? Put the cushions in place on the furniture and see where you can tie the cushions to the furniture frame. Mark the spots where …

6.How to Add a Cushion to a Metal Bar Stool

Url:https://www.doityourself.com/stry/how-to-add-a-cushion-to-a-metal-bar-stool

16 hours ago  · 5. Place the cushion covers into the dye bath and submerge them with the wooden spoon until the fabric is fully saturated. Let the cushion covers soak for about five minutes. If …

7.How to Sew a Cushion Cover With Ties - FeltMagnet

Url:https://feltmagnet.com/textiles-sewing/How-To-Sew-a-Cushion-Cover-With-Ties

2 hours ago

8.How to Dye Cushion Covers | Home Guides | SF Gate

Url:https://homeguides.sfgate.com/dye-cushion-covers-57647.html

12 hours ago

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9