How do you disassemble a peerless kitchen faucet?
- Turn off the water.
- Remove the handle.
- Unscrew the retaining nut, using locking pliers.
- Grasp the valve stem with pliers and lift out the cartridge.
- Check inside the valve housing for rubber gaskets in the inlet holes and lift out any you find using a screwdriver.
How much does it cost to replace a peerless faucet cartridge?
A Peerless faucet cartridge along with all its O-rings usually costs less than $20, so the repair shouldn't be expensive. If your Peerless faucet is leaking from under the handle, it's usually because the retaining nut holding the cartridge or ball valve is loose.
Why is my Peerless faucet leaking from under the handle?
If your Peerless faucet is leaking from under the handle, it's usually because the retaining nut holding the cartridge or ball valve is loose. To access it, you have to remove the handle and the dome-shaped collar, then you can tighten it with pliers.
How do you fix a leaking cartridge on a kitchen faucet?
When the faucet leaks, it's usually a good idea to replace everything, including the cartridge. Turn off the water. Remove the handle. Unscrew the retaining nut, using locking pliers. Grasp the valve stem with pliers and lift out the cartridge. If it's stuck, pour in some vinegar to dissolve the mineral deposits binding it.
Can a peerless shower faucet be repaired?
Peerless shower faucets sometimes include a set of seats and springs behind the actual cartridge, and these can wear out. After disassembling the faucet and removing the cartridge, pull out the seats and springs and replace them with parts from an appropriate Peerless repair kit.
Do you have any special instructions for installing pressure balance valves back-to-back?
How can I make sure my shower is safe?
What are the proper flushing procedures for a new faucet? How often should the lines be flushed?
What is the adjustable rotational limit stop?
Who can I call if I need help while I'm installing my faucet?
Why does the Peerless® name face the back of the faucet?
Why does water come out of my showerhead and the spout at the same time?
See 2 more
How do you remove the cartridge from a Peerless bathroom faucet?
1:293:02How to Replace Leaky Cartridges in a Bathroom Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipUse a crescent wrench to remove the bonnet nut from the cartridge. Once the nut is off remove theMoreUse a crescent wrench to remove the bonnet nut from the cartridge. Once the nut is off remove the cartridge if you need extra leverage. Use the pliers to pull on the stem.
How do you stop a peerless faucet from dripping?
What do I do if my single-handle kitchen or lavatory faucet drips from the aerator?Remove the aerator (it should twist off by hand).Turn off the water supplies.Turn the faucet handle to the "on" position.Turn the water on at the supply.Flush the faucet and supply lines for one minute.More items...
How do you take apart a peerless faucet?
Look for the nylon locknuts holding the body of the faucet to the countertop or sink. The locknuts twist onto two threaded shanks connected to the underside of the Peerless faucet body. Rotate the locknuts counterclockwise to remove them from the shanks and release the faucet.
How do you remove a peerless faucet handle without a visible allen screw?
If the set screw is visible, hold the faucet in place and tighten the screw. If you can't see the screw, it will be under the cap, which you can remove with a flathead screwdriver or your small knife. Tighten the screw while holding the handle in place. Once the screw is tight, the handle should stop shaking.
How do I know what model my Peerless Faucet is?
Your faucet's model number may be found on the packaging, and also on the Installation instructions provided with your faucet.
Why is my faucet still dripping after changing the cartridge?
Your faucet may contain a ceramic, brass, or rubber seat that is meant to form a seal at the bottom of the cartridge opening. The seat can become damaged with use so that it no longer fits correctly into the hole in the cartridge, which allows water to leak. The O-ring may also become cracked and cause a leak.
Are Delta and Peerless cartridges the same?
The products are interchangeable since Peerless and Delta fall under the same company. Many of the components in these faucets are the same, so you can easily switch out one part for another. That said, the components in Peerless faucets may not be as high quality as those found in a Delta faucet.
What is the difference between Peerless and Delta?
Peerless is Delta Faucet's line of "value-priced" faucets. It is the shallow end of a deep pool of good quality faucets that includes Delta faucets at mid-level and Brizo at the deep end.
Does Peerless faucets have a lifetime warranty?
Our Lifetime Limited Warranty applies to Peerless faucets manufactured after January 1, 1995. And it's one of the most extensive in the industry (provided you are the original purchaser).
How do you remove a stubborn faucet cartridge?
0:045:44How to remove a stuck cartridge or stem from any brand faucet!YouTubeStart of suggested clipEnd of suggested clipSo you want to get some CLR just like I did there spray the CLR. All over the top where theMoreSo you want to get some CLR just like I did there spray the CLR. All over the top where the cartridge threads down into the valve body. Let that set up for a few minutes tap on it a little bit.
How do you remove a faucet screen that doesn't unscrew?
0:252:42Replacing a Faucet Aerator...that's stuck! - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou might try a rubber jar opener.MoreYou might try a rubber jar opener.
How can I remove a Delta faucet handle that has no set screw?
Some single-handle Delta® bathroom faucets come with a Push-Fit Handle that eliminates the need for a set screw to secure the handle to the faucet. To remove a Push-Fit Handle, align the handle with the spout and pull the handle straight away from the faucet body. If your handle is on top, you pull upward.
What is the most common cause of a dripping faucet?
A worn-out washer is perhaps the most common cause of a dripping, leaky faucet. Every time a faucet is used, the washer rubs against the valve seat, causing friction and wearing the component down. Dripping that is caused by deteriorating rubber washers can be fixed by replacing the washer.
How do you stop a dripping faucet temporarily?
A temporary fix can easily be accomplished by tying a string around the faucet, making sure the string goes around the aerator or over the faucet spout. Then, let the end of the string hang down to the sink. The string will collect the dripping water and funnel it quietly down the drain.
How do I stop water dripping?
How to Stop a Leak Until the Plumber ArrivesTurn off the Main Water Valve. This one is the most obvious, but you might not think of it when there's a lot of water leaking into your home. ... Get a Pipe Wrap to Fix a Leaky Pipe. ... Use Epoxy. ... Using Plumbing Tape on Water Pipes.
How do you stop water from dripping?
Add dish soap Most importantly, the scientist discovered an easy way to silence the noise. Adding some dish soap, also known as washing-up liquid, to the container is enough to change the surface tension and eliminate the sound. The findings of the study were published in the Scientific Reports magazine.
Do you have any special instructions for installing pressure balance valves back-to-back?
Why, yes. It so happens we do. In order for both units to function properly, you’ll need to take the pressure balancing cartridge and flip it 180 degrees. Flipping the cartridge will reverse the hot and cold water supply lines, causing the faucet to work like a traditional hot/cold unit. You might also need to flip the cartridge to correct a hot/cold reversal (in case the supply lines were somehow connected to the incorrect sides of the valve).
How can I make sure my shower is safe?
Nothing makes you feel worse than inadvertently scalding a family member, roommate or guest. So here are some safety tips for you to observe with your shower.
What are the proper flushing procedures for a new faucet? How often should the lines be flushed?
Nonetheless, a small amount of debris may be flushed out of your pipe system during the first few days of faucet use. In addition, particles of solder, copper chips, Teflon® tape and other installation materials can get caught in aerators and showerheads. Occasionally, a chip might damage the valve seat that provides the watertight seal. The tips below will help you avoid problems like this. These procedures are a good idea to follow each time the water has been turned off for repairs in your home.
What is the adjustable rotational limit stop?
The adjustable rotational limit stop found on Peerless® valves allows you to set a maximum hot water temperature for water flowing out of the tub/shower. When set correctly, this safety feature will ensure that the handle in your tub/shower faucet never rotates beyond the set level—resulting in a safe bathing temperature.
Who can I call if I need help while I'm installing my faucet?
You can call us here at 1-800-438-6673 Monday through Saturday, 7 a.m. to 9 p.m. CST or Click here to send a message directly to Customer Service. If you're reading this on Sunday, keep exploring this FAQ list. We've tried to put all the answers on here. And if you still can't find help, go wash your hands at the neighbors' house and call us on Monday.
Why does the Peerless® name face the back of the faucet?
Because we’re so darned modest. No, seriously, it’s because you’ve put it on backwards. No worries, though. This is easy to correct.
Why does water come out of my showerhead and the spout at the same time?
We suspect your plumbing is suffering from a condition called "shower-rise," in which the water can’t get out of the spout as fast as it flows through the valve. This causes water to back up and come out the showerhead. There can be one of several reasons for this kind of nonsense:
Why is my peerless faucet leaking?
If your Peerless faucet is leaking from under the handle, it's usually because the retaining nut holding the cartridge or ball valve is loose. To access it, you have to remove the handle and the dome-shaped collar, then you can tighten it with pliers. You shouldn't have to turn off the water to make this repair.
What is a peerless shower faucet?
Peerless Cartridge Faucet Repair. Peerless shower and tub faucets and double-handle faucets usually have cartridge valves, as do some single-handle faucets. When these faucets leak, the problem may be worn gaskets in the inlet holes, worn O-rings or damaged cartridges. When the faucet leaks, it's usually a good idea to replace everything, ...
Why is my faucet leaking from the spout?
When a ball-valve faucet is leaking from the spout, the problem can usually be traced to the rubber gaskets covering the water inlet holes inside the valve housing and the springs behind them. The purpose of the springs is to push the gaskets against the ball when the water is off. When they wear out, water begins seeping through and comes out the spout. To replace the springs and gaskets, you have to remove the ball assembly:
How to remove a valve handle?
Remove the handle, using either a 1/8-inch hex wrench or a Phillips screwdriver. Unscrew the dome-shaped ball cover. You can usually do this by hand. Unscrew the ball retainer, using a pair of locking pliers. Lift out the ball to expose the two gaskets in the bottom of the valve housing.
How much does it cost to replace a peerless faucet?
Replace the cartridge and all the O-rings and gaskets. A Peerless faucet cartridge along with all its O-rings usually costs less than $20, so the repair shouldn't be expensive.
How to get stuck valve out of cartridge?
Grasp the valve stem with pliers and lift out the cartridge. If it's stuck, pour in some vinegar to dissolve the mineral deposits binding it. Wait a few hours and try again. Check inside the valve housing for rubber gaskets in the inlet holes and lift out any you find using a screwdriver.
Can a peerless shower faucet wear out?
Peerless shower faucets sometimes include a set of seats and springs behind the actual cartridge, and these can wear out. After disassembling the faucet and removing the cartridge, pull out the seats and springs and replace them with parts from an appropriate Peerless repair kit. Another problem you might encounter when Peerless shower faucet ...
Do you have any special instructions for installing pressure balance valves back-to-back?
Why, yes. It so happens we do. In order for both units to function properly, you’ll need to take the pressure balancing cartridge and flip it 180 degrees. Flipping the cartridge will reverse the hot and cold water supply lines, causing the faucet to work like a traditional hot/cold unit. You might also need to flip the cartridge to correct a hot/cold reversal (in case the supply lines were somehow connected to the incorrect sides of the valve).
How can I make sure my shower is safe?
Nothing makes you feel worse than inadvertently scalding a family member, roommate or guest. So here are some safety tips for you to observe with your shower.
What are the proper flushing procedures for a new faucet? How often should the lines be flushed?
Nonetheless, a small amount of debris may be flushed out of your pipe system during the first few days of faucet use. In addition, particles of solder, copper chips, Teflon® tape and other installation materials can get caught in aerators and showerheads. Occasionally, a chip might damage the valve seat that provides the watertight seal. The tips below will help you avoid problems like this. These procedures are a good idea to follow each time the water has been turned off for repairs in your home.
What is the adjustable rotational limit stop?
The adjustable rotational limit stop found on Peerless® valves allows you to set a maximum hot water temperature for water flowing out of the tub/shower. When set correctly, this safety feature will ensure that the handle in your tub/shower faucet never rotates beyond the set level—resulting in a safe bathing temperature.
Who can I call if I need help while I'm installing my faucet?
You can call us here at 1-800-438-6673 Monday through Saturday, 7 a.m. to 9 p.m. CST or Click here to send a message directly to Customer Service. If you're reading this on Sunday, keep exploring this FAQ list. We've tried to put all the answers on here. And if you still can't find help, go wash your hands at the neighbors' house and call us on Monday.
Why does the Peerless® name face the back of the faucet?
Because we’re so darned modest. No, seriously, it’s because you’ve put it on backwards. No worries, though. This is easy to correct.
Why does water come out of my showerhead and the spout at the same time?
We suspect your plumbing is suffering from a condition called "shower-rise," in which the water can’t get out of the spout as fast as it flows through the valve. This causes water to back up and come out the showerhead. There can be one of several reasons for this kind of nonsense: