How do I remove the control panel on a a maytag dryer
Probably you already did some of this but here you go.
- Unplug dryer or disconnect power.
- Pull the dryer away from the wall and remove the top cover.
- Remove the three screws from the electronic control board bracket, and tip the bracket assembly inside the dryer.
- Disconnect the ends of the two ribbon cables from the electronic control board connectors P3 and P4.
- Remove the two screws from the console bracket. ...
How do you disassemble a Maytag dryer?
To disassemble a Maytag dryer first remove the power switch of the dryer and your next step is to remove the screws located at the bottom of the front panel and then set aside the panel.
Where is the front panel on a Maytag dryer?
There are two common types of Maytag clothes dryer front panels--the standard front panel and the newer L-shaped front panel. Unplug the Maytag clothes dryer from the power source. Remove the two screws on the front panel. You will find them approximately 4 inches from the bottom, under the beveled edge.
How do you remove the front of a whirlpool dryer?
To remove the lower front panel insert a flat-head screwdriver in the gap between the lower panel. In the gap between the upper and lower front panels of the dryer, insert a flat-head screwdriver or putty knife. To detach the lower dryer panel, depress the two spring clips. The lower panel should be removed.
How do you remove the front panel on a Toyota Corolla?
Remove the two screws on the front panel. You will find them approximately 4 inches from the bottom, under the beveled edge. Pull the bottom of the front panel toward you until the clips on the top of the panel release. Carefully disengage the wires from the door switch and set the door aside.
How do you open the Control Panel on a Maytag dryer?
0:455:51W10391569 - Replacing Your Maytag Dryer's Control Panel AssemblyYouTubeStart of suggested clipEnd of suggested clipNow we'll be removing the two screws here holding our top. On. And once you remove those two screwsMoreNow we'll be removing the two screws here holding our top. On. And once you remove those two screws you can pull back on the top panel and then lift up and remove.
How do I remove the Maytag control board?
0:413:08How to Replace the Electronic Control Board on a Maytag ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipPush. Back on the control panel while sliding a putty knife under the right corner of the controlMorePush. Back on the control panel while sliding a putty knife under the right corner of the control panel to release the mounting clip repeat on the left side to release the console.
How do you replace a Maytag dryer control board?
1:454:26Replacing Your Maytag Dryer's Electronic Control Board AP6022778YouTubeStart of suggested clipEnd of suggested clipAnd now we'll use our quarter-inch nut driver to remove this screw. Once you get that screw out you'MoreAnd now we'll use our quarter-inch nut driver to remove this screw. Once you get that screw out you'll take the control board and shift it over to the side and then pull straight up. Now you can grab
How do you remove the dryer control panel?
0:243:19Whirlpool Electric Dryer Control Panel Assembly #WPW10639903YouTubeStart of suggested clipEnd of suggested clipUse a 5/16 inch socket or nut driver to unthread the rear screws securing the top panel. Slide theMoreUse a 5/16 inch socket or nut driver to unthread the rear screws securing the top panel. Slide the top panel back and lift up to detach.
How do I remove the control panel from my Maytag oven?
0:254:10Maytag Electric Wall Oven Disassembly – Range Repair HelpYouTubeStart of suggested clipEnd of suggested clipThe upper trim. And pull the trim. Off. Now pull the control panel forward reach behind and slideMoreThe upper trim. And pull the trim. Off. Now pull the control panel forward reach behind and slide the indicator light off of the Joule. Disconnect the wires from the oven light switch.
How do you open a Maytag Centennial dryer?
0:482:58Maytag centennial MGDC555DW2 commercial technology dryer front ...YouTubeStart of suggested clipEnd of suggested clipAnd under this corner and the corner over there are little clips that if you slide it forward justMoreAnd under this corner and the corner over there are little clips that if you slide it forward just enough they'll pop up and I'll do it and I'll show you what we did.
How do you remove the control panel from a Maytag 3000 Series dryer?
0:458:32How To: Whirlpool/KitchenAid/Maytag Front Panel Seal WP3387242YouTubeStart of suggested clipEnd of suggested clipOnce you have the screws out can lift the top off all you have to do is lift up on the back of theMoreOnce you have the screws out can lift the top off all you have to do is lift up on the back of the top a little bit and then pull back so the front comes out from the control panel.
How do you replace a dryer control board?
0:442:23How to Replace a Kenmore Electric Dryer Electronic Control BoardYouTubeStart of suggested clipEnd of suggested clipPull. The top panel back slightly to release the tabs behind the console. Pull the top panel up andMorePull. The top panel back slightly to release the tabs behind the console. Pull the top panel up and off of the dryer. Using a slot screwdriver release. The locking tabs from the wire connectors.
How do you test a dryer electronic control board?
How to test your dryer's rotary switch: Unplug your dryer and remove the control console panel on the top of your dryer to locate the rotary switch. Set your multi-meter to the Rx1 setting and place the probes on the switch's terminals. You should receive a reading of infinity.
How do you remove control panel from Whirlpool dryer?
0:283:34Whirlpool Electric Dryer Control Panel Housing #WPW10391519 - YouTubeYouTubeStart of suggested clipEnd of suggested clipUse a 5/16 inch socket or nut driver to unthread the rear screws securing the top panel. Slide theMoreUse a 5/16 inch socket or nut driver to unthread the rear screws securing the top panel. Slide the top panel back and lift up to detach.
How do you remove the control lock on a Whirlpool dryer?
Press and hold the Control Lock Key for 3 seconds to unlock the machine. You will notice the machine count down from 3-2-1. The control lock may be a stand alone key, or it could be a dual function key paired with another button like Extra Rinse, Steam, etc.
How do I replace the control board on my Whirlpool dryer?
0:402:27Whirlpool Electric Dryer Main Control Board WPW10654005 - YouTubeYouTubeStart of suggested clipEnd of suggested clipSlide the top panel back and lift up to detach. Note the location of the wire connectors connectedMoreSlide the top panel back and lift up to detach. Note the location of the wire connectors connected to the main control board then disconnect. Them. Unthread the mounting screws securing the board.
How do you remove the front panel of a Maytag washer?
0:092:33See how to remove & install the front panel in a Maytag washer - YouTubeYouTubeStart of suggested clipEnd of suggested clipLoad it down I line it I'm push down on the two bottom corners until the clip snaps in place.MoreLoad it down I line it I'm push down on the two bottom corners until the clip snaps in place.
How do you change a Maytag oven control board?
1:242:50How To: Whirlpool/KitchenAid/Maytag Electronic Control Board ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd secure it with the four Phillips. Screws. Then plug in the white and the red. Plugs. Put theMoreAnd secure it with the four Phillips. Screws. Then plug in the white and the red. Plugs. Put the rear cover on and install for chlorine screws. Block the ran gene set the oven clock.
How do you change a control board on a washing machine?
0:132:21Washer Main Control Board Replacement - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen remove all of the screws from the back of the control. Panel. Now slide the control panel toMoreThen remove all of the screws from the back of the control. Panel. Now slide the control panel to the right and lift forward place the control panel gently on the towel.
How do you test a washing machine control board?
4:139:07How to Diagnose Washing Machine Control and Program ProblemsYouTubeStart of suggested clipEnd of suggested clipTo the plug on the control board here. Now if I just grab my multimeter on a resistance orMoreTo the plug on the control board here. Now if I just grab my multimeter on a resistance or continuity setting. And just check for continuity. Between the two. We can see that.
Dryer Quick Start Guide
Fire Hazard No washer can completely remove oil. Do not dry anything that has ever had any type of oil on it (including cooking oils). Items containing foam, rubber, or plastic must be dried on a clothesline or by using an Air Cycle. Failure to follow these instructions can result in deatch or fire.
OPERATING INSTRUCTIONS
Fire Hazard No washer can completely remove oil. Do not dry anything that has ever had any type of oil on it (including cooking oils). Items containing foam, rubber, or plastic must be dried on a clothesline or by using an Air Cycle. Failure to follow these instructions can result in deatch or fire.
