Find the reset button on the tire pressure sensor Use a small object, such as a paperclip, to press and hold the reset button for five seconds Re-install the tire on the Silverado and tighten the lug nuts
How do I reset the tire pressure on my Chevy Silverado?
Reset the Tire Pressure Monitoring system on your Chevrolet Silverado: Turn ON the ignition, with the engine OFF; Apply the parking brake; Using the DIC, press the vehicle information button until the RELEARN TIRE POSITIONS message displays.
How do I reset the TPMS sensor on my Toyota Corolla?
Scroll down to the TIRE PRESSURE menu Press and hold the thumbwheel button to enter the relearn mode Start from the driver side front tire, place the TPMS Relearn Tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor
How to reset the tire pressure sensor on a Chevy Cruze?
How to Reset Tire Pressure Sensor Chevy Cruze. Using standard ignition: Park in the safe place. Turn the ignition to “ON/RUN” position, with the engine “OFF”. Press the “MENU” button. Select the “VEHICLE INFORMATION” in the “DIC”. Then scroll up the thumbwheel and find the Tire Pressure menu item display.
How long does it take to reset the TPMs on a Chevy?
Depending on the vehicle model you have, here are a few ways to reset the TPMS. Time needed: 7 minutes. If you have 2007 2008 2009 2010 Chevrolet Silverado, you can reset the TPMS by increasing or decreasing the tire pressure without using tools. Follow these instructions to get started:
Where is the TPMS reset button on a 2007 Chevy Silverado?
1:173:59How to Set Tire Pressure Monitoring System 07-13 Chevy SilveradoYouTubeStart of suggested clipEnd of suggested clipI'm going to take the Q this one does not have a key fob turn the key on. And then over here serviceMoreI'm going to take the Q this one does not have a key fob turn the key on. And then over here service tire monitors I'm going to scroll through there's a little button on the cluster.
How do you clear the service tire monitor on a Chevy Silverado?
The Chevy "Service Tire Monitor System" Reset Process The TPMS light and "service tire monitor system" warning can often be reset by adjusting your tire pressure to optimal levels and then driving around like you normally would for several minutes, followed by turning the car off, then back on.
How do you adjust the tire pressure sensor on a Chevy Silverado?
1:504:482014 Silverado Tire Sensors - Sierra Tahoe Suburban Yukon - YouTubeYouTubeStart of suggested clipEnd of suggested clipYour tpms readouts so your tire pressure. And you're going to want to hold down the center checkMoreYour tpms readouts so your tire pressure. And you're going to want to hold down the center check mark on your steering wheel until the horn beeps twice.
Where is the TPMS sensor reset button?
2:224:04How to Reset Low Tire Pressure Light TPMS. - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd on this car the TPMS reset or set button is located on the left side.MoreAnd on this car the TPMS reset or set button is located on the left side.
Why won't my tire pressure light go off?
If your TPMS light remains on after inflating the tires to the proper pressure, try these steps: Drive the car at 50 mph for about 10 minutes. This should reset the tire sensors, and the next time you start the car the TPMS light should be off.
Why is my tire pressure light still on after filling tires?
If you've added air but the air pressure warning light stays on, there's a problem with your Tire Pressure Monitoring System or you have a slow leak. Assuming there is no leak in your tire, a lit TPMS warning light indicates a problem with a tire pressure sensor.
How do you reprogram a Chevy tire pressure sensor?
After you inflate your tires, drive at 50 mph or above (in an appropriate speed zone) for 10 minutes to reset your sensor. The TPMS light should go away. Before you start your vehicle, turn your key to the “On” position. Once the TPMS light is on, hold the TPMS reset button until the icon flashes three times.
How do you reprogram a tire pressure sensor?
0:595:09How to reprogram your tire sensors! - no more tire light - - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo go ahead turnin truck on or just on the on position go down copy right go down to the tire park.MoreSo go ahead turnin truck on or just on the on position go down copy right go down to the tire park. You'll see that hold. This the check button hold it till it beeps or clicks.
How do you reset the tire pressure sensor on a 2008 Chevy Silverado?
Chevrolet Silverado (2008 - 2012) TPMS Reset ProcedureApply parking brake. ... Press and hold unlock and lock buttons on the keyless entry transmitter until horn sounds, and then LF turn signal will become illuminated.Starting with LF tire, increase/decrease tire pressure until horn sounds.More items...•
How do you reset TPMS without reset button?
You will need to turn all accessories off. Turn the key to the "On" position with the engine off for 20 minutes and then drive the vehicle above 16 mph for at least 7 minutes. Once the relearn procedure is done, the light will go out.
Can AutoZone Check TPMS sensors?
With regular inspection, you can find if your tire pressure monitoring system is corroding or going bad within your wheel, in which case, you need a replacement. AutoZone carries every tire pressure monitoring system product you need for your repair, ensuring you can efficiently and safely cruise down the road again.
How do I fix my service tire monitor?
Answer provided byTurning the ignition to the on position without starting the engine.Locating the TPMS button and holding it down until the alert flashes or disappears.Driving around for a few minutes, turning off the car, and then restarting the engine.
How do I reset my TPMS light?
With the vehicle off, turn the key to the “on” position, but don't start the car. Hold the TPMS reset button until the Toyota tire pressure sensor blinks three times, then release it. Start the car, and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.
How do you reset the tire monitor on a 2008 Chevy Silverado?
Manual relearn with Odometer ResetInflate all tires.Apple parking brake.Turn ignition ON.Push and hold the trip odometer reset step on instrument panel until PRESS (✓) TO RELEARN TIRE POSITIONS is displayed.Push (✓) to confirm.Horn sounds 2x and TIRE LEARNING ACTIVE will display.More items...
Why reset tire pressure sensor on Toyota?
So that is very important to control the tire pressure and be able to adjust it. Low tire pressure increases fuel consumption. Also, because of low pressure the friction road is increased.
How to turn on TPMS sensor?
Place the relearn tool against the tire side wall for starting working at driver’s front tire. Press the button for turning the TPMS sensor on.
How to reset TPMS?
Using the DIC, press the vehicle information button until the RELEARN TIRE POSITIONS message displays. If your vehicle does not have the DIC buttons, press the trip odometer reset stem located on the instrument panel cluster until the RELEARN TIRE POSITIONS message displays. If your vehicle has the DIC buttons, press the set/reset button. The horn will sound twice to indicate the TPMS receiver is ready, and the TIRE LEARNING ACTIVE message will display. If your vehicle does not have the DIC buttons, press and hold the trip odometer reset stem until the horn chirps twice and the TIRE LEARNING ACTIVE message is displayed;
How to tell if TPMS receiver is ready?
The horn will sound twice to indicate the TPMS receiver is ready, and the TIRE LEARNING ACTIVE message will display. If your vehicle does not have the DIC buttons, press and hold the trip odometer reset stem until the horn chirps twice and the TIRE LEARNING ACTIVE message is displayed;
How long does it take to hear a tire pressure increase?
Starting with the left front tire, hold the antenna of the J-46079 against the tire sidewall close to the wheel rim at the valve stem location then press and release the activate button and wait for a sound signal, or increase/decrease the tire pressure for 8-10 seconds then wait for the sound signal. It may take 8-10 seconds until you hear the sound, which means that the pressure increase/decrease time period has been reached;
What is a TPMs system?
Tire pressure monitoring system, or TPMS, – is a feature of many modern cars. It allows to control tire pressure, sitting at your comfort driver’s seat. When the air goes out of the tire, your pressure sensor gives warning and all you need is just to reset it.
2 Answers
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.
john h
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.