Start the Homelite blower, following the manufacturer's directions. Press the primer bulb between eight and 10 times. Move the choke lever to the "Full" position. Press the trigger throttle and pull the starter cord until the engine tries to start but no more than six times.
Full Answer
How do you start a Homelite 2 cycle gas blower?
2:4015:48Homelite 2 Cycle Gas Blower/Vac - YouTubeYouTubeStart of suggested clipEnd of suggested clipIn there's a little Prime button on the side the instructions say it's ten times. So just squeeze itMoreIn there's a little Prime button on the side the instructions say it's ten times. So just squeeze it. Until you start to see the fuel inside the little primer.
How do I start my air blower?
0:342:34How To Start A Leaf Blower - YouTubeYouTubeStart of suggested clipEnd of suggested clipMove the choke lever to the full choke. Position then squeeze the throttle trigger to the fullMoreMove the choke lever to the full choke. Position then squeeze the throttle trigger to the full throttle position and at the same time push in the throttle lock button the blower is now ready to start.
What causes a blower not to start?
Clogged air filters cause the blower's engine to receive too much fuel and not enough air, which often leads to a faulty start (or no start at all). Combustion engines, in particular, need a flow of fuel and air, which enters through the filter and exits through a muffler.
What do you do if your gas leaf blower won't start?
Top 6 Reasons Your Gas Blower Won't StartPrimer bulb wasn't pressed enough. Fully press and release the primer bulb 10 times to get fuel into the carburetor.Fueled up? Make sure the tank has plenty of properly mixed fuel.Old/improperly mixed fuel. ... Check the air filter. ... Engine may be flooded. ... Spark plug issues.
Do you run a blower with the choke open or closed?
To Choke or Not to Choke If your snow blower is cold, you'll want to pull out or turn on the choke while you're starting it. This closes off the air supply to your carburetor, which makes for a much richer fuel mixture. If your snow blower is stored in a heated garage and is warm enough, you should not use the choke.
Where is the choke on a leaf blower?
5. CHOKE - Choke is located on the side of the air cleaner. Move choke lever to "COLD START" ( ) to close choke for cold starting.
Where is the blower reset button?
It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
How do I know if my leaf blower is flooded?
1:315:10Quickly Unflood Any Leaf Blower - Stihl, Husqvarna, Ryobi Etc.YouTubeStart of suggested clipEnd of suggested clipNow some telltale signs that will indicate that your machine is flooded is if you see some fuelMoreNow some telltale signs that will indicate that your machine is flooded is if you see some fuel coming out of the muffler.
How many minutes should a blower operate before starting an engine?
four minutesIf your boat is equipped with a power ventilation system (exhaust blower), turn it on for at least four minutes before starting your engine. This will help eliminate fuel vapors in the bilge. Before starting the engine, sniff the bilge and engine compartment for fuel vapors.
How do you turn on a gas leaf blower?
3:444:53Starting a Gas Leaf Blower - YouTubeYouTubeStart of suggested clipEnd of suggested clipSit the Machine firmly on the ground. Pull twice then move your choke. Position back into run andMoreSit the Machine firmly on the ground. Pull twice then move your choke. Position back into run and the machine should start in the first or second pull.
How do you prime a leaf blower?
0:241:28How to Prime & Choke a Leaf Blower - YouTubeYouTubeStart of suggested clipEnd of suggested clipBulb. Should get the gas primed into the carburetor. And i felt it on my sixth pump there i felt theMoreBulb. Should get the gas primed into the carburetor. And i felt it on my sixth pump there i felt the primer bulb was full of gas and it it pumps them into the carburetor.
Why does my blower stop when I give it gas?
0:052:04Top Reasons Leaf Blower Starts Then Stalls — Leaf Blower TroubleshootingYouTubeStart of suggested clipEnd of suggested clipThe residue that results from old fuel being left in the tank can create a restriction in theMoreThe residue that results from old fuel being left in the tank can create a restriction in the carburetor. This is why you should always use fresh fuel when filling the tank.
Where is the blower reset button?
It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.
How do I start my backpack blower?
BACKPACK: Use your left hand to grip the blower handle and put your right foot against the base plate to secure it in place. Use your right hand to grab the starter handle. Pull starter handle until you feel resistance, then give it a brisk pull. Always guide rope back into the housing.
How do you turn on a backpack blower?
5:5517:29How to Use & Operate a Professional Backpack Gas Powered Leaf BlowerYouTubeStart of suggested clipEnd of suggested clipTo start a cold engine. Set. The stop switch to the start position about one third open put theMoreTo start a cold engine. Set. The stop switch to the start position about one third open put the choke control in the choke. Position press the air purge repeatedly.
How does an air blower work?
Air enters the centre of the impellers, and then is divided between the impeller blades. This increases the volume of the air stream, and increases the speed of the air using centrifugal force. The high-velocity air that is accelerated as a result is then contained in the blower housing, creating pressure.
Defective Spark Plug
Look for signs of wear or damage on the spark plug. Replacing a spark plug is the best solution if the porcelain insulator is cracked or damaged, or if heavy carbon is accumulating at the electrode.
Clogged Carburetor and Carburetor Repair Kit
Sometimes when we try to start up our big leaf blower, it won’t turn on right away. This can be irritating when we need to clear a storm fence or blow off the patio.
Faulty Ignition Coil
Your blower will not start if there is no power getting to the spark plugs. Before replacing a bad ignition coil, make sure all other components work.
Replace Air Filter
The air filter may be clogged. This will cause your engine to run out of air and run out of fuel. As a result, your engine may not start.
Dirty fuel filter
The fuel filter might be clogged. This could happen if the fuel in the leaf blower was leftover from
Spark Arrestor issue
A spark arrestor is a small circular metal piece that covers the end of an engine. Sparks are not expelled from running engines because this part prevents them from doing so.
Recoil starter assembly is not working properly
The recoil starter assembly is the part of the leaf blower that is responsible for turning over the engine and engaging it with the drive mechanism.
