How to Start a Stihl Weed Eater
- Examine the gas tank. This stands as the foremost step you should take. ...
- Press the “On” button. Synchronize the throttle by pressing and holding the spin trigger. ...
- Switch to the choke stance. The device’s choke adjustment comes next. ...
- Lay the cutter flat on the ground. Place the weed eater on the floor now. ...
- Gently pull the starting trigger until friction is felt. ...
Why won't my Stihl weed eater start?
How to tell if a Stihl weed eater is clogged?
How much does it cost to replace a Stihl weed eater air filter?
How many pulls does a Stihl weed eater need?
How to tell if a Stihl trimmer is on?
How much oil to gas ratio for a Stihl weed eater?
What is a Stihl weed eater?
See 2 more
How do you start a flooded Weedeater?
How to Unflood a Weed EaterPut on safety glasses to protect your eyes from fuel.Set a flooded Weed Eater on a flat surface with no obstructions near the cutting head.Allow the engine to cool slightly. ... Place an adjustable wrench on the spark plug and turn it counterclockwise to loosen it.More items...
How do you start a flooded 2 stroke engine?
0:417:02The throttle wide open and then pull it over until it finally starts. This simple method of turningMoreThe throttle wide open and then pull it over until it finally starts. This simple method of turning the choke off and holding the throttle.
How do you Unflood an engine?
Crank the engine with the accelerator pedal pushed to the floor. Continue cranking the engine (for up to 10 seconds) until you hear the engine trying to start. Once the engine's started, allow it to rev up for a second or two, then hold it at a higher than normal idle speed for a few more seconds.
What do you do when your Stihl weedeater won't start?
If you've used the correct procedure to start your Stihl trimmer and it does not start, the problem is likely related to either the spark, the fuel or the air circulation in the combustion chamber. More often than not, it's an easy fix, possibly involving replacement of a spark plug or air filter.
Will a flooded engine not start?
When your engine is flooded it means that there's too much petrol and not enough oxygen in the engine. This makes the spark plugs wet and they won't ignite the fuel. If you've only just moved your car a few metres, it's very common that it won't start immediately.
What causes a 2 stroke to flood?
Flooding is often due to over use of the choke. Once fuel has accumulated in the crankcase it may take some time and effort to clear it. *2-stroke, cold starting procedure: Apply choke > crank engine until you hear a 'pop' from the exhaust > fully open the choke > continue cranking until engine starts.
How long to wait if engine is flooded?
So how do you fix a car flooded with gas? The best way to fix a gas-flooded engine is to open the hood and wait ten minutes before cranking over the engine with the gas pedal flat to the floor until the engine starts.
How long does it take for a small engine to Unflood?
The conventional remedy for a flooded engine is to let it set for 15 minutes or so to give the carburetor time to dry.
How do you start a flooded carburetor?
The conventional remedy for a flooded carbureted engine is to steadily hold the throttle full open (full power position) while continuing to crank the engine. This permits the maximum flow of air through the engine, flushing the overly rich fuel mixture out of the exhaust.
How do you start a 2 stroke Stihl?
2:043:45Including the ground with your right hand pull out the starter grip slowly. Until you feel aMoreIncluding the ground with your right hand pull out the starter grip slowly. Until you feel a definite resistance.
What is the choke position on a Stihl weedeater?
0:001:06Now on this particular model the choke is located on the back of the carburetor on the side. SinceMoreNow on this particular model the choke is located on the back of the carburetor on the side. Since the choke is part of the carburetor you'll find it on most units close to the carburetor.
How do I start my Stihl trimmer cold?
0:241:44Set the choke lever to the cold start or close position if the engine is warm or was just recentlyMoreSet the choke lever to the cold start or close position if the engine is warm or was just recently run set the choke in the open position our unit has not been run so we will start it in the cold.
How do you fix a flooded 2 stroke?
You usually need to take out the spark plug dry it of accumulated gasoline, crank over the engine (Try to start it) with out the spark plug installed, for 30 seconds to blow out and somewhat dry the cylinder of excess gasoline, re-install the spark plug and off ya go running again.
How do you start a 2 stroke flooded dirt bike?
Get a buddy (or two) to push the bike to terminal velocity. Then, pull in the clutch, shift the bike to second gear (third on a big bore) and pop the clutch. Once the bike starts to churn over, keep it moving until you can clean the flooded gas out. Ride it around for a few minutes to clean up the plug.
Does starting fluid work on 2 stroke?
Yes, you can use starting fluid on a two stroke engine, but it must be used with CAUTION. Two stroke engines has OIL mixed with the gas for lubrication of the moving parts of the engine.
How do you make a 2 stroke engine easier to start?
0:093:03Pull until it starts which is usually one or two pulse. Let it run for about five ten fifteenMorePull until it starts which is usually one or two pulse. Let it run for about five ten fifteen seconds choke off ready to go so I'll show you.
How to get a weed eater out of a flooded engine?
Pull the spark plug straight out of the Weed Eater. On a flooded engine, the spark plug is damp on the bottom and smells strongly of gasoline. Step to the opposite side of the Weed Eater, away from the spark plug hole.
How to tell if a weed eater is flooded?
The telltale sign of a flooded engine is the strong scent of gasoline and no fire from the spark plug.
How to loosen a weed eater?
Allow the engine to cool slightly. Grasp the spark plug cap and pull it straight off the spark plug. The spark plug cap is black rubber and attaches to a black rubber coated wire. Place an adjustable wrench on the spark plug and turn it counterclockwise to loosen it. Pull the spark plug straight out of the Weed Eater.
How does a weed eater work?
Weed Eaters have a small gasoline combustion engine with a carburetor that is similar to older vehicles. Gasoline enters the fuel line when you pump the primer bulb before pulling the starter rope. The correct mixture of air and small squirts of gasoline combine in the combustion chamber to start the motor.
How to clear excess fuel?
The technique to clear the excess fuel is an easy one and gets you back to work in a matter of a few minutes. Put on safety glasses to protect your eyes from fuel. Set a flooded Weed Eater on a flat surface with no obstructions near the cutting head.
Can you use old fuel in a weed eater?
Before storing a Weed Eater for the winter, run it to empty the fuel tank. Old fuel can leave varnish deposits and not allow your Weed Eater to start in the spring.
How long does it take for a car to start after a flood?
If you flood your car's engine, you often have no recourse but to wait 10 or 20 minutes for the gas to drain from the carburetor before the engine will start, but that isn't necessary with a string trimmer. A simple procedure should get the engine going without any delay at all.
How to make a carburetor run faster?
To make this process even faster, you can increase the air circulation in the carburetor by removing the air filter. Just remember to replace it as soon as the engine turns over, and the trimmer is operating normally.
Why won't my string trimmer start?
If your string trimmer has a weak spark or the fuel is old, it may not start when you pull the cord the first few times, and it's tempting to keep the choke on or continue pushing the priming bulb until the carburetor has too much fuel.
What is a choke on a string trimmer?
The most common is a choke, which is a lever that partially closes the carburetor to provide a richer fuel mixture than the engine needs while it's running.
Why won't my Stihl weed eater start?
Your Stihl weed eater won’t start if the spark plug is worn out or damaged, and it may need replacement. Most homeowners and professionals can only get 100 hours of work out of a weed eater spark plug. Open the engine casing of the Stihl weed eater and inspect it for visible debris or damage.
How to tell if a Stihl weed eater is clogged?
You’ll be able to tell right away if it is clogged, and if it is, carefully cleans the air filter.
How much does it cost to replace a Stihl weed eater air filter?
If the air filter is damaged or clogged beyond repair, you may have to replace it. You can find replacement air filters for $2-$5, and you slide the new one in the old one’s place.
How many pulls does a Stihl weed eater need?
You can usually get a Stihl weed eater to start with 3-5 pulls, but it varies with everyone. The engine will fire once you’ve pulled the cord enough, and you’ll hear it as clear as day. Stihl weed eater engines are not overly loud, but you’ll hear it rumble and feel the handle vibrate.
How to tell if a Stihl trimmer is on?
Press both levers with one hand and use your free hand to move the starter switch to the “I” marking. The “I” marking signifies “on”, and the switch will need to be in that position for it to properly start. Some Stihl trimmers use the marking “start” instead, but both indicate that the trimmer is turned on.
How much oil to gas ratio for a Stihl weed eater?
The weed eater gas to oil ratio is usually 40:1, but it is 50:1 gas to oil for Stihl units. Slowly pour the fuel into the weed eater and keep an eye on the level so that you don’t overfill it. You can always check the fuel level while using it by removing the filler cap as well.
What is a Stihl weed eater?
Stihl is one of the leading power tool companies, and its products are accessible to any homeowner. Their weed eaters, or trimmers, have helped the curb appeal of countless homes with their precision and power. Many new and proud Stihl trimmers are faced with the question; how do you start a Stihl weed eater?
