How do you do a starter course for shingles?
1:376:00How to Install Starter Shingles - YouTubeYouTubeStart of suggested clipEnd of suggested clipSingle be sure to notice that your actual shingle length is approximately. The same it's about anMoreSingle be sure to notice that your actual shingle length is approximately. The same it's about an inch difference. But if you start with a full starter strip shingle.
How do I start my first row of architectural shingles?
1:113:33How to Install the Architectural Shingles - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst install a starter strip of shingles under the first course at the bottom edge.MoreFirst install a starter strip of shingles under the first course at the bottom edge.
What is the first course of shingles called?
Every roof has to start somewhere, and that somewhere is at the appropriately named starter shingle (also called starter strip). Starter shingles are the initial shingle products installed on the roof, just before the first course of the finish shingles, which will comprise the visible parts of the roof.
How many starter shingles do I need?
Three bundles to a square is most common, which applies to most three-tab strip shingles and some lightweight laminated shingles. Heavier three-tabbed shingles and laminated shingles require four, or sometimes five, bundles to cover a square.
How do you nail down architectural shingles?
2:053:50How to Nail Roof Shingles - IKO - YouTubeYouTubeStart of suggested clipEnd of suggested clipKeep the nail straight 90 degrees from the shingle surface. This is to avoid the nail head cuttingMoreKeep the nail straight 90 degrees from the shingle surface. This is to avoid the nail head cutting through the shingle.
Are you supposed to remove the plastic strip on the back of shingles?
The film strips on the back of each shingle are to prevent sticking together of the shingles while in the bundle. Their removal is NOT required during application.
Why do I need a starter strip for shingles?
The starter strip is crucial because it adheres to the shingles on the edges of your roof and protects them from the elements. Without starter strip shingles, a gust of wind would have no trouble sneaking under the shingles on the edges of your roof and blowing them up, and perhaps even off, your roof.Sep 1, 2017
How do you stagger shingles on a roof?
The trick to laying asphalt shingles is to stagger the seams between courses. Begin shingle application at the lower left rake of roof. Continue the first course across roof with full shingles laid flush with the starter strip and fastened with four nails, placed as specified.Feb 9, 2015
How do you keep shingles straight?
Keeping the Roofing Line Straight e shingles aligned vertically and horizontally. A chalk line can keep your line straight over long distances and large areas. A chalk line can help eliminate short exposures, waviness and additional antithetical issues.
Do you install starter shingles on the rake?
Applying starter strip shingles should fall on your roof's eaves and gables or rake edges. Applying it on the eaves helps cover the joints between the finished shingles to provide waterproofing. Installing a starter shingle on your gables carries a different function from using it to the eaves.
Are starter shingles required on rakes?
The starter shingle's two purposes are water protection and wind protection at the eave and rake. A starter shingle is used to seal with the field shingle at the first course along the eave and rake. This helps prevent wind and water from getting beneath the shingle in this critical location.Sep 28, 2018
How much does 1 bundle of starter shingles cover?
approximately 105 lineal feetStarter Strip shingle is designed to be broken into two pieces, and each piece has its own sealant strip. When separated, each starter shingle is 65 ⁄8" x 393 ⁄8", and each bundle will cover approximately 105 lineal feet. See Fig. 1.