- Position a stepladder in the room to reach the ceiling while applying compound and tape.
- Begin on one side at one end of the ceiling to apply joint compound to the butt joints, those running along the long sides of the drywall.
- Tape the butt joints by placing the end of the tape at one end of the joint and stretch it across the joint.
- Scrape the excess compound and air from under the tape with the drywall knife. ...
What tape sticks best to drywall?
- BEST OVERALL: Duck Brand 282083 Drywall Joint Tape
- BEST BANG FOR THE BUCK: LYLTECH Drywall Joint Tape
- BEST FIBERGLASS MESH: Saint-Gobain ADFORS FDW6581-U FibaTape Drywall Tape
- BEST MOLD RESISTANCE: FibaFuse FDW8201-U Paperless Drywall Tape
- BEST FOR CORNERS: STRAIT FLEX SO-100 Original Composite Tape
How to finish drywall in 9 steps?
Instructions
- Prepare the Surface. ...
- Apply the First Mud Coat (Paper Tape) If you are using paper tape, it must be embedded in a layer of compound, and thus the process takes slightly longer than ...
- Apply the First Mud Coat (Fiberglass Tape) Fiberglass-mesh tape is self-adhesive and can be applied directly to the drywall seams without first applying a layer of mud.
How to finish drywall for beginners?
Project Overview: how to finish drywall
- Tips Before Taping: Making the joints in freshly hung drywall disappear behind a smooth, flawless taping job will try your patience.
- Check for underdriven screws and nails. ...
- Tap nails slightly below the drywall face. ...
- Trim away loose, torn paper with a sharp utility knife. ...
- Spray a stain-blocking primer. ...
- Nail metal corner bead. ...
Should you drywall the ceiling before the walls?
Yes, you should install drywall on the ceiling before the walls for multiple reasons:
- The drywall on the walls can support the ceiling pieces
- You can create tight and fitted corners more easily
- The pieces are easier and faster to work with from the top
Do you tape drywall between wall and ceiling?
All it takes is a quick patching job with fiberglass mesh tape. You can then proceed with normal joint taping techniques, using drywall joint compound, which drywall professionals refer to as mud. In the end you'll create a seamless looking joint between wall and ceiling that conceals the gap completely.
How do you fill the gap between drywall and ceiling?
How to fill a gap between drywall and ceilingStep 1: Mesh drywall tape. Start by placing a strip of fiberglass mesh drywall tape over the gap so that the top edge of the tape is flush against the ceiling.Step 2: Apply joint compound. ... Step 3: Paper tape. ... Step 4: More mud. ... Step 5: Let the mud dry. ... Step 6: Sand. ... Step 7: Paint.
What is the best way to tape drywall?
2:213:29How to Tape Drywall Seams - YouTubeYouTubeStart of suggested clipEnd of suggested clipWith my fingers the entire length just at intervals of approximately or two feet I've got the tape.MoreWith my fingers the entire length just at intervals of approximately or two feet I've got the tape. Put into place now I need to embed it nice and tight.
Do you tape ceiling joints?
0:007:35Taping Drywall Ceilings - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's just kind of lightly in place so i'm going to press it in a minute with my taping.MoreIt's just kind of lightly in place so i'm going to press it in a minute with my taping.
How do you tape drywall ceiling corners?
0:426:27How to tape and finish a inside drywall corner - YouTubeYouTubeStart of suggested clipEnd of suggested clipUse the knife to scoop the mud out of the bread pan scoop it from both sides of the knife use theMoreUse the knife to scoop the mud out of the bread pan scoop it from both sides of the knife use the knife to scoop out the mud one side for the ceiling. And the other side for the wall.
Is mesh or paper tape better for drywall?
Most drywall tradesmen will say that paper tape is stronger than mesh drywall tape. Paper tape is better at preventing cracking along drywall seams. Paper tape folds easily and therefore is easily applied to corners to allow for crisp inside 90° corners. Paper tape can be applied with all purpose drywall compounds.
What happens if you don't tape drywall?
If you apply joint compound to drywall seams without tape, the compound will squeeze through the seams, wasting your time and resources. Joint compound used to fill seams between sheets of drywall will shrink and crack as it dries. Joint compound without tape will crack and fall out over time.
Do you overlap drywall tape in corners?
It's still possible to create a wavy corner if you push too hard, so apply light, even pressure as you smooth the joint compound. The strips reduce ripples and bubbles too, so there's no need to wet the tape. Don't overlap the tape where inside corners meet the ceiling.
How to smooth out drywall tape?
Hold the knife at a 25-degree angle; place it in the middle of the joint and smooth out the ceiling tape in one stroke, pressing it into the joint compound as you go. Wipe off the excess and do the same thing in the other direction. The last part of the process is finishing the drywall ceiling corners.
How to muddle drywall?
To begin the mudding process, experts from This Old House recommend putting about 2 inches of joint compound on the knife blade. Start in one corner, and push the compound into the joints in between the drywall panels. Fill them up completely, turn the knife to a 25-degree angle, and smooth out the compound. Scrape off the excess as you work.
How to get drywall mud off?
You should tape it off while the drywall mud is still fresh. Unroll about 3 feet of tape, but don't cut it yet. Center the length of tape over a seam, and press it carefully into the moist compound. Roll out more tape and press it into the rest of the joint. When you reach the end, cut off the tape with your knife.
Can you hang drywall on your own?
The team at Bob Vila explains that unless the room has very high ceilings or is very large, homeowners should be able to hang drywall on their own. However, writers from This Old House recommend that you ask someone to help you drywall a ceiling; it's really a two-person job.
How to tape a banjo?
While you have the banjo in your hands, stick tape onto several joints at once, and then press the tape flat onto the joints with a 6-in. knife and tool off any excess mud. After all the joints are covered, apply and flatten the tape over corner-bead edges.
How to keep mud from drying out?
To keep the mud from drying out as you work, loosely cover the pails. At the end of the day, wipe down the insides of the pails and the bottom of the lid with a sponge to remove any deposits. Otherwise, dried chunks of mud will fall into the mix and you'll discover the little troublemakers when you're spreading mud.
How to make a corner bead?
Clinch corner beads into place with a clincher. Run a 6-in. putty knife along the bead and adjoining drywall (on both sides) to make sure you've left a void to fill with mud. Then anchor the corner beads through the drywall into surrounding framing with 1-5/8 in. drywall nails spaced every 8 in. Drive extra nails into edges that don't lie flat.
How many pails of mud for 12x12?
All-purpose is designed to be used for all three coats in the typical three-coat taping system. A 12 x 12-ft. addition will require about two 5-gallon pails of mud.
Why does drywall tape come off the ceiling?
Moisture. Another potential cause of drywall tape separating from a ceiling is moisture/humidity. This is especially common in bathrooms because of the presence of steam and moisture. Steam from a hot shower will rise and congregate around the ceiling, and over time this may begin to compromise the tape’s seal.
What is the skill of drywalling?
Drywalling is a skill that requires not only knowledge but a certain sense of touch and feel. As such, it takes a long time to get the hang of it, and for those who are new or inexperienced, it may seem intimidating.
