
How to Install Gila Window Film
- Step 1: Clean the Window Exterior ...
- Step 2: Rinse the Window Exterior ...
- Step 3: Clean the Window Interior ...
- Step 4: Cut the Film to Fit ...
- Step 5: Apply Tape to the Film ...
- Step 6: Wet the Film and Window ...
- Step 7: Remove the Film Lining ...
- Step 8: Apply the Film ...
How to apply home window film?
Steps
- Clean the window. Clean the window thoroughly with an ammonia-based window cleaner and wipe it dry using a squeegee. ...
- Wet the glass with a light spray of water and baby shampoo. Fill a spray bottle with water and add a couple of drops of baby shampoo. ...
- Measure and trim the film to size. ...
- Put the window film onto the window. ...
How do I apply frosted window film?
- You are supplied with bubble free frosted window film. ...
- Apply the window film with the application-tape to the window, position it at the preferred location.
- Use your supplied free squeegee. ...
- Check to see if there is still any air trapped between the window film and the window itself. ...
- Allow the adhesive enough time to stick to the window. ...
How to measure for window film?
- MAKE A LIST OF WINDOWS YOU WISH TO COVER WITH FILM
- MEASURE EACH WINDOW BY BOTH LENGTH AND WIDTH, ADDING 1/2″ TO EACH MEASUREMENT (A BIAS IS REQUIRED FOR INSTALLATION PURPOSES)
- MEASURE AGAIN, JUST TO BE SURE!
- CALCULATE THE NUMBER OF LINEAR FEET OF WINDOW FILM YOU WILL NEED TO COMPLETE THE JOB
- PLACE YOUR DIY WINDOW FILM ORDER ONLINE
Can you put window film on a ceiling?
Window film must be adhered to double sided tape, usually attached to the side of the interior window trim. Then it is usually heated with a hair dryer on high to tighten it. Assuming you have no issue with the double sided tape on the ceiling, there's no reason you can't do it. Use 1/2" wide tape for the least visible tape line.

Do you put Gila window film on inside or outside?
A: All Gila Window Films are safe for dual pane windows if used correctly. Most can be applied to the inside of dual pane windows with the exception of Glare Control and Privacy Control Black (outside only).
Which side of Gila Window Film goes against glass?
Spray the inside of the window as well as the recently trimmed tint generously with the application solution. Wet your fingers with application solution then carefully lift the film from the outside of the glass. Place the wet side of the film against the wet inside glass.
Can I use water to apply Gila Window Film?
A: If Gila Application Solution is not available, you may use a mixture of water and no tears baby shampoo (without conditioner). Mix one quart of water and ¼ teaspoon of shampoo in a spray bottle. Other liquid soap products contain ingredients that may reduce the effectiveness of the film's adhesive.
How do you apply a Gila tint?
3:465:03Gila Auto Film Installation - SUV Side Window - YouTubeYouTubeStart of suggested clipEnd of suggested clipWorking your way down the window to the horizontal. Midpoint once secured roll up the window. AfterMoreWorking your way down the window to the horizontal. Midpoint once secured roll up the window. After the top edge is secured wet the window again slip the bottom of the tint into the window gasket.
How do you use Gila window film without solution?
0:031:02Gila® Application Solution Substitute Recipe - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe window film application solution included in your HeLa complete window film application cat wasMoreThe window film application solution included in your HeLa complete window film application cat was formulated to optimize cleaning and film application it was also formulated so that you can easily
Which side of window film faces out?
On a flat, clean work area, unroll the film with the liner side facing up. Mark and cut the film 1 inch wider and 1 inch longer than the window you plan to cover. Some static cling-on film has a backing that doesn't adhere to the film.
Can I use Windex to apply window film?
Window cleaner can be used on decals and small areas of film but it dries too fast for large films. Most films come with an application smoothing tool but any plastic credit card will work equally well.
How long does it take for Gila Window Film to dry?
7 to 10 daysYou have successfully applied your GILA Window Film. The film will fully "cure" over the next 7 to 10 days. Dry, sunny weather speeds curing. Any remaining small bubbles should disappear during this time.
Can you use dish soap to install window film?
o For wetting solution, use a solution of mild dish soap (i.e., Dawn® or Joy®) and water. For a 32oz. spray bottle, add 4 to 5 drops of soap.
Can Gila window film be removed?
Remove old window film from the windows of a car or truck with the Gila Automotive Window Tint Removal Kit. It features an easy-to-use tool that scrapes without leaving scratches behind to make the process effortless.
How do you make window film stick?
Before Applying Window Film The cleaner the surface, the longer the adhesive-free film will cling to the window or wall. Use a squeegee to pull off fine dust after you have thoroughly cleaned the window. Make sure the surface is completely free of soap or cleaner residue before applying the film.
How do you prep your windows for tint?
Clean the glass thoroughly with glass cleaner and a scrub sponge. It's imperative the glass be completely clean because dirt and dust will cause the tinting film to bubble. Dry with a squeegee and a low-lint cloth. Wipe down the gaskets and clean as far into the gap between the gasket and the glass as possible.
How do you stick window film corners?
0:000:55Correcting Mistakes - YouTubeYouTubeStart of suggested clipEnd of suggested clipAny debris with clean fingers spray. The film underside with application solution then respray theMoreAny debris with clean fingers spray. The film underside with application solution then respray the surface. And allow the lifted section to flow back down onto the window smooth.
Does Gila Window Film help in winter?
An Overview On Gila Heat Insulation Privacy Film This is a type of micro-thin polyester or vinyl film that you can put on your windows, which helps to keep your home cool in the summer, warm in the winter and enhance privacy without the use of curtains or blinds.
What can I use instead of tint solution?
Some tinters swear by mixing a few drops of dish washing liquid soap into a spray bottle full of water, and coating the window with the solution.
What is the best way to apply window film?
4:428:44How to apply Window Film - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce the release liner is removed spray the film thoroughly with a soap. Solution also spray theMoreOnce the release liner is removed spray the film thoroughly with a soap. Solution also spray the center of the clean glass. Do not spray the edges.
Does window film Reduce heat?
Eliminate excessive heat. While curtains and blinds are great for privacy and help to block some heat, they do so at the cost of natural light. 3M™ Window Films can reduce up to 78% of the sun's heat coming through your windows, to help make your home bright and comfortable, all day long.
Can cats see through window film?
Can Cats See Through Tinted Glass? Cat's cannot see through tinted windows because they don't have enough cone cells in their eyes. That is critical for differentiating between various colors. According to Experimental Eye Research, feline vision is akin to red-green colorblindness in humans.
How do you stick window film corners?
0:000:55Correcting Mistakes - YouTubeYouTubeStart of suggested clipEnd of suggested clipAny debris with clean fingers spray. The film underside with application solution then respray theMoreAny debris with clean fingers spray. The film underside with application solution then respray the surface. And allow the lifted section to flow back down onto the window smooth.
How do you make window film stick?
Before Applying Window Film The cleaner the surface, the longer the adhesive-free film will cling to the window or wall. Use a squeegee to pull off fine dust after you have thoroughly cleaned the window. Make sure the surface is completely free of soap or cleaner residue before applying the film.
Does Gila Window Film help in winter?
An Overview On Gila Heat Insulation Privacy Film This is a type of micro-thin polyester or vinyl film that you can put on your windows, which helps to keep your home cool in the summer, warm in the winter and enhance privacy without the use of curtains or blinds.
Can window film be applied outside?
While most window tinting films are designed to be used inside, exterior window films are also available. Window films are incredibly versatile products and while they commonly provide interior solutions for privacy, sunlight or decorative purposes they can also be applied outside.
Can you use Gila window film on wet glass?
Try using it liberally, not only for keeping glass surfaces wet while you work, but also for cleaning them up before you begin. You’ll be pleased with what you see, whether you’ve chosen standard film or static cling film.
Can you add videos to your watch history?
Videos you watch may be added to the TV's watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Why put a gila film on a window?
Putting Gila film on large windows helps cut glare. Large windows provide an unobstructed view, as well as letting in plenty of sunlight. As with all good things, you can sometimes have too much. If you can see out, chances are that people can see in, and you can have times where you are flooded with too much sunlight.
How to clean Gila filmed windows?
Clean your Gila filmed windows with Gila application solution or glass cleaner and a squeegee. Wipe them down with a clean cloth to dry them.
How to clean a window with a squeegee?
Wet down the window with clear water. Hold the squeegee blade at a 45-degree angle to the window and drag it down the glass, scraping off all of the water as you go. Wipe the squeegee blade with a clean shop cloth and repeat until the outside of the window is completely clean.
How to remove a lining from a gila film?
Pull the tape apart to separate the clear lining from the Gila film. Have your helper hold the film flat as you peel the liner away, spraying the newly exposed side of the Gila film with the Gila application solution as you go. Do not let the exposed liner fold back on itself, or it will stick.
How to separate Gila film from clear film?
Attach two strips of clear tape about 3 to 4 inches long to one corner of the film. Put one of them on the side of the film that is facing up, and one on the side facing down. Press the tape firmly to the film on each side, and then quickly pull the pieces of tape apart from each other. This will separate the clear lining from the Gila film.
How to shrink glass?
Trim away the excess film at the three edges of the window, leaving a one-sixteenth of an inch gap between the edge of the film and the window frame. Cut a one-sixteenth of an inch strip away from the factory edge on the fourth side. Glass expands and shrinks in different temperatures, so this gap is necessary.
Can you leave the liner on film?
Leave the liner on the film with the tape pieces attached, for now.
What is Gila security film?
Give vulnerable areas an invisible layer of added protection with Gila Safety & Security Film. It strengthens glass to help safeguard against intruders, accidents and scratching.
What is decorative gila?
A luxurious alternative to expensive window treatments, Gila® Decorative Filigree Window Film is both beautiful and cost-effective. Film’s precise application won’t block natural light or hide window frames like drapes, shades or sheers. Gila Filigree Window Film lets in the sun’s natural warmth and looks great. Easy-to-handle and designed for DIY projects, it’s the perfect choice for homes, offices and small businesses alike. Static cling technology attaches to any flat glass surface—try it on doors, cabinet fronts and tabletops, too.
Why install Gila windshield strip?
Install Gila’s specially sized windshield strip to give your eyes a rest from annoying road glare. It’ll make your shades more of a style statement and less of a driving essential.
How wide is Gila roll?
Thinking about what you look like from behind? No problem. Gila’s 6-inch-wide rolls are made to hug the curves of back windows, so your custom look includes the rear view.
Can you have glass without a designer?
You can have glass with sun protection, cooling properties or a dramatic look, even without an interior designer or a luxury car. Gila® Window Film transforms home and auto glass in just an afternoon, at a reasonable price. Our DIY products are made for professional results, with precise standards and advanced technology.
What is included in window film application kit?
DIY projects should be satisfying, not frustrating. Our Complete Window Film Application Kit contains 4 items to help with exactly that: a generously sized bottle of application solution, a hard plastic card to smooth bubbles, a lint-free cloth to whisk away debris without leaving more behind, and a trimming tool made for safety and accuracy.
Can you add videos to your watch history?
Videos you watch may be added to the TV's watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
What is Gila heat control?
Gila Heat Control Window Films aren’t quite that scientifically advanced, but they do give you the power to cool down hot spots, reduce glare and protect furnishings from UV rays. And unlike blinds or drapes, they give you clear views, allowing in natural light while enhancing comfort.
Does Gila tint look mirrored?
Less Reflection Window tints can look mirrored from inside or out, depending on time of day. Gila’s Low Reflective and 3-in-1 product reduces this effect.
Can you add videos to your watch history?
Videos you watch may be added to the TV's watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
