How far from the wall should a toilet flange be?
The Distance To Set The Toilet Flange From The Back Wall. You'll want to set the center of the water closet flange 12 inches from the finished back wall. Don't measure from the base molding!
What is the rough-in distance for a toilet?
12 inchesThe toilet rough-in refers to the distance from the finished wall to the center of the toilet's floor drain or waste outlet. Most toilets have a rough-in of 12 inches, although it's not uncommon for older homes to have an unusual size such as 10" or 14".May 5, 2017
Is a toilet supposed to touch the wall?
There is no hard-fast rule about whether a toilet should touch the wall, as it is a matter of personal preference. Some people are okay with a toilet tank's top touching the back wall, while others desire a minimum of one inch of space between the commode and the back wall.May 6, 2021
How do I know if my toilet is a 10 or 12 rough?
If the old toilet is still there, measure from the center of the capped bolts (on the bottom) to the wall (not the baseboard). There should be 24 inches of clearance from the wall facing the bowl and 15 inches on each side as a guideline. If your measurements are between 11.5 and 12.5 inches, it is a 12-inch rough-in.
Can you replace a 10 inch rough-in toilet with a 12-inch rough-in toilet?
The rough-in for your bathroom plumbing should match the rough-in for the toilet. Even if a toilet is designed for a 10-inch rough-in, you can still install it in a space with a 12-inch rough-in.
Should there be a gap between toilet bowl and tank?
Most toilets have a space between the bottom of the tank and the top of the bowl anywhere from a ¼ of an inch to a ½ inch. Tighten too loosely and the tank will leak underneath the rubber washers and down the bolts; tighten too much and risk the tank cracking.Sep 14, 2015
Do toilets have to be on external wall?
Chances are if you are asking yourself this question you may have been told by your builder or designer that the toilet needs to be placed against the outside wall. While there are good reasons to do so, it is not always necessary. In fact, many bathroom layouts have the toilet set against an internal wall.
What size is a standard toilet?
Although 12” is the standard size, some toilets also feature a 10” and a 14” rough-in. It’s important to know specifically what your toilet’s rough-in size is before you calculate the distance from the flange to the back wall.
How far should a toilet flange be from the vanity?
You can add more space if you want, but 15” is the very minimum. This means the toilet flange should be 15” from the vanity, the shower, the tub, and both the back and side walls. Just like before, if your wall has ½” drywall, you’ll need to add a ½” to the overall length.
How accurate is a toilet rough in?
The measurements listed above are for your basic toilet featuring a 12” rough-in. If you’re unsure if your toilet has a 12” rough-in, you can look in the owner’s manual.
How far should a water closet flange be from the back wall?
The center of the water closet flange should be 12-inches from the back wall. When you measure this distance, make sure you measure from the finished wall and not the base molding. Another thing you need to consider is the thickness of your back wall. If you used ½” drywall, add an extra ½”.
What is rough in distance?
They include: The proper distance from the back wall to the toilet flange. The correct amount of space on both the right and left side of the toilet. The right amount of space in front of the toilet bowl.
How much space should be between side of toilet and wall?
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.)
What is the rough in distance for a toilet?
The toilet rough-in refers to the distance from the finished wall to the center of the toilet’s floor drain or waste outlet. Most toilets have a rough-in of 12 inches, although it’s not uncommon for older homes to have an unusual size such as 10″ or 14″.
Is a toilet supposed to touch the wall?
No, there is no standard distance a toilet tank should set out from the wall. There are standard rough in distances, the most common is 12″ with a few at 10″ and a few at 14″, but the actually distance the tank will be from the wall will vary. Yours is quite normal.
How Far From wall is toilet UK?
Toilets should be placed with 37/5 cm (15 inches) of distance between the side walls and the centre line of the toilet. Popular building advice also recommends 52.5 cm (21 inches) of clear space from the front edge of the toilet to the front wall, allowing leg room for individuals seated on the toilet.
Why is my new toilet so far from the wall?
When toilet flanges are installed it is typically in the early stages of the project and the standard 12 ” measurement is taken from the drywall, rather than the finished tile surface that you are measuring from. That means your flange was set at a distance further from the wall than even the 13″ you measured.
How do I know if my toilet is a 10 or 12 rough?
If your toilet has four bolts rather than the standard two, you’ll measure to the center of the rear bolts. The standard rough-in measurements are 10, 12 and 14 inches. If your measurement is in between these intervals, round your number down to the nearest standard measurement.
Can you replace a 10-inch rough in toilet with a 12-inch rough in toilet?
The rough-in for your bathroom plumbing should match the rough-in for the toilet. Even if a toilet is designed for a 10-inch rough-in, you can still install it in a space with a 12-inch rough-in.
How far away should I install a toilet?
How Far From the Wall Should I Install a Toilet? Hunker may earn compensation through affiliate links in this story. Toilets should be around 12 inches away from the wall. When designing or renovating a bathroom, you'll need to know the toilet rough-in placement and measurement.
How far should a toilet be from a shower?
It's typically required that toilets be a minimum of 15 inches from any side wall, shower or tub. This distance is always measured from the center of the toilet bowl. However, if you have a bidet next to the toilet, there should be a minimum of 30 inches between them. In front of the toilet, it's recommended you have a minimum of 24 inches, ...
How far should a floor trap be from the wall?
The trick is that this rough-in measurement varies, depending on the toilet style, but it's typically between 10 and 14 inches. Advertisement.
What to consider when updating a bathroom?
If you're just designing the bathroom, consider your floor space and distances before you choose your toilet, because it makes a big difference in a small bathroom.
Measuring for Toilet Placement
When you are roughing in a toilet for your bathroom, there are four important measurements to ensure comfort and a proper setup of your plumbing.
How Far is Too Far
Building codes identify the placement of toilets and other fixtures in bathrooms. Ideally, the center of the toilet bowl should be 15” from the wall behind the tank of the toilet and from the walls on either side. You should have at least 24” between the front of the toilet bowl and facing wall.
ADA Compliance
If someone in your family has limited mobility, toilet placement needs to meet the requirements of the Americans with Disabilities Act (ADA). According to ADA regulations, toilets must be:
What to Do If the Toilet is Too Far from the Wall
There are two ways to fix a toilet that is too far from the wall – with an offset flange and relocating the waste pipe.
Other Ways to Use an Offset Flange
Offset flanges not only move a toilet closer to the back wall, but the hardware can also be used to move a toilet in any direction. Some of the most common problems that can be fixed with an offset flange are:
Problems That Require Moving the Waste Pipe
Unfortunately, there are some toilet problems that can only be fixed by moving the waste pipe rather than installing an offset flange. Offset flanges will only move the toilet about 2” in any direction. If your toilet needs to be moved more than 2”, the plumbing needs to be rerouted.
Related Questions
Move the toilet paper dispenser to part of the wall that is closer to the seat. You can mount it on a wall to the left or right, or in front of the toilet. Another option is to buy a freestanding toilet paper dispenser.
How far from the wall should a toilet flange be?
If you’re simply replacing your toilet, and notice the center of your flange is only 10 inches from the wall, there’s no need to go through the hassle of moving the flange. Just get a water closet with a 10″ rough-in. Or suppose you’re roughing in a toilet and there’s a floor joist in your way.
What are the sizes of toilets?
However, it’s useful to know that toilet’s also come in: 1 10-inch rough-in. 2 14-inch rough-in.
How much clearance do you need for a toilet?
So looking at the toilet, make sure there are at least 15 inches of clearance from the center of the toilet to any adjacent fixture (or wall). To the left…. And the right…. For example: If a bath vanity is next to your toilet, you’ll need 15″ of clearance. If a tub is next to your toilet, you’ll need 15″ of clearance.
What is the rough in size of a toilet?
This information can be found on the toilet’s specification sheet. 12 inches is the most common toilet rough-in size. However, it’s useful to know that toilet’s also come in: 10-inch rough-in. 14-inch rough-in.
How high above the floor for escutcheon?
A lot of times the water line comes in too low and requires notching the trim. Needless to say, this usually turns out UGLY. 7 inches above the finished floor allows enough clearance for an escutcheon, and base trim all the way up to 5.25″.
Can you shut the door when using a toilet?
The answer is no. The purpose of this clearance is to allow enough space for a person to use the toilet comfortably. Luckily, people shut the door when using a toilet. And as long as you have 21″ (or 24″) of clearance when the door is shut you’re good to go (literally). The final measurement is….
