How far apart should receptacles be in a garage?
The number of outlets depends on the size of the room; the general recommendation is to install the outlets from 3 feet to 5 feet apart throughout the whole garage.
Where should outlets be placed in a garage?
Standard outlets are spaced apart, a foot or so above the floor. If you plan on adding workbenches along the walls, you'll also want outlets at the same above-the-counter height as in a kitchen. This way, you won't have to drop a cord behind the bench top.
What is the code for garage outlets?
210.52(G)(1) Garages. In each attached garage and in each detached garage with electric power, at least one receptacle outlet shall be installed in each vehicle bay and not more than 1.7 m (5 ½ ft) above the floor.
How many outlets can be on a 20 amp circuit in a garage?
ten outletsThe answer to the question how many outlets on a 20 amp circuit is ten outlets. Always comply with the 80% circuit and breaker load rule, allowing a maximum load of 1.5 amps per receptacle. Remember that your circuit, wire sizes, and outlets must be compatible to avoid overheating and electrical hazards.
Do all outlets in a garage need to be GFCI?
GFCI protection is required for 125-volt to 250-volt receptacles supplied by single-phase branch circuits rated 150 volts or less to the ground. GFCI receptacles are required in bathrooms, garages, crawl spaces, basements, laundry rooms and areas where a water source is present.
Does a garage need 20 amp outlets?
Not all dwelling units have a garage. For those that do, whether attached or detached, if the garage is supplied with electric power, at least one 120-volt, 20-ampere branch circuit must be installed to supply garage receptacle outlets.
How many outlets can be on a 15 amp breaker?
8 outletsTechnically, you can have as many outlets on a 15 amp circuit breaker as you want. However, a good rule of thumb is 1 outlet per 1.5 amps, up to 80% of the capacity of the circuit breaker. Therefore, we would suggest a maximum of 8 outlets for a 15 amp circuit.
Do I need a breaker for garage?
For most garages, you will want to use a 50 amp breaker with 8/3 wire between the two buildings to handle the load. Install a sub-panel with its own main breaker so that the power can be shut off inside the garage for servicing the breakers in the panel.
Why are garage outlets higher?
The mechanical code requires appliances having an ignition source shall be elevated such that the source of ignition (spark) is not less than 18" above the floor of a garage. Yes, this is a residential garage. "Spark" is part of the definition of ignition source in the mechanical code.
Does a garage need 20 amp outlets?
Not all dwelling units have a garage. For those that do, whether attached or detached, if the garage is supplied with electric power, at least one 120-volt, 20-ampere branch circuit must be installed to supply garage receptacle outlets.
Can Romex be exposed in a garage?
As electrical wirings are found everywhere homeowners often wonder – can Romex be exposed in the garage? The short answer to the question is – no, you should never expose your Romex wiring in your garage. You should always cover Romex wiring on your property.
What is the NEC code for outlet height?
Electrical receptacle outlets on branch circuits of 30 amperes or less and communication system receptacles shall be located no more than 48 inches (1219 mm) measured from the top of the receptacle outlet box nor less than 15 inches (381 mm) measured from the bottom of the receptacle outlet box to the level of the ...