what do you need to fix a hole in the wall

To fix a hole in a concrete wall, you will need:

• Dust mask
• Safety googles
• Putty knife
• Wire brush
• Rubber or latex gloves
• Bonding agent
• Brush
• Mortar mix
• Trowel

Full Answer

How do you repair a hole in the wall?

If playback doesn't begin shortly, try restarting your device. Videos you watch may be added to the TV's watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

How to repair a small hole in the wall?

Steps

1. Gather your tools and materials. Below are all of the tools and materials you'll need to complete this project.
2. Clean the area. This could get messy, so best to place a drop sheet down to protect your carpet. ...
3. Apply the patch. ...
4. Apply your plaster. ...
5. Wait for the first coat to dry. ...
6. Add another coat of plaster. ...
7. Paint. ...

How to fill a hole in your wall?

How to fill deep holes in wall

• Clean the hole making sure you remove all loose materials. ...
• Use a flat edged filling tool to push the filler into the crack. ...
• Smooth it with a wet knife.
• Check the instructions to see how long it takes to dry – this should typically be around one or two hours.
• Once dry, sand it down so it’s smooth with the wall.

More items...

How to fill deep holes in a wall?

How to fill deep holes in wall. For deep holes, you’ll need a filler that works specifically for that depth as many are surface fillers. Deep fillers are tougher than hairline fillers and designed to stop the problem worsening. Clean the hole making sure you remove all loose materials. You can do this with the edge of a scraper or a fine brush.

What materials do you need to fix a hole in the wall?

Materials: For this job you'll need a scrap piece of drywall, furring strips, joint tape, drywall screws, and joint compound.Cut out a square piece of new drywall that's slightly larger than the hole.Put this piece on top of the area that needs to be patched, and trace around it with a pencil.More items...

What is the fastest way to fix a hole in the wall?

0:311:30How to Fix a Hole in the Wall // Drywall Simple and Easy - YouTubeYouTubeStart of suggested clipEnd of suggested clipI used a carpenter square to mark the wall for a straight cut and use a razor blade to score alongMoreI used a carpenter square to mark the wall for a straight cut and use a razor blade to score along those lines. I then use a small cell to cut from the center of the hole to each corner.

How do you fix a wall that has a hole in it?

0:332:23How to Repair Drywall - How to Fix a Hole in the Wall - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou may want to use a sole to cut all the way through but be careful with any wires or pipes thenMoreYou may want to use a sole to cut all the way through but be careful with any wires or pipes then carefully grasp one side and bend it inward. Making sure to pivot.

What kind of putty is used for drywall?

0:487:00How To Fix A Small Hole In Drywall Or Plaster With Putty (Spackling ...YouTubeStart of suggested clipEnd of suggested clipThis is pink spackling compound because it turns white when it has dried okay but spackling compoundMoreThis is pink spackling compound because it turns white when it has dried okay but spackling compound can be any color so don't be alarmed if yours is yellow.

What is a drywall patch?

0:033:09How to Repair Drywall - YouTubeYouTubeStart of suggested clipEnd of suggested clipLet it dry then add another coat of compound if necessary a great fix for holes 6 inches and smallerMoreLet it dry then add another coat of compound if necessary a great fix for holes 6 inches and smaller is called the California patch.

How do you use a wall repair kit?

0:523:19Drywall Repair: How to Fix a Hole in the Wall - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou got to prepare the wall that's the pro trick get a knife you could get a razor knife or sharpMoreYou got to prepare the wall that's the pro trick get a knife you could get a razor knife or sharp knife. And just get all the loose stuff out of there now the patch has something to stick to.

How do you repair a hole in the wall without your parents knowing?

1:369:10I was mad and punched the wall! How to repair hole in wall tutorialYouTubeStart of suggested clipEnd of suggested clipWhat you want to do is you just want to peel off the paper backing first which has directions onMoreWhat you want to do is you just want to peel off the paper backing first which has directions on every patch all you want to do is place it centered on the hole. This is a six inch by 6 inch patch.

How do you fix a big hole in drywall?

2:286:57How to patch and repair drywall - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou'll have a rough edge around your cut the sand and wipe it down if there aren't studs behind yourMoreYou'll have a rough edge around your cut the sand and wipe it down if there aren't studs behind your hole attach a 1 by 4 inside your wall and screw your drywall patch to that.

How to fix a hole in a wall with cardboard?

Start by cutting a thick piece of cardboard into a square that’s slightly larger than the hole you aim to fix. Poke two small holes through the center of the cardboard cutout and thread a short string in through one hole and out through the other. Push the cardboard through the wall hole, keeping the string ends facing you and ensuring ...

How to make a wall with glue?

Use a toothpick to combine the two, then follow the steps below: Next, follow the steps below: Put on rubber gloves to be sure that this super-strength, fast-drying glue never comes in contact with your skin. Immediately apply the mixture directly to the wall. After it dries, start sanding the hard, plastic-like finish until it’s flush with ...

How to make a cardboard sanding board?

Push the cardboard through the wall hole, keeping the string ends facing you and ensuring that all corners sit behind intact drywall. Pull the strings tight to hold the cardboard in place. Mix together one tablespoon flour, one teaspoon salt, and a few drops of water to form a paste.

Is drywall indestructible?

Photo: fotosearch.com. While drywall is highly durable, it’s not indestructible. Over the years, interior walls take a beating, speckled with everything from nail nicks to doorknob dings. During your tenure as homeowner—or even as an apartment renter—you’re bound to end up with at least one unwanted hole in the wall.

How to make a ragged hole in a wall?

Start by cutting the ragged hole into a neat square or rectangle. Slip one of the 1x3s into the wall cavity and screw it to the edge of the cutout; be sure it overlaps into the hole by 1 1/4 in. Then attach the second 1x3 to the opposite side of the cutout.

How to hide joints in drywall?

Spread a thick coat of joint compound around the edges of the patch. Use the drywall knife to firmly press paper tape into the compound; this will hide the joints. After the compound has dried completely, sand it smooth and apply at least two more thin coats of compound.

Can you patch holes in drywall?

No matter how careful you are, live in a home long enough, and you'll find yourself with some holes in the walls to patch. And if a small section of wall is really badly stained or damaged, you'll have to cut out the affected area and cover the hole with a drywall patch.

How do I fix a hole in a wall?

If you need to fix a golf ball-sized hole in your wall, apply fiberglass mesh tape or damp sheetrock tape over the hole. Use a drywall knife to apply joint compound over the patch and smooth it out. Apply your patch to dry for 24 hours, then add another layer of joint compound and repeat as needed.

What do I need for a hole in a sheetrock wall?

For a large hole in a sheetrock wall you will need: A piece of sheetrock. Since you may only need a piece of sheetrock that is a few feet square, see if you or a friend has a piece of it lying around, instead of buying a whole sheet. However, most home improvement stores also sell smaller pieces of sheetrock.

What do I need to patch a hole in a golf ball?

Get all of your tools and supplies together before you get started. To patch a hole the size of a golf ball, you will need: Fiberglass mesh tape or sheetrock tape. A small amount of joint compound. A 4” drywall knife. 220 grit sandpaper. ...

How to get spackling paste off of wall?

Smooth the spackling paste out with your putty knife. The goal is to make the transition between the wall and the patch as seamless as possible. Using a damp cloth, wipe off any excess spackling paste that may have gotten on the wall around the hole.

How to put a patch in a hole?

Push the patch through the hole holding the string. Filler side towards you , use the string to hold the patch in place, then use more filler in the hole. Tie the string to a timber offcut to hold the patch in place as the filler sets. Cut the string when the filler is set.

How to clean a hole in a wall with putty knife?

Then clean it out throughly with the wire brush. Using a brush and wearing gloves, apply bonding agent to the back and sides of the hole. Make up the mortar mix according to the manufacturer’s instructions.

How to remove plaster from wood?

Fine-grit sandpaper. Use the hammer and chisel to remove loose and damaged plaster. Make sure you work carefully to avoid damaging the lath – the wood structure behind the plaster. Using a trowel, coat the lath with plaster base coat. Work the base coat into the spaces in between the wood as well.

How long does it take for mortar to set?

Mortar needs to be allowed to cure and requires moisture, so allow it to set for around 2 hours, then cover the patch with a sheet of plastic.

How to Fix a Large Hole in the Wall

If you find yourself with a large hole in your drywall, you don’t have to call a handyman: Patch up the hole yourself by following the simple steps below.

High Quality Paintbrushes & Rollers

Go with high quality painting tools to ensure your DIY project is the best it can be.