Full Answer
What does fabric Code S mean?
dry clean only“S”—Fabrics that are Code S must be cleaned with solvents (dry clean only). You can spot treat stains with a water-free solvent or dry-cleaning product. Use solvent cleaners in a well-ventilated room and keep away from open flames. Avoid using cleaning products containing carbon tetrachloride, as it is highly toxic.
What does S mean in upholstery cleaning?
dry solvent cleaned onlyDry Cleaning / Code "S" Upholstery fabrics labeled as Code "S" must be dry solvent cleaned only. Dry solvent cleaning is reserved for delicate or non-colorfast fabrics that can be damaged when using water-based cleaning methods. The term dry solvent refers to non-water, hydrocarbon-based compounds.
How do you clean upholstery S?
For fabrics with an S code… Apply dry cleaning solvent to a clean towel and gently brush over generally dirty areas of upholstery. You can work solvent into heavily soiled areas with a clean, soft-bristled brush. Allow the piece to dry completely before sitting on it again.
Can you steam clean an S code couch?
If your furniture has a W (wet) or WS (wet cleaning and solvent) code, you're good to give its surfaces a steam cleaning. You should never steam furniture labeled S (solvent) or X (no cleaning). Doing so can damage its upholstery, and it can even void the manufacturer's warranty.
How wide is s couch?
What are standard sofa dimensions? The standard three-seat sofa is about 84” (152cm) wide, 40” (102cm) deep, and about 33” (84cm) tall. Loveseats, on the other hand, tend to be even smaller, at 52” (130cm) wide and 33” (84cm) deep, with a height that's about equal at 33” (84cm).
What happens if you use water on S fabric?
What happens if I use water on upholstery with S code? Using water on S-coded upholstery may cause it to bleed, shrink, “pucker,” and leave a brown-colored watermark. For best results, solvents should be applied to a surface and then immediately vacuumed off.
Can you use vinegar on S fabric?
White vinegar is great for tackling stubborn stains, and is safe to use on most fabrics. That makes it ideal to clean a fabric sofa naturally. Make the following solution and use it to blot the stain — don't soak the sofa, and don't rub, because you risk spreading the stain.
How do you get s stain out of a couch?
The cleaning code “S” (for “solvent”) means rubbing alcohol is a great option. Working section by section, spray an area with rubbing alcohol and then scrub with a white or light-colored sponge (so no color transfers to the couch while you scrub). You'll see the stains lift off onto the sponge.
How do you clean leather S?
How to Clean Leather: Apply Vinegar Cleaning Solution. Mix a 50/50 vinegar and water solution in a bowl and use a microfiber cloth to apply it to your furniture. Rub the leather in a circular motion to lift the dirt out of the natural fibers. Return your cloth to the bowl often, wringing it out and rewetting it.
What are the grades of upholstery fabric?
Generally, fabric manufacturers utilize a grading system to indicate how expensive their products are. Each grade is designated with an alphabetical letter, starting at grade A and going up to grade F. Grade A fabrics are the least expensive, while those that belong to grade F are the most expensive.
Can I use my shark steam mop on upholstery?
Shark's® ingenious Lift-Away™ Professional Steam Pocket® Mop is ideal for cleaning upholstery, as it features a detachable, handheld steam cleaner that is perfect for reaching all those hidden nooks and crannies that sofas tend to have.
Is it worth it to steam clean a couch?
Steam cleaning removes stubborn tough stains, dirt, grease and more while also sanitizing surfaces by removing allergens and pathogens. One of the most useful applications of steam cleaning units is to clean upholstery, fabric furniture and mattresses.
How do you read a upholstery cleaning code?
Standard upholstery cleaning codes are: W, S, WS, X and D.W – for Wet.S – for Solvent.WS – for Wet and Solvent.X – for Vacuum only.D – for Dry Clean only.
What is s dry cleaning solvent?
What Is Dry Cleaning Solvent? Dry cleaning solvent is a petroleum-based product that contains chemicals to help dissolve stains and soil without the use of water.
What is s spring in sofa?
Sometimes referred to as serpentine springs because of their S-shape, sinuous springs are the most commonly used type of couch springs. These steel wire springs snake in a continuous S-pattern from the front of the couch frame to the back and are typically joined together horizontally by a cord.
What does W or WS mean on upholstery?
W – Spot clean only with water-based shampoo or foam upholstery cleaner. Pretest for color loss and fabric compatibility. Do not over wet. Use professional upholstery cleaning service for overall soiling. WS – Spot clean with upholstery shampoo, foam from a mild detergent, or mild dry cleaning solvent.
What is wool sponge?
Combining excellent absorbency and durability with extreme softness, these Wool Sea Sponges are the ultimate choice when tasked with cleaning delicate upholstery or silks. All-natural and 100% biodegradable, these sponges provide excellent foam control and inhibit bacterial growth. Ideal for cleaning delicate surfaces and fabrics.
What is code S for cleaning?
Dry Cleaning / Code "S". Upholstery fabrics labeled as Code "S" must be dry solvent cleaned only. Dry solvent cleaning is reserved for delicate or non-colorfast fabrics that can be damaged when using water-based cleaning methods. The term dry solvent refers to non-water, hydrocarbon-based compounds. Dry cleaning is considered to be the safest of ...
Can you use a dry cleaner on a soiled fabric?
A dry cleaning solvent may be toweled onto heavily soiled areas such as armrests or head rests to remove hair and body oils. A brush or hand bonnet may be used to agitate the soiled areas.
What does W stand for in upholstery?
If you’re in doubt about how to proceed, it’s usually best to call a professional upholstery cleaner. “W” —Code W stands for ‘Water based cleaner’ and these are the easiest fabrics to clean.
What does code X mean on a sofa?
A Code X means the fabric is not cleanable with water or solvent cleaners. Now you’re equipped with a guide for cleaning upholstery fabrics, so you’ll know just how to handle that next stain on your sofa! For day-to-day care and cleaning, here are some basic tips on keeping your upholstery looking good for years to come.
How to clean code S?
Be careful to avoid over-wetting the stain. “S” —Fabrics that are Code S must be cleaned with solvents (dry clean only). You can spot treat stains with a water-free solvent or dry-cleaning product. Use solvent cleaners in a well-ventilated room and keep away from open flames.
Can you clean upholstery yourself?
Luckily, most decorator fabrics and upholstery pieces are labeled with a cleaning code and, once you understand the codes, you can tackle most mild cleaning jobs yourself.
What to use for type 'S' fabric upholstery?
I have a couple of pieces of furniture upholstered in velvet with the "S" - or solvent only - cleaning code. I know you are not supposed to use water to clean off stains, but I'm not sure what or where to buy the correct product. I looked at one of those foam type cleaners and it specifically said not for use on S-type fabrics.
How to get stains out of upholstery?
Stop by your local furniture retailer, particularly the retailer where the upholstery was purchased, if possible. Ask if they sell dry cleaning solvent that will remove stains from upholstery. 2. Look at hardware or home repair stores for dry cleaning solvent in the cleaning supply section of the store. 3.
What is the best way to clean upholstery?
Water-free solvents are typically the best type of dry cleaning solvent for cleaning upholstery. Dab a small amount of the dry cleaning solvent onto the stain and blot gently until the stain is gone. Perform a test on an inconspicuous area of the upholstery with the dry cleaning solvent to check for staining or other discoloration ...
Can you use spot remover on upholstery?
An option not mentioned below is spot remover from a carpet cleaning company. I have some from Chem-Dry, which says it can be used on upholstery also, after testing it in a hidden area. (BTW, I still have a half-bottle of Aero Spot Remover, which is trichloroethylene, but I'm keeping it. LOL)
Definitions & Translations
Get instant definitions for any word that hits you anywhere on the web!
A Member Of The STANDS4 Network
Get instant definitions for any word that hits you anywhere on the web!
How to keep upholstery looking good?
It will always be easier to keep your upholstery looking good if you maintain it regularly – just a good vacuuming will do so much to keep it fresh!
What is code S fabric?
Code S fabric are (most often) natural fibers like linen, wool and silk, and water-based cleaning methods can leave a ring, shrink, warp, or otherwise damage the fabric. This means you have to clean upholstery with *water-free*, non-diluted cleaning solvent, often a dry-cleaning like Guardsman Dry Cleaning Fluid (remember, this is just a resource, always test your fabrics before diving in with a new product!).
What does X mean in cleaning code?
X = Nothing. You can’t clean this. If you have a fabric with cleaning code X, don’t get it dirty because you probably can’t do anything for it beyond vacuuming or brushing the surface. Luckily this code isn’t seen much anymore, mostly on certain window shades.
How to keep furniture in good shape?
Although you cannot prevent life from happening to your furniture, you can help keep it in good shape with a few simple steps. Be sure to vacuum regularly with an upholstery attachment to remove soil. If a spill does occur be sure to clean it up immediately. The longer the spill is on the fabric, the more it sets in making it harder to come clean.
Can you clean upholstery with soap and water?
This means you can clean your upholstery with a water-based detergent, making this a family-friendly, DIY kind of fabric. Not only can you clean it with a little soap and water, but you also don’t have nasty chemicals around the house to clean the upholstery.
Is code W fabric machine washable?
Please note, this is *not* the same as being machine washable, and you should be careful to avoid over-wetting the stain. Code W fabrics are *usually* (but not always) man-made, like polyester and nylon.
What is a fully reupholstered piece of furniture?
A fully reupholstered piece of furniture is “like new” especially if the frame is a quality one . Pattern Match – the process of matching the print or weave on a piece of fabric across a piece of upholstered furniture. A good pattern match requires more fabric, which is why lower cost furniture rarely has matched patterns.
What is the most important part of upholstered furniture?
The frame is the most important part of a piece of upholstered furniture. Much like our own skeleton, if we don’t have a strong frame made of healthy bones and joints, we’re going to feel it over time and eventually start to break down. And our bones are made of much stronger stuff than even the best wood.
What is the difference between reupholstering and recovering?
reupholster – Recovering refers to simply replacing the outer fabric, but doing very little repair to the frame or replacing the cushioning. Reupholstery refers to stripping the piece down to its wood frame, making any repairs as needed and then upholstering with all new materials . A fully reupholstered piece of furniture is “like new” especially if the frame is a quality one.
Why don't furniture match patterns?
Most lower priced furnishings don’t match patterns because it takes skill and extra fabric and is more expensive. But, it’s so worth it. Another wonderful detail of quality upholstery is the ability to have dressmaker details*.
Why does cheap furniture break down?
A cheaply upholstered piece of furniture will break down in these spots because of the extra tension from both the inside and outside. And finally, once we have a strong, sturdy frame, and strong, comfy cushioning, we should think about the fabrics used.
What is a dressmaker detail?
Dressmaker Details – Added details such as trims, pleating etc. which makes for a unique piece of furniture.
What is a good frame for furniture?
A good furniture frame is made from a kiln dried hard wood (* see terms below) such as oak or maple. The wood should be straight lumber without warping and free of knots and wormholes as much as possible. Lower cost furniture is usually made of a softer wood such as pine and is often treated with chemicals to sterilize it.
What does X/S mean in furniture?
X or X/S means the piece can’t be safely wet OR dry cleaned! You can only safely clean the piece by brushing with a soft brush and careful vacuuming. In other words, in layman’s terms, this piece of furniture can’t be cleaned using normal cleaning procedures.
What does S code stand for in cleaning?
Wait until it’s completely dry to know for sure! S – An S code stands for solvent clean, or dry clean only.
What does the W on a label mean?
W – Generally, if you see a W at the bottom of your label, you should feel like you just won a prize! The W stands for wet or water clean. This means that, for the most part, you furniture can be safely cleaned using a water based upholstery cleaner or water based foam. A W coded piece of furniture will usually perform better in a variety ...
Where to find cleaning instructions on a couch?
The label will usually have the title “Recommended Cleaning Instructions,” and on the bottom of that label you will find a letter or letters. This designation is what is known as a cleaning code, and your label may have a code that says “W”, “SW”, or something else. (See the small letter “S” at the bottom of the label pictured in this post?) When we purchase furniture, we many times are interested in the color, pattern, or texture of the fabric, and aren’t really thinking about cleaning it! But a couple of years later, the issue of cleaning will come up, and that’s where the cleaning codes may help point you in the right direction.
What is a SW code?
SW or WS – these codes denote that your piece of upholstered furniture can be cleaned by either dry solvent or wet methods. If you decide to tackle this yourself, do so very carefully, and pre-test accordingly. Generally speaking, a qualified professional would be your best option.
