AP-Manager Interface A controller configured with IPv4 has one or more AP-manager interfaces, which are used for all Layer 3 communications between the controller and lightweight access points after the access points have joined the controller.
What is an AP-Manager interface?
AP-Manager Interface A controller configured with IPv4 has one or more AP-manager interfaces, which are used for all Layer 3 communications between the controller and lightweight access points after the access points have joined the controller.
How many AP-Manager interfaces can be created when lag is disabled?
But when LAG is disabled, one or more AP-manager interfaces can be created, generally one per physical port. When LAG is enabled—Supports only one AP Manager, which can either be on the management or dynamic interface with AP management.
Can the dynamic interface act as an AP Manager?
The Dynamic Interface tied to a VLAN can act as an AP Manager (when enabled). When you enable LAG, all the ports would lose their AP Manager status and the AP management reverts back onto the Management interface. Port redundancy for the AP-manager interface is not supported.
How do I remove the AP-Manager for a controller configured with IPv6?
A controller configured with IPv6 has only one AP-manager and is applicable on management interface. You cannot remove the AP-manager configured on management interface. The controller does not support jumbo frames.
How many AP managers are there in IPv6?
A controller configured with IPv6 has only one AP-manager and is applicable on management interface. You cannot remove the AP-manager configured on management interface.
How to open interfaces in a controller?
Choose Controller > Interfaces to open the Interfaces page.
What is LAG in AP?
If link aggregation ( LAG) is enabled, there can be only one AP-manager interface. But when LAG is disabled, one or more AP-manager interfaces can be created, generally one per physical port. When LAG is enabled—Supports only one AP Manager, which can either be on the management or dynamic interface with AP management.
Can you map AP manager to backup port?
You cannot map the AP-manager interface to a backup port. It is not possible to have APs and a non-AP-manager interface on the same VLAN. If they are in the same VLAN, the controller will move the traffic up on the incorrect VLAN as the controller gets the CAPWAP discovery on the non-AP-manager interface.
Do you need an AP manager for Cisco 5508?
For Cisco 5508 WLCs, you are not required to configure an AP-manager interface. The management interface acts like an AP-manager interface by default.
Does IPv6 support dynamic AP?
A controller configured with IPv6 does not support Dynamic AP-Manager. By default, the management interface acts like an AP-manager interface. Link Aggregation (LAG) is used for IPv6 AP load balancing.
AP Manager Duties & Responsibilities
To write an effective AP manager job description, begin by listing detailed duties, responsibilities and expectations. We have included AP manager job description templates that you can modify and use.
AP Manager Qualifications
Qualifications for a job description may include education, certification, and experience.
AP Manager Examples
Our company is searching for experienced candidates for the position of AP manager. To join our growing team, please review the list of responsibilities and qualifications.
