Determine the size of your doors based on the width of your closet opening
| Opening Size | Number of Doors |
| Up to 24″ | 1 door |
| 24″ – 36″ | 2 doors |
| 36″ – 48″ | 3 doors |
| 48″ – 60″ | 4 doors |
What are the standard dimensions of a closet door?
- The standard height for interior doors is 80”.
- Standard widths can range anywhere from 1 ⅝” to 1 ¾”.
- Add an extra 2” for width and 2 ½” for height when planning out a rough opening.
- You can customize these sizes for unique doors that fit the architectural structure of your home.
What is the minimum width for a closet door?
The required capacity of each door opening shall be sufficient for the occupant load thereof and shall provide a minimum clear opening width of 32 inches (813 mm). The clear opening width of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees (1.57 rad).
How to build a custom closet door?
Steps: 1. If you don't have an existing soffit in your room on which to hang your doors, you can build one by connecting two 2x6s to your desired length. To attach them to your wall, pre-drill for 4" screws about every eight inches along the edge and place the screws loosely inside the holes.
What is the smallest depth for a closet?
When designing a closet, consider the specific efficiencies of each different storage element to better serve your closet needs. The comfortable recommended depth of a closet is 24” (61 cm), but closet depths as narrow as 20” (50.8 cm) can be used if desired. Shelf depths of 12” (30.5 cm) should be used for shoes and smaller clothing elements.
How do I know what size closet door to buy?
0:031:00How to Measure For a New Specialty Closet Door | The Home DepotYouTubeStart of suggested clipEnd of suggested clipDo this at the center of the finished opening. And then along each side use the smallest. Result.MoreDo this at the center of the finished opening. And then along each side use the smallest. Result. Then measure the inside width from jam to jam. Again measure three times to get the smallest. Result.
What are the most common closet door size?
Still, it can be incredibly helpful to know what the general or standard size of a closet door should be. The average measurement is at 30 inches wide and 80 inches tall. The size of your closet door can vary depending on the architecture of the room and the type of closet door you have.
What size bifold closet doors do I need?
Measure the width of the opening at the top, bottom and middle. Measure the height on both sides and in the middle. Take the smallest measurements and deduct half an inch (the fitting tolerance) to get the size of the door you need to order.
Can you use 2/24 bifold doors for a 48 opening?
Two-section bifolds are generally sold in widths to fit openings from 24 to 36 inches. Again, the doors can be trimmed slightly at the sides to fit smaller openings or filler strips can be added to the sides of the opening to close gaps. If an opening is 48 inches wide or wider, two 2-section doors are used to fill it.
Is a 30 inch door too narrow?
Doors can be as narrow as 30 inches and as tall as 96 inches, and thickness can depend on the door material. Entry doors are available in single- and double-door configurations with additional options like matching sidelights and transoms. These options can impact the overall size of your entry door.
What is the standard rough opening for a closet door?
A 6-foot-wide closet opening is the most common, but you can install closet doors in an opening of just about any width. Sets of bifolds are available in a variety of widths (in multiples of 2 inches) and bypass doors can be cut to any width desired. The standard height is 80 inches (the same as for an entry door).
How wide is a standard closet door?
30 inchesCloset doors are narrower and aren't required to meet the standard interior door building codes. The average closet door has a width of 30 inches and a height of 96 inches, though sizes can vary widely. Bi-fold doors are common closet door types, which have two panels for a single door and four panels for double doors.
How much smaller should a bifold door be than the opening?
½'' smallerThe actual dimension of bifold doors is always ½'' smaller in width than the stated size to accommodate the necessary clearance for proper operation of doors. Bifold doors must be 1-1/2'' shorter in height than the finished opening.
What is the finish opening for a 36 inch bifold door?
Bifold Finished Opening Widths are true to the measurement (a 3/0 is 36”, a 2/8 is 32”, a 6/0 is 72”, etc).
What is the rough opening for a 48 inch bifold door?
The rough opening of a 48-inch bifold door is 82-inch (2082 mm) higher and 50-inch (1270 mm) wider. This rough opening allows you to install 0.21 mm-thick drywall at the top and on both sides of the door, a 38.1 mm space under the door, and 2032 mm for the doors and hardware.
What is the rough opening for a 24 inch bifold door?
Framing rough opening sizes are really quite simple. Just add 2″ to the width of the actual door size. You should add 2-1/2″ to the height of the actual door. This will give you room to space the door frame off of the sub-floor.
How do you size a bifold door opening?
Take three measurements of the width of the opening — at the top, the middle and the bottom. Then take three measurements of the height of the opening — one on each side and one in the middle. Take the smallest numbers from both sets of measurements and subtract a half-inch from each to get your final width and height.
What do you need to measure for a bifold closet door?
For bifold and pivot closet doors, you’ll need to measure the diagonals, widths, and heights of the finished opening, and make sure you have space for the doors when they’re open. For bypass closet doors, you only need the widths and heights of the finished opening.
How tall is a bifold closet door?
Bifold closet doors typically fit an 80.5” or 96” tall opening. Typical widths can range from 24” to 72”. For spans up to 36”, your closet doors will have two panels or one door opening from the right or left. For widths between 36” and 72”, four panels will be needed for your bifold door, or two doors – one on each side.
How many panels are needed for a bypass door?
For the largest widths, your bypass doors will need four panels. Three panels are used for bypass closet doors covering 108” to 144” widths. For smaller widths, two panels are all that is required. Use the largest width and shortest height measurements if there is a difference when measuring your closet finished opening.
Do all closets have to be square?
Even in new homes, not all closets are perfectly square. Whether you’ve selected a bifold, pivot, or bypass door, you’ll need to measure both the top and bottom horizontal widths of your opening.
Do you need to take a diagonal measurement for a bypass closet door?
If the measurements differ by more than ½’, the doors will not slide open or closed completely and the opening should be fixed so the opening is straighter. It is not necessary to take a diagonal measurement for a bypass or sliding closet door.
How wide is a sliding closet door?
You can adapt standard interior doors to use as sliding closet doors. These doors come in 24-, 28-, 30-, 32- and 36-inch widths. The standard height is 80 inches, which you can trim to fit your closet’s opening.
How to measure a door opening?
Measure the height of the door opening on the right side, as well. Take both measurements, because the door opening may not be square. If the opening is extra wide, take a third measurement at the center of the doorway. Measure horizontally across the top of the opening just below the doorframe. Measure across the bottom ...
What are the dimensions of a bedroom closet?
What Are the Standard Dimensions for a Bedroom Closet? Standard dimensions for bedroom closets vary based on the type of closet. Minimum dimensions for a walk-in closet should be 4 feet wide by 4 feet deep. Conversely, the minimum dimensions for a reach-in closet should be 36 inches wide by 24 inches deep.
How deep is a closet?
They can also mimic the appearance of other furniture around the home. On average, wardrobe closets are typically 24 inches deep but can be as narrow as 12 to 18 inches deep. The height of the closet depends on the style, but the standard height is 72 inches. The width of wardrobe closets varies from 24 to 96 inches.
How much space do you need for a walk in closet?
Large walk-in closets that have a width of more than 10 feet can accommodate seating, walkways, or storage islands. As mentioned before, these structures still need to have at least 24 inches of walkway space on all sides. If you would like a closet island, the width of the closet needs to expand by 5 feet.
How much weight can a closet rod hold?
The weight capacity of a clothing rod will depend on the material it’s made out of and the length of the rod. A 6-foot oval aluminum closet rod can hold about 45 pounds. However, a rod of the same length but made from 1 5/16-inch steel polished chrome can hold 170 pounds.
How deep should a closet hanger be?
Most closets will include rods for hanging clothes. Hangers require at least 22 inches of depth to swing freely on the clothing rod. You should position the rods at specific distances from the floor and ceiling to accommodate several types of clothing.
What is closet shelving?
Bedroom closet shelving can be a practical way to organize and store your clothing. Shelves can also store bulkier items used in your bedroom, like pillows and blankets. Ideally, the top shelf of a closet should be high enough so that items are out of the way.
What is a good closet?
When there is insufficient closet space, or your room doesn’t have closets, a wardrobe closet is a good option. Wardrobe closets are the most common type of closet in Europe and have become popular in the US in older homes. This is an easier alternative than cutting into walls to create closet space.
How wide should a bedroom door be?
Now all you need to know is how to properly frame your door rough opening. So, if you have a bedroom door that is 30″ wide (which is considered a 2/6 or 2′-6″ door) just add 2″ to the width and frame it 32″ wide.
How high is a door frame?
The height is 80″ (which is considered 6/8 or 6′-8″) add 2-1/2″ to the actual door height and frame it 82-1/2″ high.
How far off the floor should I shim door jams?
If you are going to carpet the floor, shim the door jambs off the floor about 3/8″. This will allow carpet to be tucked under the jambs and usually leaves enough clearance so the door doesn’t rub on the carpet.
What is the best door to open a walk in closet?
French doors with clear glass panels can be a very elegant choice to open on to a walk-in closet. Wood-paneled French doors are also elegant and provide a more traditional look. You can even get French doors in a flat front extra glossy finish if that is more your aesthetic.
What is a bypass closet door?
the 80’s. Though still used frequently, they are no longer as popular as other styles. Bypass closet doors are simply your basic sliding closet door.
What is a bifold door?
Bifold doors are similar to bypass doors in that they slide along a track. However, bifold are made of two door panels that are hinged in the middle so they fold together and open to the side. This style of the closet door allows you to access both sides of your closet at the same time and allows you to easily access the center space in your closet.
What is an accordion door?
Accordion doors are the most budget-friendly option you will see. They are made of multiple panels that fold together like an accordion and run along a single rack installed at the top of the opening.
What is a sliding barn door?
This door is installed outside of the frame, with visible rustic looking hardware. This door style can be made to suit any size door opening, and since it stays along the wall, is a good space-saving option.
Where are the hardware on a door?
They are attached at the top and bottom of the door, which allows them to open fully. They can be customized and made to suit any style or room size. These are definitely not for the buyer on a budget. The hardware can be expensive, and they need to be professionally installed.
Can new doors change the look of a room?
Whether you are doing a complete remodel or are only trying to make a few changes to modernize the look of a room, new doors can change the feeling of a space. They can also increase a room or closets functionality if you choose wisely. The doors you choose will partially be determined by the type of close you have.
