How do I drain my car’s coolant?
Nov 23, 2011 · 2,748. The arrow in the picture points to the coolant drain. Slip a hose on it, remove radiator cap and open valve. Reply. Aug 6, 2011. #4.
What is a coolant drain tool?
Jan 18, 2019 · Release the clamp, disconnect the engine-to-engine oil cooler hose from the engine oil cooler and drain the coolant from the LH side of the cylinder block. Connect the engine-to-engine oil cooler hose and position the clamp when finished. Secondary system Place a suitable container below the radiator drain****.
Where is the radiator drain valve on a car?
Oct 20, 2010 · Find the coolant reservoir on the left side near the footboard. You will have to remove the reservoir. After you remove the reservoir, you will be able to see the water pump. The drain is a hex head screw threaded into the case at the bottom of the water pump. Unfortunately, it will drain into the foot board and the pan under the engine.
Where do you put antifreeze in a car radiator?
Oct 23, 2017 · Engine coolant inside the radiator is drained from the drain hole located on the bottom of the engine under cover. (c) Tighten the cylinder block drain cock plugs. Torque: 13 N⋅m (130 kgf⋅cm, 10 ft⋅lbf) 2. ADD ENGINE COOLANT (a) Tighten the radiator drain plug. (b) Add engine coolant into the radiator until it overflows.
How do I find my coolant drain plug?
Hello, the radiator drain plug will be a the bottom edge of the radiator, facing the engine (passenger side). If you drain the coolant, be sure to catch it with a pan of some sort, and properly dispose of it.Jan 7, 2017
How do you drain and fill coolant?
0:543:27How To Change The Coolant In Your Car - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd loosen the drain plug. This will typically be on the left or right side of the radiator at theMoreAnd loosen the drain plug. This will typically be on the left or right side of the radiator at the bottom allow the coolant to drain. Next. Move your catch pan underneath the engine.
Can you drain coolant yourself?
To flush with water and remove any leftover residue from the old coolant/antifreeze, top up the radiator with clean water using a hose, and replace the radiator cap. Then, start the engine and leave it running for 15 minutes.Oct 6, 2020
Where is the radiator drain valve located?
Where is the radiator drain valve? A radiator drain petcock is usually located above the bottom of the radiator. So even if you can open it, you're not draining the radiator completely. That's why shops always remove the lower radiator hose.
Can I drive my car after adding coolant?
How Long Should You Let The Car Run After Adding Coolant To Ensure It Is No Longer Overheating? The engine should be allowed to cool for a minimum of 15 minutes before beginning operation. A cool engine should push the temperature gauge back toward normal.Feb 25, 2022
Is coolant in the radiator?
Car coolant is located in a reservoir affixed to the radiator before it's introduced to the engine block and its components. Engine coolant is used in conjunction with a liquid cooling system. The liquid cooling system is made up of several components.Jul 7, 2020
What happens if you dont flush coolant?
The coolant can become more acidic over time and lose its rust-inhibiting properties, causing corrosion. Corrosion can damage the radiator, water pump, thermostat, radiator cap, hoses and other parts of the cooling system, as well as to the vehicle heater system. And that can cause a car engine to overheat.
How much does a coolant flush cost?
The average cost to flush coolant from a radiator is anywhere from $100 to $200. The exact cost will usually depend on where you go (an independent mechanic will be cheaper than a dealership). Some less reputable shops might only charge between $50 and $100.Apr 16, 2021
How do I know if I need a coolant flush?
Vehicle Overheating and High Temperature Gauge The primary role that coolant plays in your vehicle's functioning is keeping your engine temperatures low. If you find that your temperature gauge is always high and your engine is frequently overheating, chances are that you need a coolant flush.
What is radiator petcock?
0:101:57Radiator Petcock: 2 Minute Tuesday Shop Tip - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell you climb down underneath here. And you might have a nice little drain underneath here at theMoreWell you climb down underneath here. And you might have a nice little drain underneath here at the bottom of the radiator or petcock. Something that'll make it super easy to drain your radiator.
How do you fit a radiator drain valve?
3:3211:56How to fit a radiator valve with a drain off cock - YouTubeYouTubeStart of suggested clipEnd of suggested clipI put them across the top overvaluing the top of the Bell. Put it on and then turn this one upwardsMoreI put them across the top overvaluing the top of the Bell. Put it on and then turn this one upwards like that once you've done that you can let go. And we should be away.
How do you fix a leaking petcock radiator?
1:052:52How To Stop A Radiator Petcock From Leaking - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo we took the o-ring off the original. One and it was flattened out. And this is an ac o ring weMoreSo we took the o-ring off the original. One and it was flattened out. And this is an ac o ring we have our o-ring kit with all kinds of o-rings in it nothing. Fit now the new one is protruding.
How to drain coolant from car?
If a valve is not available loosen the lower radiator hose and slowly remove it from the radiator to initiate the draining process. Open the drain valve by turning the it counter clockwise.
How to catch coolant from a drain valve?
Open the drain valve by turning the it counter clockwise. Have a fluid catch basin ready to catch the now draining coolant. Sometimes the coolant will contact frame members and other supports which can make catching the coolant a little more difficult. In these cases use more than one catch basin.
How to refill a radiator with coolant?
Refill the Radiator with Coolant. When you are ready to refill the system with coolant remove the cap from the new coolant container. Underneath the cap there will be a seal that ensures you that the coolant has not been watered down and is pure from the manufacturer.
How to keep car from overheating?
Flush a cooling system to avoid over heating. Your car's cooling system is designed to keep the engine from overheating while in operation. This is achieved through the use of engine coolant and a radiator which removes heat from the coolant once it has passed through the engine block and cylinder heads. In time the engine coolant will need ...
Where is the radiator cap located?
The radiator cap is located on the top of the radiator or on the coolant reservoir. Some systems have two caps one that holds pressure and the other just keeps dust and dirt out of the reservoir. SPONSORED LINKS. 2.
Is coolant toxic to animals?
Also coolant is toxic and will harm animals and humans if ingested. You may need to raise your car off of the ground using a floor jack and supporting it with jack stands for safety. Start with the engine cool and wear gloves and safety goggles. 1. Locate the Radiator Cap.
Do you need to mix coolant with water?
If you have flushed the system there will be no need to mix coolant with water because there will be a sufficient amount or water still remaining in the engine block. Continue to add coolant until you have reached the full line in the reservoir or the top of the radiator.
How to flush a radiator with coolant?
Open the drain, and allow all the coolant to drain into the container until it stops flowing out. Then close the radiator petcock or drain. Pour the radiator flush product into the radiator. Fill the radiator with water from your garden hose until it’s about one inch below the radiator neck.
How to check coolant level on a car?
Recheck the coolant level in the radiator and on the plastic tank where there should be a “full level” indicator. Add more coolant if needed. Close and tighten the radiator cap and reservoir cap. It's also a great idea to check the coolant level a day or two later.
How to protect your engine from the elements?
Protect your engine from the elements with a radiator flush. If you're driving a vehicle with an internal combustion engine, then periodically you'll need to flush the radiator and replace the coolant, which is also called antifreeze. Adding fresh radiator coolant with the proper 50/50 mix of coolant and distilled water protects your radiator ...
How to make a radiator with 50/50 water?
Using pre-diluted coolant, as opposed to concentrated or full-strength, is an easy , no-fuss way to ensure your radiator has the proper 50/50 mixture of coolant and water. Run the engine until the cooling system stops bubbling and the coolant level starts to rise, then put the radiator cap back on the system.
How to prevent burns on radiator?
Prevent burns by never opening a warm to the touch cooling system. 1. Open the radiator fill cap, usually on top of the radiator. If your vehicle has a plastic tank or reservoir for coolant, open that cap too. 2.
How long does it take to prep a car for antifreeze?
Around 3 hours with a lot of down time between steps. Prep: With the vehicle parked on a level surface, ensure the engine and radiator are cool to the touch. Antifreeze is toxic, so keep pets and kids from entering the work area.
Can a leaky radiator cap cause problems?
They're cheap and they're a key part of the cooling system; a leaky radiator cap can be enough to cause all kinds of problems. 14. For peace of mind, use an antifreeze tester to determine the lowest outside temperature to which your vehicle’s coolant is protected from freezing. Last updated May 9, 2019.
How Often Should I Change My Coolant?
How Much Does It Cost?
- When having a cooling system service performed by a repair garage or dealer it will cost between $150.00 and $210.00 (US). This will include emptying of the radiator and cooling system and coolant reservoir and refilling it with new coolant. They should also check the system coolant level once the engine has warmed up to it's operating temperature. You can do the job yourself for ab…
Let's Get Started!
- When changing the coolant from your car's radiator there are two things to remember. First, no matter how much coolant has drain out of the system there will always be some left in the engine block which will be difficult to remove just by draining the system for the first time. A flush machine can be used but the problem is most states have outlaw...
Watch The Video!
- 4. Flushing the System To flush the cooling system refill the radiator with plain water. Then start the engine and allow it to run until it is at operating temperature while keeping the radiator or reservoir full. Once the engine is warm and the thermostat has opened shut the engine off and repeat the draining process motioned earlier in this guide. Perform this operation as many time…
Questions?
- Our certified technicians are ready to answer coolant flush questions for free. We hope you saved money and learned from this guide. We are creating a full set of car repair guides. Please subscribe to our 2CarPros YouTubechannel and check back often for new videos which are uploaded regularly.