Full Answer
See more
Where is the fuel pump relay located on a 2003 Ford Explorer?
0:211:02Fuel Pump Relay and Fuse Location Ford Explorer 02 03 04 05 2002 ...YouTubeStart of suggested clipEnd of suggested clipCome over here to the fuse compartment lift this little tab lift it up. Your fuel pump fuse. Is thisMoreCome over here to the fuse compartment lift this little tab lift it up. Your fuel pump fuse. Is this 20 amp fuse right here. This 15 amp fuse runs your fuel pump coil.
Where is the fuel reset button on a 2003 Ford Explorer?
The fuel pump shut-off switch is located behind an access panel in the right rear quarter trim panel, near the liftgate. The fuel pump shut-off switch has a red reset button on top of it.
Where is the relay switch on a 2003 Ford Explorer?
0:171:04Starter Relay and Starter Fuse Location Ford Explorer 02 03 04 05 ...YouTubeStart of suggested clipEnd of suggested clipRaise the hood. Come over here to the fuse box under the hood lift this little tab right here. AndMoreRaise the hood. Come over here to the fuse box under the hood lift this little tab right here. And you can lift this right off. So your starter fuse and starter relay fuse are right here this red one.
Where is the fuel pump relay switch located?
Ⅳ The Location of Fuel Pump Relay The fuel pump relay's end is usually at the center of the floorboard, under the carpet in the front area of the passenger or driver's side footwell. The fuel pump relays can be found in a variety of locations depending on the vehicle.
What are the symptoms of a fuel pump relay?
5 Symptoms of a Bad Fuel Pump Relay (and Replacement Cost)#1 – You Can't Start Your Vehicle.#2 – Check Engine Light.#3 – Engine Stalling.#4 – Rough Acceleration.#5 – No Noise From the Fuel Pump.
What causes fuel pump to not kick on?
If either due to a faulty crank sensor, or ecu, the crank sensor signal is not being read, the ignition and fuel pump systems will not power up. Also, a faulty ignition module can create the same issue. Check for signals from the crank sensor and other sensors.
Where is the fuse located for fuel pump?
In most car models, the fuel pump relay is located in a fuse box somewhere under your dashboard, but it can also be located in the fuse box in the engine bay. The engine's or the dashboard fuse box is usually a long black box containing a fuel pump relay and various other fuses and relays.
Where is the fuel pump relay on a 2004 Ford Explorer?
0:181:09Ford Explorer 2004 Fuel Pump Fuse and Relay - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo over on the driver side pop. This box open here the horn works so you know that the horn relayMoreSo over on the driver side pop. This box open here the horn works so you know that the horn relay which is right here works the fuel pump relay is right next to it.
Where is the fuel pump fuse on a Ford?
0:232:17Ford Expedition - FUEL PUMP FUSE AND RELAY LOCATION (2009YouTubeStart of suggested clipEnd of suggested clipAll the fuel pump fuses will be located. In the main fuse box under the front hood which is locatedMoreAll the fuel pump fuses will be located. In the main fuse box under the front hood which is located right here and it's very easy accessible.
How do you bypass a Ford fuel pump relay?
0:482:58HOW TO BYPASS BAD FUEL PUMP RELAY ON FORD RANGER ...YouTubeStart of suggested clipEnd of suggested clipIt's just a little jumper wire. But you could just use the wire. And be fine you don't really needMoreIt's just a little jumper wire. But you could just use the wire. And be fine you don't really need the terminals on it.
How do you reset the fuel pump?
Locate the reset button to the fuel pump shut off switch. Press and hold the reset button for about 20 seconds. Note: The fuel pump shut off switch reset button is usually located either under the dash in the driver compartment or under the driver or passenger seat.
What sensor controls the fuel pump?
The fuel tank pressure sensor is part of the fuel pump assembly and is mounted on top of the tank or inside the tank. It's part of the evaporative emissions system (commonly referred to as “EVAP”) and reads pressure in the fuel system to detect evaporative leaks, such as a loose or faulty gas cap.
What would cause my Ford Explorer not to start?
The most common reasons a Ford Explorer won't start are a dead battery, an alternator problem, or failed starter.
What is a fuel reset?
It resets the fuel pump if is is turned off due to accident or sudden jaring...
Where is the fuel pump fuse on a 2004 Ford Explorer?
0:381:09Ford Explorer 2004 Fuel Pump Fuse and Relay - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the 20 amp fuel pump fuse is gonna be right here. And if you find that it's blown. You want toMoreSo the 20 amp fuel pump fuse is gonna be right here. And if you find that it's blown. You want to swap it I recommend swapping it with the 20 amp horn fuse right here.
Where is the fuel pump relay on a 2006 Ford Explorer?
0:486:182006 Ford Explorer Fuel Pump Relay, Fuse & Circuit - YouTubeYouTubeStart of suggested clipEnd of suggested clipRight off the bat I'll show you there's a 30 amp JK's fuse for the fuel pump. And that's this oneMoreRight off the bat I'll show you there's a 30 amp JK's fuse for the fuel pump. And that's this one right here. So this views 30 amps provides the power for the fuel pump as well as the injectors.
1 Answer
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.
Marvin
An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.
MasterPro Ignition 30 Amp 5 Terminal Multi-Purpose Relay
When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures.
Import Direct Ignition 20 Amp 5 Terminal Multi-Purpose Relay
When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures.
Standard Ignition 4 Terminal Multi-Purpose Connector
When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures.
Standard Ignition 20 Amp 5 Terminal Multi-Purpose Relay
When autocomplete results are available use up and down arrows to review and enter to select. Touch device users, explore by touch or with swipe gestures.
