why did my spa drain into my pool

Why does my spa drain into the pool?

Most commonly, it is simply due to a failed, or stuck check valve in the plumbing at your equipment. A raised body of water that actually shares the same system as the main pool that is lower than the spa naturally wants to drain into the main body of water below it because of gravity.

Why did water drain from hot tub?

If anything gets trapped within that valve, such as debris, it can disturb the flap and prevent the valve from sealing properly. That allows the water to flow backward and drain instead of remaining inside your hot tub.

Why is my spa draining when pump is running?

There is normally a check valve in the plumbing at the equipment pad to stop water from draining from the spa to the pool. There could be debris in the check valve or it could be failing due to age. A pic of the equipment pad might help.

Why is spa draining in spa mode?

The suction valves need to be adjusted properly. Turn the spa suction valve to the “off” position and make sure you have the spa return valve at least partially open. This will help the flow between the pool and spa. You may also want to see if the actuator has gone bad if the suction valves are fine.

How does a spillover spa work?

Spillover spas are hot tubs that connect directly to your pool through a small curtain or fountain of water. This water moves directly from the jacuzzi into the swimming pool, spilling over a ledge or a series of ledges.

Is it normal for a hot tub to lose water?

The water that you put in your hot tub doesn't just stay there forever, and you will have to add more in no matter what. Is water loss normal? Yup, water loss is considered normal when it comes to evaporation. The standard rate for water loss is about 1 inch a week.

Why is my hot tub losing water overnight?

If a hot tub drained completely overnight, there is most likely a cracked PVC pipe somewhere under the hot tub. Remove the panels and look where the most water has puddled on the ground, or look for an active drip or obvious crack.

Why does my pool lose water when the pump is on?

Pressure-side Return Leaks. Generally, if you're losing water when your pump is running, you have a pressure-side return leak. When you're running your pump, the plumbing after the pump is under pressure. Often times, this can lead to small leaks and water sprays through your line (from the filter to your return jets.)

Why is my hot tub going down?

It may simply be that your tub's inflation valve or deflation valve adapter is faulty, or that it's too loose. A loose inflation valve is likely to be a key cause of air escaping through a Lay-Z-Spa. Once again, it can be uncommon for problems like this to arise in the most robust of tubs.

How do you isolate a spa in a pool?

0:062:16How to put your pool into spa mode and start the Heater - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you turn the one on the bottom on are you degrees the pool section is off and I was going to beMoreAnd you turn the one on the bottom on are you degrees the pool section is off and I was going to be sucking from the spa. So the spa now is one hole contained unit.

How often do you have to add water to hot tub?

With average use, your hot tub should be drained and refilled about once every three or four months. But since everyone uses their hot tub differently, the answer can vary based on how many people use it and how often. Hot tub manufacturers like Jacuzzi offer some handy tips for figuring out when to drain and refill.

Why is my hot tub leaking from the bottom?

It is most common to have leaks on the backside of spa jets, which can be caused by loose locknuts or deteriorated spa jet gaskets on the inside of the spa. Spa leaks occur in other gasketed spa or hot tub equipment, too — anything with o-rings and gaskets are susceptible.

What happens if water level is too low in hot tub?

Low water levels can not only cause major water flow issues, but can also cause your heater to shut down as well. Needless to say, with no heater, sitting in your hot tub will not be so hot, so make sure your hot tub is always topped up to optimal levels.

How do you find a leak in a hot tub?

How to Find a Hot Tub LeakTurn off power to the hot tub. ... Examine the fittings and pipes leading to the pump and the spa's heater. ... Follow each pipe to its jet looking for signs of leakage along the way.Place a drop of dark food coloring in the water in front of a jet. ... Let the water set to see how far it drops.More items...

Why does my pool pump not seal?

When the pump shuts off, water cannot flow back through the pool returns, which prevents the spa from equalizing and allow it to remain full. The parts inside of the valve can become worn over time, and in turn, cause it not to seal correctly after the pump and filter system times out.

What happens when the pool level is higher than the spa level?

If the spa's water level is higher than that of the pool, when the pump stops pushing water to the spa and pool, the spa will equalize itself to the level of the pool in a process known as equalization. No water is being lost.

What happens when a pool pump shuts off?

When the pump shuts off, water cannot flow back through the pool returns, which prevents the spa from equalizing and allow it to remain full. ...

What happens if the return valve is turned toward the spa?

These valves are positioned for pool mode only. If the return valve was turned toward spa, this will create an overflow (fountain)

What is a pool/spa combination pool?

A pool/spa combination pool uses the same water for both the spa and pool. Most use the same pump; some may have an added spa pump. Valve position is the main factor in determining where the water is flowing. The most common position for valves is to direct water to both the pool and spa in order to create a spa "overflow" or fountain effect ...

What is a spa spillover valve?

The most common position for valves is to direct water to both the pool and spa in order to create a spa "overflow" or fountain effect when the spa is not in use. This is referred to as "spa spillover". Many systems are now using automatic valves called "actuators" that are motorized and controlled by the touch of a button via an installed ...

Can a spa pump pull water out of the spa?

Answer: No, because in normal operation the spa main drain should be in the closed position already and the pump won't pull water from the spa.

Can you use drain mode in service mode?

through the system. “Fill/Spillway” and “Drain” mode can only be used while in “Service” mode

Does a pool pump switch off?

pump will switch off while the pool/spa valves are rotating into position. The current operating

Why does my spa keep draining?

There are really only a few reasons as to why the spa is draining. Most commonly, it is simply due to a failed, or stuck check valve in the plumbing at your equipment. A raised body of water that actually shares the same system as the main pool that is lower than the spa naturally wants to drain into the main body of water below it because ...

Why Does The Spa Drain When The Pump Shuts Off?

Oh no! Did you wake up today, look out your window, or walk out to your pool area and notice that the spa was nearly empty? Is it leaking? Where’d the water go? Is it under the deck? But, there isn’t any water gathering that you can see.

Why does my pool drain water?

Air leaks. Pool equipment including the plumbing can end up getting an air suction leak, or even an air pressure leak. What can happen is due to gravity, once the system shuts off, air can make its way out of the system. This can cause the water in the system to drain.

What is a check valve in a pool?

The check valve prevents back water flow from going into the pool. Sometimes, that valve goes bad or gets stuck allowing the water from the spa to drain back into the swimming pool. It’s an illusion! There is no actual leak. Essentially, it is just moving.

Why should the spa drains be cracked open?

They should be set so that there is more water going to the spa than the pool to get the waterfall effect into the pool the spas drains should only be cracked open to help keep it clean. These valves may have gotten out of sinc due to a power bump /someone moving them with the switch etc.

Why is my vac pump draining down?

It could be a check valva failure and it could be underground. It could also be a small air leak getting into system causing the vac to break when pump is off causing the draining down.

Where does water go in a pool pump?

water enters the front of the pump , is pumped to the filter then to the heater [ and or solar , if you have it ] and to the return jandy valve to the pool, however if you look at the return plumbing you should see a pipe connecting the pool return and the spa return with a check valve , this is the spa by-pass .

Why are my jandy valves out of position?

They should be set so that there is more water going to the spa than the pool to get the waterfall effect into the pool the spas drains should only be cracked open to help keep it clean. These valves may have gotten out of sinc due to a power bump /someone moving them with the switch etc. Its probably just a valve setting if you haven't seen a water lose or you don't see air bubbles from returns when running, which would be a sign of an air leak on the equipment.

Is The Spa Leaking?

If It Doesn't Leak, Why Is It draining?

• If the spa's water level is higher than that of the pool, when the pump stops pushing water to the spa and pool, the spa will equalize itself to the level of the pool in a process known as equalization. No water is being lost. Although it's not very noticeable, the pool actually receives the amount of water that has equalized from the spa.

See more on dengarden.com

What Is Causing This, and Can It Be fixed?

More About Pool and Spa Combination Pools

Questions & Answers

Comments