Why Won’t My Frigidaire Affinity Washer Drain?
- Drain Pump More often than not, the main reason that your Affinity washer will not drain is due to an obstruction, damage, or malfunction in the drain pump. ...
- Clogged Hose or Pump in the Drain System ...
- Door Lock Motor and Switch Assembly ...
- Lid Switch Assembly ...
- Coin Trap ...
- The Drain Hose ...
- Malfunctioning Settings ...
Why is my Frigidaire washing machine not draining?
- Verify that your Frigidaire front washer is plugged into a working electrical outlet and turned on; otherwise, you won't be able to reset it.
- Press and hold the "Spin Speed" and "Soil Level" buttons together for a few seconds.
- Continue holding the buttons until a signal sounds then release them.
What would cause my washer not to spin or drain?
Try These Easy Fixes
- Common Reasons a Washer Won’t Spin. In this post, we’ve outlined the most common reasons a washer won’t spin. ...
- Drive Belt. Your washing machine’s drive belt helps the motor power the spin of the drum by wrapping around the motor and a pulley wheel.
- Drive Motor. ...
- Motor Coupler. ...
- Lid Switch. ...
- Broken Pump. ...
- Repair Costs When a Washer Won’t Spin. ...
- Washer Won’t Spin? ...
Why is my washer not spinning all the water out?
| What You Need to Know
- Check Your Machine’s Power Supply. Perhaps one of the easiest answers to the question, “Why is my washer not draining or spinning?” is in its power source.
- Reset Your Machine. If your machine has this function, try performing a master reset on it. ...
- Check the Machine’s Position on the Floor. ...
- Rebalance the Washer’s Load. ...
- Inspect the Lid Switch. ...
Why is my Whirlpool Cabrio washer not draining?
Why is my Cabrio washer not draining? Check the washer's discharge hose if the water fails to drain from the washtub. Look for any kinks in the Cabrio washer's discharge hose that could stop the water from draining. Straightening the hose ensures proper draining. Test the drain pump to ensure it has not failed if the washer still will not drain.
See more
How do I force my Frigidaire washer to drain?
If not, follow these steps:Step 1: Turn off the power and lay down towels.Step 2: Locate the drain hose at the back of the washing machine.Step 3: Drain the water.Step 1: Turn off the power and lay down towels.Step 2: Locate the drain hose.Step 3: Drain the water.Step 4: Scrub the filter.
What causes washing machine not to drain out the water?
A washing machine not draining can have multiple causes, including a clogged or jammed drain hose or a broken pump, lid switch, or belt. No matter the culprit, you need to drain the water from the washing machine before diagnosing the issue or doing any work to remedy the situation.
Where is the drain pump on a Frigidaire washing machine?
0:409:29How To: Frigidaire/Electrolux Drain Pump 137221600 - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou'll need to remove this dispenser assembly to do so pull it out until it stops. Then press thisMoreYou'll need to remove this dispenser assembly to do so pull it out until it stops. Then press this button here which will allow you to release it from the machine with the detergent dispenser removed.
Why won't my washing machine won't drain?
0:102:07Top-Load Washer Won't Drain — Washing Machine TroubleshootingYouTubeStart of suggested clipEnd of suggested clipYourself. If your top load washer won't drain. Here are the top three most probable causes. TheMoreYourself. If your top load washer won't drain. Here are the top three most probable causes. The drain cycle begins when the control sends voltage to the drain pump. Which pumps the water out the drain
How do I know if my washing machine drain pump is bad?
A common complaint is that the water in the washing machine drum will not drain, or that the washing machine has stopped mid-cycle with it still full of water. Another common issue is that the washing machine drum will not spin, or it won't drain properly.
How do I get my washer to drain?
How to drain a washer filled with waterTry the spin cycle. ... Turn off the power and water supply. ... Remove and check the drain hose. ... Check to see if it will drain with the help of gravity. ... Check your machine's inner workings. ... Check the drain pipe. ... Drain manually if needed. ... Call a service professional.
How do you test a washing machine drain pump?
0:522:51Front Load Washer Won't Drain - How to Test the Drain Pump - YouTubeYouTubeStart of suggested clipEnd of suggested clipI set my meter to volts EC turn the washer to the drain spin cycle that way when you start the firstMoreI set my meter to volts EC turn the washer to the drain spin cycle that way when you start the first thing that's going to happen it's going to try to drain.
Where is the drain filter on a Frigidaire top load washer?
0:4113:40How To: Frigidaire/Electrolux Filter 137518800 - YouTubeYouTubeStart of suggested clipEnd of suggested clipAll you have to do is pull it out till it stops. And then on the back left corner there's a littleMoreAll you have to do is pull it out till it stops. And then on the back left corner there's a little release tab you have to press down on. And you can't pull it off the rest of the way.
How do you troubleshoot a Frigidaire washing machine?
0:001:52Troubleshooting Your Washer Not Starting - YouTubeYouTubeStart of suggested clipEnd of suggested clipStill no power check to ensure house fuse isn't blown or the circuit breaker tripped. You can alsoMoreStill no power check to ensure house fuse isn't blown or the circuit breaker tripped. You can also check to make sure the water supply faucets are turned. On. Make sure the washer lid is closed.
How do I know if my washing machine drain hose is clogged?
The number one sign of a clogged drain affecting your washing machine is finding water inside the unit after the washing cycle is complete. During the cycle, water is flooded into the chamber of the machine, mixing in with the detergent to clean your clothing.
How do you fix a clogged drain pump on a washing machine?
0:413:17Washer Repair: How to Unclog the Drain Pump - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd the top one is the inlet port that has a short hose goes right up to the bottom of the outer tubMoreAnd the top one is the inlet port that has a short hose goes right up to the bottom of the outer tub. Any items that may be stuck in that pump are typically going to be on the inlet port.
Why is there water at the bottom of my washing machine?
Water In Bottom of Washing Machine Drum: Why It Happens Your drain hose is kinked. Your lid mechanism is broken or not engaging fully. Your drain or hose is clogged. Your load was too large for a good spin cycle.
Why are my clothes soaking wet out of the washer?
Loading Too Many Items. Overloading can lead to an imbalance that reduces the washer's spin speed, leaving clothes too wet after spin cycle completes. If the washer leaves clothes soaked after a large load, remove some items, redistribute others and run another rinse and spin cycle.
What causes a washing machine not to drain and spin?
Top reasons washers won't spin or drain Worn drive coupler or broken belt – A top-load washer drive coupler connects the motor to the washer transmission. The coupler can wear out over time or fail, especially if the tub is consistently overloaded. Similarly, a drive belt can wear out, break, or slip on the pulleys.
How do I know if my washing machine drain hose is clogged?
The number one sign of a clogged drain affecting your washing machine is finding water inside the unit after the washing cycle is complete. During the cycle, water is flooded into the chamber of the machine, mixing in with the detergent to clean your clothing.
Why is there water at the bottom of my washing machine?
Water In Bottom of Washing Machine Drum: Why It Happens Your drain hose is kinked. Your lid mechanism is broken or not engaging fully. Your drain or hose is clogged. Your load was too large for a good spin cycle.
Why is my Frigidaire washing machine not draining?
Malfunctioning Settings. Another quite common cause for drainage issues in a Frigidaire Affinity washing machine pertains to issues with the settings. When they aren’t working correctly, your machine will fail to work in an optimal capacity at best and may not work at all at worst.
Why won't my washer drain?
When debris is allowed to continue accumulating in the coin trap, it can become clogged and lead to your washing machine failing to drain properly . When the washer won’t drain or isn’t doing so as it normally would, checking the coin trap and cleaning it can be a quick fix.
Why Won’t My Frigidaire Affinity Washer Drain?
Multiple components, any of which can go bad at any time , could potentially lead to draining issues with your washer.
Why Does My Frigidaire Affinity Washer Keep Pausing?
This is typically denoted with a PAU to indicate that the cycle was interrupted and has not been restarted properly.
How Do You Run a Clean Cycle on a Frigidaire Affinity Washer?
One of the great things about modern washing machines like the Frigidaire Affinity is that it has a self-cleaning functionality.
What happens when a washer lid switch stops working?
When that lid switch assembly stops working, the washer won’t drain. In order to check for a defective switch assembly, you can use your multimeter to check for continuity in each of the lid switches. Whichever ones don’t show that continuity, replace them.
How to check if a washer is clogged?
The only way to check for an obstruction is to remove all of the hoses from the pump. Don’t just check the ends of the hose, either. 2. Look deep. Use a flashlight to look down into the hose for any potential clogs that could be keeping your washer from draining properly. 3.
Common solutions for: Frigidaire Washer won't drain
Sometimes, small objects or articles of clothing can get caught in the drain pump. To determine if anything is blocking the drain pump, remove the drain pump and check the pump for obstructions. If the drain pump is clear of obstructions, but is still noisy during the drain cycle, replace the drain pump.
The Right Parts for the Job
We carry more than 4 million parts from over 175 major brands, so chances are, we've got the part you need.
Why won't my washer drain?
If your washer won’t drain or spin, the water level control may be faulty. Open the machine’s control panel and look for a plastic tube attached to the water level valve. If it’s clogged, clear it out with vinegar. If the valve itself is corroded, it may need to be replaced.
How to reset a washer that won't turn on?
Unplug your washer for about one minute. Then, plug the appliance back in. Open and close the door six times in 12 seconds to tell the computer to reset everything. This may not work on all machines, but it’s an easy fix if yours is compatible with this technique.
Why does my washer spin when it's top loading?
Top-loading washers will only drain and spin if the lid is securely closed. Therefore, a defective lid switch assembly could be causing the problem.
What happens if you remove the hose from a washer?
Be aware that if you remove the hose to get an obstruction out of the pump, any water in the washer will come pouring out. To avoid a mess, scoop out as much water from the drum as possible before disconnecting the hose.
What to do if your washer hose is kinked?
Adjust the hose behind the washer to make sure water can easily flow through it. If the hose is kinked, that could stop an otherwise functional machine from draining.
What is a washing machine?
A functional washing machine is an effective tool for getting dirt, sweat, and stains out of clothing. The exact way the washer cleans your clothes depends on the precise settings you choose, but the basic premise is the same: first, the drum fills with water when you hit “Start.”.
Can a sock clog a washing machine?
Remove the front panel of the washer and check for any obstructions in these areas. If you find anything, remove it to see if you can get the washing machine to drain.