Hanging regular curtains from a traverse rod is possible provided that they feature certain qualities. You first have to check if the curtains can be customized. See if you can add pins that can then be connected to the openings in the traverse rod. You should also consider how big the curtains are.
How to hang curtains with transoms?
How To Hang Curtains On An Arch Or Transom Window. In most cases hanging curtains can be as easy as tossing a curtain rod above the windows and slipping the curtains on the rod. This is not always the case when there are unique windows in the home. Some examples are transom windows or arched windows. These windows were likely designed to be ...
How to use tension rods to hang curtains?
Part 2 Part 2 of 2: Installing Correctly
- Measure for the height of the rod. Use a measuring tape. ...
- Mark where the brackets will go. When you're sure of all your measurements, use a pencil to mark where the screws will go.
- Add a mid brace if needed. ...
- Drill pilot holes to help start the screws. ...
- Screw the brackets to the casing or wall. ...
- Check for level. ...
- Put the curtains on. ...
How to hang two sets of curtains on one rod?
- Be sure to match the width of the panels with the length of the curtain rod. ...
- Take care of natural light. Opened curtains should aesthetically frame the window and at the same time allow maximum daylight into the room. ...
- Don’t overlook decorative elements. Match brass rings to the brass curtain rod, chrome to the chrome. ...
How to convert tab back curtains to traverse rod?
- Mount the traverse rod supports and bracket according to the packaging instructions. Hang the rod in the supports and brackets.
- Measure the width of your curtain panels. Cut a piece of pleater tape to this size.
- Lay the curtains flat, wrong side up.
- Carry one curtain panel at a time to the traverse rod.
How do you put curtains on a traverse rod?
2:384:24Signature Series | How to Install Pinch Pleat Draperies with Traverse RodYouTubeStart of suggested clipEnd of suggested clipIt insert the first drapery pin into the first hole of the master carrier followed by the second pinMoreIt insert the first drapery pin into the first hole of the master carrier followed by the second pin into the second hole and so on insert the last pleat into the last ring or glide on the rod.
Can I hang rod pocket curtains on a traverse rod?
Although the traverse rod system was made for pinch pleat curtains, you can adapt almost any rod pocket curtain to work on the rods.
Can you put grommet curtains on traverse rod?
You can make your curtains to use with traverse rods. Finding the style of the grommet, particularly one that matches the material your rod consists of, is a good idea.
Are traverse rods out of style?
Are Traverse Rods Out Of Style? Traverse curtains can be difficult to find in stores, but that's because of demand, not lack of style. This style of curtain has a timeless and sophisticated look that never really goes out of style. However, they are more expensive.
Can I use curtain hooks on rod pocket curtains?
Pinhooks can give you the custom-pleated look you want without the wear and tear on your wallet that nobody wants. The best news is that with a little ingenuity, pinhooks can be used with rod pocket curtains and a curtain rod, sparing you the expense of the more traditionally-used traverse rod.
What do you call curtains that go on a track?
Pencil pleat curtains can be hung from a track or a pole. Tab top and Eyelet curtains must be hung from a pole. Pinch and Goblet pleat curtains can be hung from a track or pole but as they hang underneath either, to enable the curtains to concertina back properly, the track or pole will be in full view.
Can you use rings on a traverse rod?
There are decorative traverse rods, even those with rings, which are constructed with hidden slides to give you the best of both worlds. You can choose metal or wooden poles, with or without rings, depending on your style.
How do you make pinch pleated drapes for a traverse rod?
2:3914:56How To Make A Pinch Pleated Drape (Figuring Pleats And Spaces)YouTubeStart of suggested clipEnd of suggested clipNow we're talking about with the overlap. This is the overlap. This site right here this is yourMoreNow we're talking about with the overlap. This is the overlap. This site right here this is your leading edge or your overlap.
When should you use a double curtain rod?
Although very similar in design to single curtain rods, a double curtain rod allows you to layer more than one drapery panel or curtain for a more enhanced and dramatic look. Most typically, people layer a sheer curtain first and then a regular curtain on top to block out light.
Can you hang back tab curtains with hooks?
0:442:50How To Hang Pole Pocket Curtains With Back Tabs , Pole ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipHooks. You'll be given a set of these and well here's how we do this you're going to use not the tabMoreHooks. You'll be given a set of these and well here's how we do this you're going to use not the tab. But the hook belt.
What's the difference between a drape and a curtain?
Curtains are fabric panels used to cover windows, and are generally cut to fit a window or drop a few centimetres below it. Drapes are also fabric panels but are generally made from thicker fabrics and cut to floor length or to slightly puddle on the floor.
Can you use rings on a traverse rod?
There are decorative traverse rods, even those with rings, which are constructed with hidden slides to give you the best of both worlds. You can choose metal or wooden poles, with or without rings, depending on your style.
How do drapery pins work?
0:021:39Drapery Pins - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou can lower the pins along the back of the pleat header. To add length move the pins up higherMoreYou can lower the pins along the back of the pleat header. To add length move the pins up higher just be sure to keep the pin setting measurement consistent across the panel.
How do you use pleating tape for curtains?
0:574:59How-To Use Triple Pinch Pleat Tape - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd which side is going to be on the end on either side of your drapery. And start with a pin. RightMoreAnd which side is going to be on the end on either side of your drapery. And start with a pin. Right on the edge. And then let the tape fall out as it may.
How do you remove a hook from a traverse rod?
0:037:04How to Replace Slides for Traverse Rods for Curtains and Drapes + ...YouTubeStart of suggested clipEnd of suggested clipAnd pull them out and very quickly the whole slide can come off quite easily. And you can see thatMoreAnd pull them out and very quickly the whole slide can come off quite easily. And you can see that these will just slowly come off without any problem and these are pretty easy to remove.
What is traverse rod?
Traverse rods feature a track that is then positioned inside a slot carved into the body of the rod. That track is responsible for accommodating clips that allow the traverse rod to work as expected.
Why is a traverse rod important?
The number one reason why homeowners like traverse rods so much is because of how easy they are to use.
What is pinch pleat curtain?
Pinch pleat curtains are the ones that are meant to be used with traverse rods. The issue with pinch pleat curtains is that they don’t cover as much space as regular curtains. Homeowners may purchase curtains that are the same size as their traverse rod and not realize their mistake right away.
How to keep curtains in place?
In order to keep the curtains in place, you have to connect the curtain pins with the corresponding pins. As long as the pins are well designed, you should have no trouble getting the curtains in the right spot. Your selection is limited somewhat by the fact that you need pins to be present on the curtains.
Why are curtains important?
The curtains are important elements of your home. They beautify your home while simultaneously offering privacy, light control, and even some level of insulation. Placing curtains over your windows and leaving them be is an option. If you want to continually tinker with your curtains though, using a traverse rod is advisable.
How to connect a master carrier to a traverse rod?
Look for the master carriers on the traverse rod and start by reaching for the one on the left side. Connect the first pin to the hole in the master carrier. Continue by connecting the second pin to the master carrier.
Is a traverse rod a good curtain?
A traverse rod can prove to be a good addition to your home, especially from a functionality stand point. Get the most out of it by pairing it with the right set of curtains. Learn more about how to choose the right curtains for your traverse rod and other relevant topics by reading on.
What is traverse rod?
Traverse rods make it easy to open and close the drapes. An intermediate skilled home sewer can utilize drapery maker tricks and successfully hang non–pinch-pleated drapes on a traverse rod, hiding the pins and providing enough support for the weight of the drapes. A traverse rod allows drapes to be opened and closed by pulling on a cord hanging ...
How does a traverse rod work?
A traverse rod allows drapes to be opened and closed by pulling on a cord hanging to one side of the drapes. The cord connects to pulleys in the headrail, which moves the drapery carriers across the rod. The drapes connect to these carriers by an N-shaped pin, called a drapery pin.
Where are drape pins inserted?
One straight, pointed end of the pin is inserted into the back of the drapes, and the other end is hooked through a hole in the carrier. The weight of the drapes hangs on the pins. The construction of drapes includes header tape that reinforces the fabric against the pull of the pins. With careful insertion, the pins will not be visible from ...
How to make a drapery panel?
Step 1. Turn the drapery panel inside out and check for the presence of heading tape. This is a fabric-like piece, typically 4 inches wide, that is sandwiched between the drape and the lining. If none is present, lay a piece between the layers and turn the drape right sides out.
How to attach drapery pin to traverse rod?
Insert a drapery pin into the seam so the bottom edge of the pin aligns to the pin mark and hook the pin into the carrier of the traverse rod. Insert pins, at the same distance from the top edge, into the outside edge seams of the curtains.
How to use a traverse rod?
If you want to use a traverse rod, that opens and closes with the pull of a cord, you need to alter your tab-back panels to accept a drapery pin. Just by making a small single-finger pleat, the curtains can accept a pin and hold the folds in place as the curtains are opened and closed on a traverse rod. 1. Place a pin perpendicular ...
How to make a curtain with a pin?
1. Place a pin perpendicular to the top edge of the curtain, midway between each tab. 2. Lay the curtain on the table, the top of the curtain toward you and the tabs against the table, the right side of the curtain is on the surface. 3. Draw a 4-inch line perpendicular to the top edge between each tab, using the pin as the starting marker.
Do tab back curtains fold?
Tab-back curtain panels hang in gentle, even folds only when you arrange them across the rod ; the panels lose their neat folds when the curtains are opened and closed. Because they must be hung on a decorative rod and moved manually, they might not be as functional as you'd like. If you want to use a traverse rod, ...
