Full Answer
Do recessed can lights need maintenance?
Installed properly, recessed can lights rarely need maintenance, although like any light fixture, light bulb sockets can wear out or go bad, and wire connections can loosen and require reconnection. In rare instances, the thermal sensors can go bad, leading to a fixture that periodically "goes dark" until the sensor cools and resets itself.
Do Canless recessed lights get hot?
The short answer is Yes, canless recessed light can get hot. However, not at a high temperature. Canless recessed lights can get hot, but they dissipate the heat out of the housing. This design is much safer than traditional recessed lights.
Where can recessed lights be used?
Home movie theaters: Theaters benefit from the clear sight-lines that recessed lights provide. Kitchen perimeter/above counters: Since recessed lights are directional, they work well as kitchen task lights to direct light down onto countertops, or to cast light across the face of kitchen cabinets.
Are led recessed can lights worth the cost?
LED fixtures often cost a little more than standard recessed lights, but the energy cost savings makes them a good bargain over the long run. Installed properly, recessed can lights rarely need maintenance, although like any light fixture, light bulb sockets can wear out or go bad, and wire connections can loosen and require reconnection.
What is the difference between canned and recessed lighting?
Canned lights are a type of recessed lights. They get their name from the fixture that sits within the ceiling, which is a cylinder, almost like a metal can. This can is essentially the holder for a light bulb, instead of having a lower-hanging pendant that you would install the bulb into.
How do you install no can recessed lights?
3:5717:03DIY | How To Install Recessed Lighting With No Housing or J-BoxesYouTubeStart of suggested clipEnd of suggested clipHere. We have this is the wires that are coming from this so we need to take this panel off rightMoreHere. We have this is the wires that are coming from this so we need to take this panel off right now so in order to do that we need to get the screwdriver.
Do you need a junction box for recessed lights?
Common examples of electrical devices that require no junction boxes include: Recessed lights ("can lights") Bathroom ventilation fans.
What can I use instead of can lighting?
Recessed Lighting AlternativesDisc Lights.Pendant Lights.Spotlights And Downlights.Tube Lights.Track Lighting.Flush Mount Lights.Cheaper Alternative To Recessed Lighting.Alternative To Recessed Lighting In Kitchen.More items...
What is a Canless recessed lighting?
Canless recessed lighting does not come with canisters or housings to hold the bulb. They are thin—or ultra-thin—and use LED light integrated into the system. They are compact and can fit into tight spaces.
Do you need an electrician to install recessed lighting?
Installing recessed lighting can be challenging—you might want to hire an electrician to do the job. Even if you're experienced in wiring light fixtures, installing recessed lighting comes with some challenges that may be best left to a professional.
Can you install a ceiling light without a junction box?
You can't install a light fixture without a junction box, but the fact that there's no box at the spot where you want to install the light doesn't mean you can't install the light.
Can you replace a regular light with a recessed light?
Converting a standard ceiling light fixture to a recessed light involves removing the old fixture and its electrical box and installing the new recessed light, usually in the same place. Alternatively, you can install the new light in a different location nearby.
Do LED lights require a box?
They do not need anything but a clamp to protect the wire coming in the fixture And the push connectors or wire nuts. OP says "Similar To", not "Identical To". Don't get pissy.
What is better than recessed lighting?
Luckily, there is now a better alternative to recessed can lights. What many people are now using in their homes instead of recessed can lights is a light fixture called a disc light. The disc light is a very thin LED light, typically about an inch tall, that is mounted to the surface of the ceiling.
Does recessed lighting increase home value?
LED recessed lighting is particularly appealing to prospective buyers and, according to research by Vonn, could add anything between 1% and 3% to your home's value – enough to pay some estate agent fees!
How much does it cost to put in a can light?
For the fixture itself, budget roughly $20 to $30 per light for traditional can lights. The cost to install traditional can lights is around $100 to $250 per fixture, depending on materials and finishes.
How can I get ceiling lights without wires?
To install a ceiling light without wiring, look for plug-in pendant lights. These are single lights that hang by a cord from the ceiling and plug into a nearby outlet.
Can I install recessed lighting myself?
If you have a nearby power source, you can easily install recessed lights by yourself. Bringing in a power source adds some time to the project, but this can be accomplished by wiring your own circuit or hiring an electrician.
How do you install a ceiling light without a junction box?
1:594:38How to install a light fixture where there is no electrical box - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst. So i take. The center part of the light. I found some wood to screw to. And i screwed it toMoreFirst. So i take. The center part of the light. I found some wood to screw to. And i screwed it to the wood and the other ones you can see i put them in an angle with coarse screws.
How do you hook up recessed lighting?
7:278:49How To Install Recessed Lights | Ask This Old House - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe junction box goes up into the hole in the ceiling. And secures in place by installing a screwMoreThe junction box goes up into the hole in the ceiling. And secures in place by installing a screw and then hanging the junction box on the keyhole slot in the back.
Why Are Recessed Lights Better?
Are they better? Well, yes, and no. Done haphazardly or without thought, recessed lights can look…bad. Done well, recessed lights should not be all that noticeable, and they should do a specific job, such as provide task lighting, create a direct path of light in an area that is not well-lit, or light high or hard-to-reach areas.
Where Should You Have Recessed Lights?
Recessed lights should be placed in a work area that needs to be well-lit, such as in a kitchen.
Are Recessed Canister Lights Right for You?
Recessed light fixtures are a good choice where you want to aim light in a particular direction— either straight down or against a wall feature— or where low ceilings make it necessary to use low-profile lighting fixtures that don't hang or protrude from the ceiling. For whole-room illumination, remember that recessed lights usually need to be installed in groups of several fixtures to provide adequate light.
What is a recessed light fixture canister?
Called recessed light fixture canisters, can lights, or cans, these are light fixtures contained up inside an inverted can that is mounted fully above the line of the ceiling.
How much does a recessed light cost?
At big-box home improvement centers, costs can range from around $5 to around $30 for individual fixtures, but convenient multipacks are also available, offering four, six, or eight fixtures in a kit.
What are the parts of a recessed light fixture?
The parts of a recessed light fixture include: Bar hangers: Most recessed light fixtures have two adjustable bar hangers that allow you to brace the fixture between ceiling joists to hold it firmly in place.
Why did insulation in the 1970s help?
During the first energy crisis of the 1970s, homeowners began adding thick layers of insulation to their attics to conserve energy. People sometimes found that covering recessed fixtures with insulation caused them to overheat, sometimes to a degree that caused home fires. Several solutions were quickly developed.
Why do you need illumination?
Because the fixtures themselves aren't very visible and don't call attention to themselves , the illumination itself is what serves the design element. They work well in situations where you want to provide illumination around the edges of room, such as when lighting up a bank of kitchen cabinets.
What is the wire that runs from a light fixture to a junction box?
Wire cable: Most fixtures have a metal cable that contains the wire leads that are attached to the circuit wires. The cable runs from the light fixture to the junction box, protecting the wire leads.
What Is Canless Recessed Lighting?
Recessed lighting has been a part of the real estate industry since the 1950s. Walking into a home that does not have them is almost impossible these days.
How deep do you need to install a canless recessed system?
The single-unit canless recessed system is not complex to install with its less chunky junction or electrical box. You only need a few inches deep of ceiling space.
Why do homes have baffle trim?
Since most trims are metal, most residential homes use baffle trim to prevent the light from glaring. The bulb sits a few centimeters inside the trim, casting a cone-shaped light.
How long do LED lights last?
Moreover, LEDs have 80 percent longer brightness. They can last anywhere between six and 11 years, making them a top choice among homeowners who want to save on their electric bill. An LED light used 24/7 can last you up to six years.
Is canless LED lighting more economical?
Although the whole setup may be pricey, the extensive lifespan of canless LED lighting fixtures are more economical in the long run.
Does canless recessed lighting work against you?
The compact feature of canless recessed lighting works against you come replacement time.
Do canless recessed lights follow instructions?
Unlike can recessed lights, the canless versions for different brands do not follow a standard set of instructions for installation. They also differ in functions, with some more high-tech than others.
What is Recessed Lighting?
Recessed lighting refers to lighting fixtures built up into a ceiling, rather than hanging from it. The bulb can be enclosed in a tubular can to focus the light straight downward. There are also canless recessed lights.
Types of Recessed Lighting
New construction lights go into the ceiling before putting up the drywall. The main light canister is suspended by adjustable hanger bars that nail into the ceiling joists on either side of the cavity. The canisters are usually prewired and come with thermal guards to prevent air passing between floors.
What to Consider Before Buying
First, examine the area you want to illuminate. Do you need straight downward lighting or task lighting in a particular area? For task lighting, consider a moveable eyeball-style spotlight. With these, you position the light to bathe the area you want, like a fireplace mantel or a specific area in your kitchen.
How Much Does Recessed Lighting Cost?
Recessed lighting costs vary. Remodel boxes go for around $20 each, though cheaper models are available. For unfinished ceilings, new construction recessed lights can be had for as little as $8 each. In both instances, it’s typically more economical to buy in bulk.
How to Install Recessed Lights
Installing recessed lights is a simple task in an unfinished space. Begin by fastening the hanger bars on either side of the ceiling joists. Make sure the light isn’t installed too far into the cavity; put it closer to where it will be flush with the drywall. The trim piece will cover up the difference.
Can a Handyman Install Recessed Lighting?
A handyman is a person who can fix domestic repairs and minor renovations at home. It’s not a good idea to hire a handyman if electricity and lighting wiring are involved. To ensure everyone’s safety, it’s better to hire a licensed electrician who is more professional than handyman. Electricians have more knowledge and experience in electronics.
What does an electrician do for a house?
Electricians know how to handle the house cables, how and where to drill – the diameter and depth of the recessed lighting holes. In addition to passing the quality inspection, a licensed electrician can also ensure the safety of your house. Incorrect wiring can cause fire and electric shock.
Why do you hire an electrician?
Hiring an electrician or electrical contractor has its advantages. Because electricians are proficient in lighting circuits and installation, they can avoid many common mistakes. Besides, since you are already working with a licensed electrical contractor, you no longer need to worry about the permits.
How long does it take to install a recessed light?
Assuming you hire a licensed electrician, each recessed lighting fixture may take up to half an hour to install. If it is a newly installed recessed light, it may take longer because some changes to the wiring are required.
What happens if you put too many recessed lights?
If you put too bright or too many lights, you will be blinded by the glare. If the number and lumen of recessed lights are not enough, it will bring you dim lighting effects.
What is recessed lighting?
Recessed lighting is a popular lighting equipment nowadays. Before installation, you may need to understand the recessed lighting codes in order to comply with the regulations and ensure the safety of the house. The following are the code requirements for recessed lighting.
Why do you need a permit for recessed lighting?
If it is a new recessed lighting installation, a permit is necessary because it involves altering the house wiring.
Why Buy From Del Mar Fans & Lighting?
There are many reasons to buy from Del Mar Fans and Lighting, however, here are just a few reasons we would like to bring attention to!
What is recessed lighting?
Recessed lighting fixtures are light fixtures that are installed in the ceiling to provide task, accent, ambient, and wall washing lighting effects. They aren’t as decorative or expensive as chandeliers or pendants and aren’t as complex as track lighting -- but they can still be a difficult topic because they require knowledge ...
How deep should a downlight be?
Most residential downlights top out at 7 ½” deep, meaning they will generally fit. Shallow recessed lighting is available if you don’t have much room. Most shallow recessed light fixtures are only 5” deep or less. There are deep housings available if you have extra room.
How wide is a standard ceiling joist?
Standard Measurements: The average home uses ceiling joists that range from 2x4 to 2x12 inches. The width of the board determines the height of the ceiling. Joists have a standard spacing of 16-24 inches, regardless of their size or length.
What is the best size recessed light for a task?
Three-inch recessed lighting is the most standard for task lighting, with an aperture of 3 inches a light beam can be concentrated in one area. Proper placement for recessed lighting that is being used as task lighting is to place your can lights flush with the ceiling and over your task area.
What are the drawbacks of IC rated recessed lights?
The drawback to IC Rated recessed lights is that the light source is located closer to the trim, increasing the glare. Manufacturers will limit the wattage that can be used in IC Rated recessed fixtures. A way to avoid glare would be to use a fixture such as a pendant or chandelier paired with a dimmer instead of can lighting.
What is the best trim for ambient lighting?
The most appropriate trims for ambient lighting: Standard Open Trims. Premium Baffles.
LED Lighting projects are very popular because they add so much to your home
So, to help me answer that question, I have Jason Medich. You can go to my website. Jason is in our Directory of Contractors. He’s a great electrician. Otherwise, he would not be one of our Trusted Pros. We only have qualified, quality contractors on our website.
When in Doubt, Hire it Out
Jason: Exactly. If you don’t feel comfortable with it, electricity can cause fires. Electricity can severely injure you if you don’t know what you’re doing. So, yes, get someone who does.
