Uninstall the Old Drain Pump
- Release Drain Hose Spring Clamp with Pliers Look underneath the washer and you will see several exposed components. ...
- Remove Drain Hose Now the drain hose is loose and can be pulled off the end of the drain pump. ...
- Open Wire Harness Compartment On the drain pump housing is a small compartment that flips open. ...
- Disconnect Wires ...
- Remove Mounting Bolts ...
- Extract and Discard Old Drain Pump ...
How to clean pump filter on a front load washer?
This process is for Front Load Washers with an access cover at the bottom, front of the washer only:
- Using a coin or flat screwdriver in the notch on the door, open the access door.
- Place a shallow pan or dish under the pump access door, and place towels on the floor in front of the washer to protect the floor. ...
- Pull down the pour spout.
- Turn the pump filter counterclockwise and remove the filter. ...
- Clean the debris from the filter.
How to drain water from Samsung washing machine manually?
— For Top Loaders
- Turn your washer’s power off.
- Get a bucket.
- Scoop out the water from the washer using the bucket until you can’t take out any more water.
- Run a Spin cycle to remove any water remaining in the drum. This Is An Original Part! Installation Instructions Are NOT Included With This Part!
How to disassembling Samsung washer front load?
- To complete the removal of the front panel, use a pair of needle nose pliers to remove a retaining wire that holds the door boot seal in place.
- Pull the seal away from the lip of the front panel.
- Remove two screws that secure the door latch assembly in place.
- Open and remove the filter access door and release the drain tube from the retaining tab.
How to unclog Samsung dishwasher drain?
- You can access the drain hose by removing the kick plate on the front of the dishwasher.
- The drain hose runs from the drain pump on the bottom of the dishwasher to the sink drain or air gap on the sink.
- Use a flashlight to follow the hose to the drainage area.
- Correct any kinks in the line.
Where is the drain pump filter on a washer?
How to remove a spring clamp from a washer?
How to seat a washer panel?
How to catch a leak in a pump?
How to unplug wire harness?
See 2 more
About this website
LG Front Load Washer - Cleaning the Drain Pump Filter
[Logo] LG Makes It Easy [Title] LG Front Load Washer : How to clean the Drain Pump filter . Your LG Front load washing machine is equipped with a drain pump filter that makes lost button or loose change a thing of the past.
Where is the drain pump filter on a washer?
Open the drain pump filter cover at the bottom of the washer front panel.
How to remove a spring clamp from a washer?
Use the outer spring pliers to expand the spring clamp and remove it from the door boot. Release the rubber door boot from the lip around the opening to the washer tub on the front panel. Remove the 7 screws from the top of the front panel. Close the washer door.
How to seat a washer panel?
Push the panel down and forward to seat it on the washer frame.
How to catch a leak in a pump?
Put a towel under the pump body hoses to catch leaks.
How to unplug wire harness?
Unplug the wire harness connections for the control panel by pressing on the release tabs and sliding the connectors apart.
When should a washer drain?
The washer should drain at the beginning of the test cycle. If it does not, visit our Support Center to request service.
How long does it take for a washer to cool down?
Allow approximately one hour for the water to cool before performing this procedure to avoid possible injury. If playback doesn't begin shortly, try restarting your device.
What happens if your washer isn't level?
If the washer isn't level it may not drain correctly. Make sure your washer is level.
Why do you need to clean a pump filter?
Clean the pump filter periodically to improve cleaning performance and help prevent odors. A clogged debris filter reduces the effectiveness of the draining system.
Does Samsung washing machine drain water?
Samsung washing machine does not drain. If you receive a no drain or overflow error, water does not drain, or if it overflows from the washer, follow the instructions in this guide to get your washer draining water again.
Where is the drain pump filter on a washer?
Open the drain pump filter cover at the bottom of the washer front panel.
How to remove a spring clamp from a washer?
Use the outer spring pliers to expand the spring clamp and remove it from the door boot. Release the rubber door boot from the lip around the opening to the washer tub on the front panel. Remove the 7 screws from the top of the front panel. Close the washer door.
How to seat a washer panel?
Push the panel down and forward to seat it on the washer frame.
How to catch a leak in a pump?
Put a towel under the pump body hoses to catch leaks.
How to unplug wire harness?
Unplug the wire harness connections for the control panel by pressing on the release tabs and sliding the connectors apart.
