- Try removing the stopper by hand. Some stoppers can be removed by hand without the need for any special tools or techniques. ...
- Remove items from under the sink. If you can’t pull the stopper out, you will need to go underneath the sink to release it – so the next ...
- Locate the horizontal plunger rod. Take your flashlight and put your head under the sink. ...
- Locate the clip attaching the rod and the strap. ...
- Unscrew the pivot nut. The other end of the rod you just detached from the strap should be attached to a pivot nut, and now you need to ...
- Remove the stopper. The stopper should now be free so you can just pull it out from the sink by hand. ...
- Remove hair with the hair remover. Before replacing the stopper, you should take the opportunity to pull any hair and gunk out of the hole.
- Consider washing it down with a drain-cleaning product. Before putting the plug back in, this is a good chance to give the drainpipe a thorough clean, particularly if ...
- Put everything back into place. Once you have cleaned everything up and unblocked the drain, it is time to put everything back the way it was, so simply ...
How to replace a bathroom pedestal sink?
Install the Mounting Brace
- Use a stud finder to locate the wall studs. ...
- Mark the height of the sink on the wall.
- Cut a hole in the wall at the sink height that spans from stud to stud.
- If you have an already tiled wall, you will need to either remove the tile or cut through it using an angle grinder.
- Cut a piece of 2 × 8 board to fit snugly between the studs.
How to replace the drain in a pedestal sink?
- To remove the pedestal sink to gain access behind it, remove the caulk under the sink bowl and the caulk near the bottom stand at the floor.
- After this, carefully lift up the sink and slide the pedestal out. ...
- Lift the sink about a 1/2 inch off pedestal while having someone else slide the pedestal out and then put the sink back onto the wall bracket.
How to remove the pop up on a pedestal sink?
Steps for Replacing a Pedestal Sink Pop-Up Assembly:
- Close the sink's hot- and cold-water shut-off valves.
- Disconnect the hot- and cold-water supply lines.
- Remove the toggle bolts securing the sink bowl to the wall.
- Use wrench to disconnect drainpipe behind pedestal.
- Pull the pedestal away from wall and lift off sink.
- Remove and save the trap from the sink.
- Loosen the nut holding the tailpiece to the sink.
How to remove sink stopper in three steps?
Step-by-Step Guide to Removing a Bathroom Sink Stopper
- Removing the Stopper by Hand. You can remove some bathroom sink stoppers by hand. ...
- Remove Items from Under the Sink. If you can’t remove the bathroom sink stopper by hand, you’ll have to approach it from underneath the sink.
- Locate the Plunger Rod. ...
- Locate the Clip Attaching the Plunger Rod and Strap. ...
- Remove the Pivot Nut. ...
- Remove the Stopper. ...
How do you loosen a nut under a pedestal sink?
2:099:49How to Replace Pedestal Sink Parts | Ask This Old House - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo i'm just going to score it with a razor knife. All right so now i'm just going to go after thoseMoreSo i'm just going to score it with a razor knife. All right so now i'm just going to go after those bolts with a box wrench that one's pretty loose. All right so both of those nuts are off.
How do I remove the stopper assembly?
1:244:21Replace a Bathroom Sink Stopper - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf it's metal you may need a wrench to loosen it. If it's plastic it's likely you'll just be able toMoreIf it's metal you may need a wrench to loosen it. If it's plastic it's likely you'll just be able to turn the nut by hand remove the pivot rod from the drain. Be careful when you remove the pivot rod.
How do you take apart a pedestal sink?
1:302:45Pedestal Sink Installation - Removing the Old Sink - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou'll want to go ahead and take your sharp razor knife and cut an incision around the floor. OnceMoreYou'll want to go ahead and take your sharp razor knife and cut an incision around the floor. Once you cut that incision on the caulk around the floor.
How do you get a push plug out?
0:284:10How Do I Fix a Stuck Push Down Sink Plug | 4 Ways To Free Pop Up PlugYouTubeStart of suggested clipEnd of suggested clipSo in my previous. Video i said put on a rubber glove. And just push. Down. As hard as you can withMoreSo in my previous. Video i said put on a rubber glove. And just push. Down. As hard as you can with the rubber glove. So you got grip. Turn counterclockwise. And it pops up see.
How do you remove a push drain stopper?
How to Remove a Push-Pull Drain Stopper:Set the drain to its open position.Lift up on the drain stopper's knob and turn it counterclockwise.After enough turns, the drain stopper should be unscrewed and come free from the drain opening.
How do you access pedestal sink pipes?
To remove the pedestal sink to gain access behind it, remove the caulk under the sink bowl and the caulk near the bottom stand at the floor. After this, carefully lift up the sink and slide the pedestal out.
How does a pedestal trap work?
Telescopic pedestal traps are designed to enable the waste pipe from a basin to be concealed behind the pedestal that supports the basin. They also give some flexibility with the connection to the waste pipe, as the telescopic neck of the trap slides up and down within the trap body to vary the height of the outlet.
How do you remove a bathtub drain assembly?
0:453:46How to remove and replace a bath drain - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn my drain assembly and that will remove it from the waste tissue which is below the tub. And. IMoreTurn my drain assembly and that will remove it from the waste tissue which is below the tub. And. I can put a screwdriver in the hole in the drain. Tool as well. Once. I get it loose.
How do you remove a tub stopper without screws?
1:133:16Remove Pop-up Stopper-No Set Screw - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're gonna pull it up just enough to where you can grab hold of this larger. Piece then you'reMoreYou're gonna pull it up just enough to where you can grab hold of this larger. Piece then you're gonna unscrew this larger piece you felt it give there. And you unscrew this larger.
How to remove a stopper on a pedestal?
To remove the stopper, you have to disconnect the lever arm from the lift rod and unscrew it from the drain tailpiece hidden inside the pedestal. You often must accomplish the latter procedure without looking because there isn't room for your head behind the pedestal.
What is the difference between a pedestal sink and a cabinet sink?
The anatomy of a pedestal sink is identical to one installed in a cabinet, with one important difference: Instead of being hidden by the cabinet, the drain pipes are inside the pedestal, and you usually can see only the horizontal outlet of the P-trap and the lever arm for the stopper. To remove the stopper, you have ...
Where is the pop up stopper lever?
Locate the pop-up stopper lever under the sink. It extends outward from inside the pedestal and is connected to the lift rod by a U-shaped spring.
How to fix a P-trap nut that doesn't move?
Turn the nut with your fingers, if possible. If it doesn't move, turn it with a pair of adjustable pliers. If you can't lock the pliers onto the nut without looking, balance a hand mirror against the wall on the horizontal P-trap pipe so you can see what you're doing.
What to wear when using bathroom sink stoppers?
Wear rubber gloves, as bathroom sink stoppers tend to be quite dirty. You don’t want to touch all that dirt with your bare hands.
How many types of bathroom sink stoppers are there?
Overall, there are six bathroom sink stopper types. They are:
Why won't my bathroom sink stopper stay up?
A common issue is that your bathroom sink stopper won’t stay up, clogging your sink again. Again, this can happen because of hair or debris on the stopper. Any form of buildup can make the stopper stop working. If this isn’t the case, then the culprit is probably the clevis.
What is a pop up stopper?
In a way, pop-up bathroom sink stoppers look similar to a bathroom sink pop-up. They have a lever on top of the overflow plate, as well as the spring. This operates the stopper and opens or closes it. Despite being high in quality, they are a bit complicated to remove and clean while they tend to collect hair.
Where is the lever on a bathroom sink?
This type of bathroom sink stopper has a lever located at the front part of the tub. It doesn’t have any visible pop-up stopper, just a strainer. Trip lever bathroom sink stopper has a plunger in the overflow pipe. It moves up and down to open and close the drain pipe.
What is the other side of a detached rod?
The other side of the detached rod should be connected to a pivot nut that you have to unscrew. This is the moment when you take the bucket and place it under the sink. In case the water comes running down when the nut is unscrewed, this will save you a lot of cleaning work.
Can you pull out a bathroom sink stopper?
Everything you did so far should be enough to release the bathroom sink stopper. You should be able to pull it out without any issues. Keep in mind that the plug is probably dirty and covered in disgusting gunk. This is an excellent opportunity to clean it up and fix it, in case it is broken.
Try Removing Sink Stopper by Hand
Some sink stoppers can be removed by hand, without the need of special tools or equipment. Grab the stopper, lift and twist. If the topper does not come out, continue to Step 2.
Remove Items Under Sink
Before working under your sink, remove the sink cabinets of its contents, so you can more easily move around underneath. If there's not enough light in your bathroom, use a flashlight.
Find Horizontal Plunger Rod
The first step to removing your sink stopper requires that you find then remove the horizontal rod. This rod connects the stopper to the strap, which is a piece of metal with holes. If it's too dark to see, use a flashlight to help with the search.
Find Metal Clip
Once the rod has been located in the strap, you'll see the rod is held in place with a metal clip. Remove the clip so that the horizontal rod and strap are no longer connected. Be sure to remember which hole the rod was in. Or better yet, take a photo!
Remove Pivot Nut
At the other end of the horizontal rod, there is a piece called the pivot nut that is still attached to the sink drain. Before you unscrew and remove the pivot nut entirely, get a bucket or a bowl and place it directly underneath to catch any water that may come out.
Remove Sink Stopper
Now that the horizontal rod and pivot nut have been removed, you should be able to remove the sink stopper by hand. Simply pull it out. The stopper may be covered in build up and gunk, so while it's out, definitely clean it thoroughly.
Clean Sink Stopper
To clean a sink stopper, you have many options. There are also drain cleaning tools you can use, as well as drain openers.